TOYOTA CAMRY 2019 (in English) User Guide

Page 11 of 52

9
Instrument panel light control
NOTE: Regularly scheduled maintenance, including oil changes, will help
extend the life of your vehicle and maintain performance. Please refer to the
“Warranty Maintenance Guide.”
Automatic transmission
* The “POWER” switch/ignition switch must be “ON” and the br\
ake pedal depressed to shift from Park.
Shift the shift lever to “S” position from “D” position.
+ : Upshift (push and release)
- : Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking do\
wnhill. For
best fuel economy during normal driving conditions, always drive with th\
e shift lever
in the “D” position.
N
Park*
Reverse
Neutral
Drive
“S” mode
+ (“S” mode)
- (“S” mode)
“S” (SEQUENTIAL) MODE
Auto lock/unlock
Automatic door locks can be programmed to operate in different modes, or\
turned
OFF.
Shift position linked door locking/unlocking function
-Doors lock when shifting from Park.
-Doors unlock when shifting into Park.
Speed linked door locking function
-Doors lock when the vehicle speed goes above approximately 12 mph (20 k\
m/h).
Driver’s door linked door unlocking function
-Doors unlock when the engine switch is set to OFF and driver’s door i\
s opened.
Refer to the Owner’s Manual for more details.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
FEATURES & OPERATIONS
142098_Camry_QRG_GUTS.r1.indd 97/20/18 4:36 PM

Page 12 of 52

10
Hold wheel, push lever down, set angle and length, and return lever.
NOTE: Do not attempt to adjust while the vehicle is in motion.
Tilt and telescopic steering wheel
Smart KeyWithout Smart Key
Steering lock release
Push Turn Turn Turn
Parking brake (if equipped)
When starting the engine, the engine
switch may seem stuck in the “LOCK”
position. To free it, turn the key while
turning the steering wheel slightly left
and right.A message informing the driver that the
steering wheel is locked will be
displayed on the multi-information
display.
Check that the shift lever is set in P.
Press the engine switch while turning
the steering wheel left and right.
Lock release leverAngle
Length
FEATURES & OPERATIONS

Page 13 of 52

11
Electric parking brake (if equipped)
Automatic (shift lever operation)
ManualTo turn automatic mode ON, while vehicle is stopped, pull and hold switch until
“EPB Shift Interlock Function Activated” displays in Multi-Information Display (MID).
While depressing brake, shifting into P position will automatically set the brake
and turn the parking brake indicator and parking brake light on. To release brake,
depress brake and shift out of P. The indicator light turns off.
To turn automatic mode OFF, push and hold parking brake switch until “EPB Shift
Interlock Function Deactivated” displays on the MID.
While vehicle is stopped and brake pedal is depressed, pull to set parking brake
and turn the parking brake indicator and parking brake light on. To release, press
the brake pedal and push switch. The indicator light turns off.
Refer to the Owner’s Manual for limitations and more details.
Parking brake light
Parking brake light
Standby indicatorOperated indicator
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Driver sideAutomatic modeManual mode (Brake HOLD switch)

Page 14 of 52

12
Vehicle Stability Control (VSC)/TRAC OFF Switch
FEATURES & OPERATIONS
Driving mode select switches (if equipped)
The VSC OFF switch can be used to help free a stuck vehicle in surroundings like
mud, dirt or snow. While the vehicle is stopped, press switch to disable the TRAC
system.
To disable both VSC and TRAC systems, press and hold the switch for at least 3
seconds.
Refer to the Owner’s Manual for limitations and more details.
Normal -
Suitable for normal driving.
SPORT mode -
Use when a higher level
of response is desired,
such as when driving in
mountainous regions.
ECO MODE -
Helps achieve lower fuel
consumption during trips
that involve frequent
accelerating and braking.
Refer to the Owner’s Manual for more details.

Page 15 of 52

13
Seat adjustments - Front
Seats - Head restraints
Vehicle Stability Control (VSC)/TRAC OFF Switch
Seat folding - Rear (if equipped)
(1)(2)
Tip: To fold rear seats, the release button is located in the trunk.
Driving mode select switches (if equipped)
The VSC OFF switch can be used to help free a stuck vehicle in surroundi\
ngs like
mud, dirt or snow. While the vehicle is stopped, press switch to disable\
the TRAC
system.
To disable both VSC and TRAC systems, press and hold the switch for at l\
east 3
seconds.
Refer to the Owner’s Manual for limitations and more details.
Refer to the Owner’s Manual for more details.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Seat position (forward/backward)
Seat cushion angle Height crank (driver side only)Seatback angle
Lumbar support
(if equipped,
driver side only)
Height crank (driver side only)
Seatback angle
Seat position (forward/backward)
Lock release button
MANUAL SEAT (IF EQUIPPED)
POWER SEAT (IF EQUIPPED)
Pull
Fold down
Refer to the Owner’s Manual for more details.
142098_Camry_QRG_GUTS.r1.indd 137/20/18 4:37 PM

