light TOYOTA PRIUS 2008 2.G Quick Reference Guide
Page 21 of 32
19
OVERVIEW BASIC HYBRID VEHICLE OPERATIONFEATURES/OPERATIONS SAFETY AND EMERGENCY FEATURES
Windows
Window operation
Automatic operation (driver side only) Push the
switch completely down or pull it completely up
and release to fully open or close. To stop window
midway, lightly push the switch in the opposite
direction.
Window lock switch Deactivates all passenger
windows. Driver’s window remains operable.
NOTE:If 12V battery is disconnected, the window
will need to be reinitialized. Refer to the Owner’s
Manual for more details.
Window lock
switch
Up
Down
Driver side
Down
Up
Tilt steering wheel
Hold wheel, push lever down, set angle and return
lever.
Note: Do not attempt to adjust while the vehicle
is in motion.
Angle
Lock release
lever
Page 28 of 32
26
SAFETY AND
EMERGENCY FEATURES
If belt is fully extended, then retracted even
slightly, it cannot be re-extended beyond that point,
unless fully retracted again. This feature is used to
help hold child restraint systems securely.
To find more information about seat belts, and how
to install a child restraint system, refer to the
Owner’s Manual.
Keep as low on
hips as possible
Take up
slack
Too high
Seat belts
Moving the lever to “LOCK” will allow the door to
be opened only from the outside.
Doors-Child safety locks
Door locks
Seat belts-Shoulder belt anchor
Unlock
Rear door
Push up, or
squeeze lock
release to lower Lock
Page 29 of 32
27
OVERVIEW BASIC HYBRID VEHICLE OPERATIONFEATURES/OPERATIONS SAFETY AND EMERGENCY FEATURES
27
Emergency flashers
Note: The air vent on the right side of the rear
seatback is designed to assist in cooling the
Hybrid vehicle battery. DO NOT BLOCK OR
COVER THIS VENT, as it may cause
overheating, resulting in reduced vehicle
performance.
Rear air vent
Push
Tire Pressure Warning System
If tire pressure becomes critically low on any of the
tires (excluding spare), indicator illuminates. Pushing
“ SET” button should not turn off the light.
Correctly adjusting tire inflation will turn off the
light after a few minutes. After replacing/rotating
tire or wheels, the system must be initialized.
Refer to the Owner’s Manualfor details on system
reset initialization.