high beam TOYOTA RAV4 2008 XA30 / 3.G Owners Manual

’08 Rav4_U (L/O 0802)
10
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
∗1: For details, see “Service reminder indicators and warning
buzzers” on page 129 in Section 1 −6.
∗
2: If this light flashes, see “Cruise control” on page 168 in
Section 1 −7.Cruise control indicator light
∗
2
Four −wheel drive lock indicator light
Headlight high beam indicator light
Turn signal indicator lights
Automatic transmission indicator lights
(4 −speed)
Engine oil replacement reminder light
∗ 1
Slip indicator light
Front fog light indicator light Headlight indicator light
Tail light indicator light
“AIR BAG ON” and “AIR BAG OFF” indicator
lights
Downhill assist control system indicator light “AUTO LSD” indicator light
Low windshield washer fluid level warning
light∗1
Electric power steering system warning light∗1
Automatic transmission indicator lights
(5 −speed)

’08 Rav4_U (L/O 0802)
11 5
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
HighLow beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight high beam indicator light
(blue light) on the instrument panel will
tell you that the high beams are on.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
with the knob turned to “OFF”.TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
The engine switch must be in the “ON”
position.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it. If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See “Replacing light
bulbs” on page 422 in Section 7
−3.

’08 Rav4_U (L/O 0802)
234
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
For vehicles sold in the U.S.A. (and
Canada)—
Part 15 of the FCC Rules
FCC Warning:
Any unauthorized changes or modifi-
cations to this equipment will void
the user’s authority to operate this
device.
Laser products
Do not take this unit apart or at-
tempt to make any changes your-
self. This is an intricate unit that
uses a laser pickup to retrieve in-
formation from the surface of com-
pact discs. The laser is carefully
shielded so that its rays remain in-
side the cabinet. Therefore, never
try to disassemble the player or al-
ter any of its parts since you may
be exposed to laser rays and dan-
gerous voltages.
This product utilizes a laser. Use of
controls or adjustments or perfor-
mance of procedures other than
those specified herein may result in
hazardous radiation exposure.
CARING FOR YOUR COMPACT DISC
PLAYER, DVD PLAYER AND DISCS
Extremely high temperatures can keep
your compact disc player and DVD
player from working. On hot days, use
the air conditioning to cool the vehicle
interior before you use the players.
Bumpy roads or other vibrations may
make your compact disc player and
DVD player skip.
If moisture gets into your compact disc
player and DVD player, the players
may not play even though they appear
to be working. Remove the disc from
the player and wait until it dries.
CAUTION
Compact disc players and DVD play-
ers use an invisible laser beam which
could cause hazardous radiation ex-
posure if directed outside the unit. Be
sure to operate the players correctly.
Compact disc player
Audio CDs
Use only compact discs marked as
shown above. The following products
may not be playable on your compact
disc player.
SACD
dts −CD
Copy −protected CD
CD− ROM

’08 Rav4_U (L/O 0802)
424
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
Low beam
(outside)High beam (inside)
1. Open the hood. Turn the bulb base
counterclockwise to the front of the
vehicle as shown.
The above illustration shows the left −hand
headlight.2. Unplug the connector while depress- ing the lock release.
If the connector is tight, wiggle it.3. Plug in a new bulb into the connec- tor and install it into the mounting
hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
—Headlights

’08 Rav4_U (L/O 0802)
434
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
ENGINE COMPARTMENT (No.1)1. SPARE 30 A: Spare fuse
2. SPARE 20 A: Spare fuse
3. SPARE 10 A: Spare fuse
4. ECUB2 7.5 A: Air conditioning sys-
tem, power windows
5. RSE 7.5 A: Rear seat entertainment
system
6. STR LOCK 20 A: No circuit
7. RAD NO.1 20 A: Audio system
8. ECUB 10 A: Wireless remote control
system, electric power steering system,
main body ECU, power door lock, front
passenger occupant classification sys-
tem, clock, audio system, meters and
gauges
9. DOME 10 A: Engine switch light, interi-
or light, vanity lights, luggage compart-
ment light, front personal lights, foot
lights
10. HEAD LH 10 A: Left−hand headlight
(high beam)
11. HEAD RH 10 A: Right−hand headlight
(high beam)
12. HEAD LL 10 A: Left−hand headlight
(low beam) 13. HEAD RL 10 A:
Right−hand headlight
(low beam)
14. AC INV 15 A: AC inverter
15. TOWING 30 A: No circuit
16. STV HTR 25 A: No circuit
17. DEICER 20 A: Windshield wiper de−
icer
18. HTR 50 A: Air conditioning system
19. PTC2 50 A: No circuit
20. PTC1 50 A: No circuit
21. HEAD MAIN 50 A: “HEAD LL”, “HEAD
RL”, “HEAD LH”, “HEAD RH” fuses
22. RDI 30 A (without towing package) or FAN2 50 A (with towing package):
Electric cooling fan
23. CDS 30 A (without towing package) or FAN1 50 A (with towing package):
Electric cooling fan
24. HLP CLN 30 A: No circuit
Fuses