Page 16 of 52

14
HEADLIGHTS
TURN SIGNALS
Lights & turn signals
FEATURES & OPERATIONS
-Daytime Running Light system (DRL) Automatically turns on under certain conditions
to make vehicle more visible to other drivers. Not for use at night.
-Automatic light cut off system Automatically turns lights off after 30 second delay,
or lock switch on remote may be pushed after locking.
-Automatic High Beam (AHB) system Automatically switches between high and
low beams as appropriate to provide the most light possible and enhance forward
visibility.
Refer to Toyota Safety Sense
™ P (TSS-P) in this guide or the Owner’s Manual for
more details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to Owner’s Manual for details.
1 The right hand signals will flash three times.2 The left hand signals will flash three times.
Parking lightsHeadlights
DRL OFFAUTO
High beam
Auto High Beam*or
Right turn
Lane change1
Lane change2
Left turn
High beam flasher
Low beam

Page 17 of 52

15
* Intermittent windshield wiper frequency adjustment Rotate to increase/decrease
wipe frequency.
Refer to the Owner’s Manual for more details.
Windshield wipers & washers
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Adjust frequency*
Pull to wash and wipeMist
Interval wipe
Slow
Fast
Seat heaters (if equipped)
Driver seatFront passenger seat

Page 18 of 52

16
FEATURES & OPERATIONS
Air conditioning/heating
AUTOMATIC (IF EQUIPPED)
With “SYNC” button
Temperature selector
(driver’s side)Temperature selector
Automatic climate control ON -
Adjusting the temperature setting will
cause the airflow vents, air intake and
fan to adjust automatically. Automatic climate control ON -
Adjusting the temperature setting will
cause the airflow vents, air intake and
fan to adjust automatically.
“SYNC” button - Indicator ON: Synchronized
temperature settings for driver and pas-
sengers. Indicator OFF: Separate temperature
settings for driver and passengers.
Airflow mode display
Airflow mode display
Airflow vent mode - In “
” or “” mode,
use outside air (“” indicator OFF) to
reduce window fogging. Airflow vent mode - In “
” or “” mode,
use outside air (“” indicator OFF) to
reduce window fogging.
Temperature selector
(passenger’s side)
Recirculate cabin air
(outside air when OFF)Recirculate cabin air
(outside air when OFF)
Outside rearview mirror*/
rear window defogger
* If equipped.
* If equipped.
Rear window defogger
Outside rearview mirror*/
rear window defogger
Climate control OFF
Climate control OFF
Air ConditioningON/OFF
Rear window defogger
Air Conditioning
ON/OFF
Fan speed
Fan speed
Windshield airflow/defoggerWindshield airflow/defogger
Without “SYNC” button
Type A

Page 19 of 52

17
AUTOMATIC (IF EQUIPPED) (CONTINUED)
With “SYNC” button (continued)
Fan speed
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Temperature selector
(driver’s side)
Automatic climate control ON -
Adjusting the temperature setting will
cause the airflow vents, air intake and
fan to adjust automatically.
“SYNC” button - Indicator ON: Synchronized
temperature settings for driver and pas-
sengers. Indicator OFF: Separate temperature
settings for driver and passengers.
Airflow mode display
Airflow vent mode - In “
” or “” mode,
use outside air (“” indicator OFF) to
reduce window fogging.
Airflow vent mode - In “
” or “”
mode, use outside air (“” indicator
OFF) to reduce window fogging.Temperature selector
(passenger’s side)
Temperature selector
Recirculate cabin air
(outside air when OFF)
Outside rearview mirror*/
rear window defogger
Outside rearview mirror*/
rear window defogger
Air conditioning ON/OFF
Rear window defogger
* If equipped.
Climate control OFF
Air Conditioning ON/OFF
Fan speed Windshield airflow/defogger
Windshield airflow/defogger
MANUAL (IF EQUIPPED)
Recirculate cabin air
(outside air when OFF)
Type B

Page 20 of 52

18
FEATURES & OPERATIONS
Intelligent Clearance Sonar with Rear Cross
Traffic Braking (ICS w/RCTB)
(if equipped)
When parking, this available system scans for stationary objects, like walls or
lampposts. Should the system anticipate a collision, it will emit an audible and
visible alert, reduce engine or motor output, and automatically apply the brakes
if needed. If your vehicle is equipped with ICS, the RCTA system will also have a
braking function that may apply the vehicle’s brakes if the system detects crossing
vehicles while the Camry is backing up.
System ON/OFF on the
Multi-Information Display.
CHANGE SETTINGS
The Blind Spot Monitor is a system that has two functions:
• The Blind Spot Monitor function (assists the driver in decision-making when
changing lanes)
• The Rear Cross Traffic Alert function (assists the driver when backing up)
The system is designed to use radar sensors to detect vehicles traveling in the
Camry’s blind spot and advises the driver of the vehicles’ presence via the outside
rear view mirror indicators.
Refer to the Owner‘s Manual for limitations and more details on this system before
attempting to use it.
Blind Spot Monitor with Rear Cross
Traffic Alert (BSM w/RCTA)
(if equipped)
Indicators
Indicators
RCTA function
displayRear Cross Traffic Alert buzzer Outside rear view mirror indicators

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 ... 60 next >