ESP TOYOTA PRIUS V 2012 Accessories, Audio & Navigation (in English)

Page 11 T OYOTA — RS3200 PLUS Security System
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond en\
try point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to ad\
just the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
1.

ARM the system.

Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)

2.

W
ait until the STATUS MONITOR’S LED starts flashing. The
LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds.



3.

With the tip of a key
, tap the center of the driver’s door
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Toyota dealer for
more information.
4.

DISARM the system to stop the W
ARN AWAY ALARM. Press
the unlock button