tires TOYOTA RAV4 1999 Owner's Manual

'99 Rav4.U
202
Replacing wheels
WHEN TO REPLACE YOUR WHEELS
If you have wheel damage such as
bending, cracks or heavy corrosion, the
wheel should be replaced.
If you fail to replace damaged wheels, the
tire may slip off the wheel or they may cause
loss of handling control.
WHEEL SELECTION
When replacing wheels, care should be
taken to ensure that the wheels are re-
placed by ones with the same load ca-
pacity, diameter, rim width, and offset.
Correct replacement wheels are available at
your Toyota dealer.
A wheel of a different brand, size and type
may adversely affect handling, wheel and
bearing life, brake cooling, speedometer/
odometer calibration, stopping ab
ility, head-
light aim, bumper height, vehicle ground
clearance, and tire or snow chain clearance
to the body and chassis. Replacement with used wheels is not rec-
ommended as they may have been sub-
jected to rough treatment or high mileage
and could fail without warning. Also, bent
wheels which have been straightened may
have structural damage and therefore
should not be used. Never use an inner
tube in a leaking wheel which is designed
for a tubeless tire.
NOTICE
Do not use wheels of different
brands, sizes and types. This maydamage the drive system.
Aluminum wheel precautions
After driving your vehicle the first 1600
km (1000 miles), check that the wheel
nuts are tight.
If you have rotated, repaired, or
changed your tires, check that the
wheel nuts are still tight after driving
1600 km (1000 miles).
When using tire chains, be careful not
to damage the aluminum wheels.
Use only the Toyota wheel nuts and
wrench designed for your aluminum
wheels.
When balancing your wheels, use only
Toyota balance weights or equivalent
and a plastic or rubber hammer.
As with any wheel, periodically check
your aluminum wheels for damage. If
damaged, replace immediately.

'99 Rav4.U
216
Dimensions and weight
2- door hardtop4- door hardtopSoft- top
215/70R16 tires235/60R16 tires215/70R16 tires235/60R16 tires215/70R16 tires235/60R16 tires
Overall length mm (in.)3750 (147.6)3765 (148.2)4160 (163.8)4175 (164.4)3750 (147.6)3765 (148.2)
Overall width mm (in.)1695 (66.7)1760 (69.3)1695 (66.7)1760 (69.3)1695 (66.7)1760 (69.3)
Overall height mm (in.)1655 (65.2)
*
1
1645 (64.8) *
21635 (64.4)1660 (65.4) *
1
1650 (65.0) *
21640 (64.6)1660 (65.4) *
1
1650 (65.0) *
21640 (64.6)
Wheelbase mm (in.)2200 (86.6)2200 (86.6)2410 (94.9)2410 (94.9)2200 (86.6)2200 (86.6)
Front tread mm (in.)1460 (57.5)1480 (58.3)1460 (57.5)1480 (58.3)1460 (57.5)1480 (58.3)
Rear tread mm (in.)1465 (57.7) *
3
1470 (57.9) *
41490 (58.7)1465 (57.7) *
3
1470 (57.9) *
41490 (58.7)1465 (57.7) *
3
1470 (57.9) *
41490 (58.7)
Vehicle capacity weight
(occupants + luggage) kg(lb)273 (601) *
3
333 (734) *
4273 (601)341 (751) *
3
351 (773) *
4341 (751)273 (601) *
3
333 (734) *
4273 (601)
*1
:Unladen vehicle (four- wheel drive models)
* 2
:Unladen vehicle (two- wheel drive models)
* 3
:Four- wheel drive models
* 4
:Two- wheel drive models

'99 Rav4.U
220
Tires
Tire size and pressure:
Model
Tire size
Tire pressure
kPa (kgf/cm 2
or bar, psi)
Wheel sizeModelTire size
FrontRear
Wheel size
2- door hardtopand soft top
215/70R 16 99S180 (1.8, 26)180 (1.8, 26)16 6J
16 6.5JJ *
and soft- top235/60R 16 100H170 (1.7, 25)170 (1.7, 25)16
6.5JJ
4- door hardtop215/70R 16 99S190 (1.9, 28)180 (1.8, 26)16 6J
16 6.5JJ *
4 door hardto
235/60R 16 100H170 (1.7, 25)170 (1.7, 25)16
6.5JJ
Wheel nut torque, N ´m (kgf ´m, ft ´lbf):
103 (10.5, 76)
* : Vehicles with aluminum wheel

'99 Rav4.U
226
Uniform tire quality grading
This information has been prepared in ac-
cordance with regulations issued by the
National Highway Traffic Safety Adminis-
tration of the U.S. Department of Trans-
portation. It provides the purchasers and/
or prospective purchasers of Toyota
vehicles with information on uniform tire
quality grading.
Your Toyota dealer will help answer any
questions you may have as you read this
information.
DOT quality gradesÐAll passenger ve-
hicle tires must conform to Federal
Safety Requirements in addition to
these grades. These quality grades are
molded on the sidewall.
TreadwearÐ
The treadwear grade is a
comparative rating based on the wear rate
of the tire when tested under controlled
conditions on a specified government test
course. For example, a tire graded 150
would wear one and a half (1- 1/2) times
as well on the government course as a
tire graded 100. The relative performance
of tires depends upon the actual condi-
tions of their use, however, and may de-
part significantly from the norm due to
variations in driving habits, service prac-
tices and differences in road characteris-
tics and climate. Traction AA, A, B, CÐ
The traction
grades, from highest to lowest, are AA, A,
B, and C, and they represent the tire's
ability to stop on wet pavement as mea-
sured under controlled conditions on spe-
cified government test surfaces of asphalt
and concrete. A tire marked C may have
poor traction performance.
Warning: The traction grade assigned to
this tire is based on braking (straight
ahead) traction tests and does not include
cornering (turning) traction.
Temperature A, B, CÐ The temperature
grades are A (the highest), B, and C,
representing the tire's resistance to the
generation of heat and its ab ility to dissi-
pate heat when tested under controlled
conditions on a specified indoor laboratory
test wheel. Sustained high temperature
can cause the material of the tire to de-
generate and reduce tire life, and exces-
sive temperature can lead to sudden tire
failure. The grade C corresponds to a lev-
el of performance which all passenger car
tires must meet under the Federal Motor
Vehicle Safety Standard No.109. Grades B
and A represent higher levels of perfor-
mance on the laboratory test wheel than
the minimum required by law. Warning: The temperature grades for this
tire are established for a tire that is prop-
erly inflated and not overloaded. Exces-
sive speed, underinflation, or excessive
loading, either separately or in combina-
tion, can cause heat buildup and possible
tire failure.