change language TOYOTA SIENNA 2010 XL30 / 3.G Navigation Manual
Page 23 of 276
BASIC FUNCTIONS
23
When the engine switch is in the “ACC” or
“ON” position, the initial screen will be
displayed and the system will begin oper-
ating.
CAUTION
When the vehicle is  stopped with the
engine running, always apply the
parking brake for safety.
After a few seconds, the “CAUTION”
screen will be displayed.
After about 5 seconds, the “CAUTION”
screen automatically switches to the map
screen.  When the “MAP/VOICE”  button
is also pushed, the map screen is dis-
played.
While  the “CAUTION” screen is displayed,
the  “DEST”  or “MENU”  button cannot be
operated.  And if the “Language” , “Cal-
endar”  or “Maintenance”  buttons on the
“Information” screen are touched, the
screen will change back to “CAUTION”
screen  and then change to the map screen
in about 5 seconds later or if the  “MAP/
VOICE”  button is pushed.
Initial screen 
Page 92 of 276
ADVANCED FUNCTIONS
92
INFORMATION
During route guidance, the voice
guidance continues even if the navi-
gation screen is changed to other
screens.
“Adaptive Volume Control”: By turning
“Adaptive V olume Control” on, the volume
is turned up automatically when the ve-
hicle speed exceeds 50 mph (80 km/h).
To turn the “Adaptive Volume Control”
system  on, touch the button.  The indicator
will be highlighted. The system can memorize the following
settings for up 
to three users.
Map direction
Map scale
Map configuration
Guidance mode
Setup
Volume
Language
Route trace
Travel time/arrival time
Right screen of dual map
Route preference
Maintenance notification
1. Push the “MENU” button.
2. Touch “Select User”.
User selection 
Page 109 of 276
ADVANCED FUNCTIONS
109
Distance unit
Distance unit can be changed.
1. Push the “MENU” button.
2. Touch “Setup” on the “Menu”
screen.
3. Touch “km” or “miles” of “Dis-
tance” to choose the distance unit.
The selected button is highlighted.
4. Touch “OK”.
INFORMATION
This function is available only in En-
glish or Spanish. To  switch language,
see “Select language” on page 185.
Estimated travel time
The speed that is used for the calculation
of the estimated travel time and the esti-
mated arrival time can be set.
1. Push the “MENU” button.
2. Touch “Setup” on the “Menu”
screen.
3. Touch “Set Speed” of the “Esti-
mated Travel Time”.
4. Touch  or  to set the average
vehicle  speeds for “Residential”, “Main
street”, and “Freeway”.
To set the default speeds, touch  “De-
fault” .
5. After  setting of the desired speeds is
completed, touch “OK”.