TOYOTA TACOMA 1998 Owners Manual
Page 221 of 246
'98 Tacoma (U)221
ÐHeadlights
1. Open the hood. Unplug the connec-
tor. Remove the rubber cover.
If the connector is tight, wiggle it.2. Release the bulb retaining spring and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install a bulb, align the tabs of the
bulb with the cutouts of the mounting
hole.3. Install the rubber cover with the ºTOPº mark upward and snuggle on
the boss. Then insert the connector.
Make sure the rubber cover fits snugly on
the connector and the headlight body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
Page 222 of 246
'98 Tacoma (U)
222
Use a Phillips- head screwdriver.Use a Phillips-head screwdriver.
ÐParking lights ÐFront turn signal lights
(two- wheel drive models
except Pre R
unner)
Page 223 of 246
'98 Tacoma (U)223
Use a Phillips-head screwdriver.
a: Rear turn signal light c: Back-up light
b: Stop and tail light ÐLicense plate lights (type A)
ÐFront turn signal lights
(four- wheel drive models
and Pre Runner)
ÐRear turn signal, stop and
tail, and back-up lights
Page 224 of 246
'98 Tacoma (U)
224
ÐLicense plate lights (type B)
Use a Phillips-head screwdriver.
ÐHigh mounted stoplight
Use a Phillips-head screwdriver.
Page 225 of 246
'98 Tacoma (U)225