lights TOYOTA YARIS 2012 User Guide

62
1-1. Hybrid system (hybrid vehicle)
YARIS_F (including HV)_WE_52C79E
Hybrid vehicle driving tips
For economical and ecological driving, pay attention to the following
points:
Using Eco drive mode
P. 253
Use of Hybrid System Indicator
Eco-friendly driving is possible by keeping the indicator needle of
Hybrid System Indicator within Eco area. (P. 276)
When braking the vehicle
Make sure to operate the brakes gently and in good time. A greater
amount of electrical energy can be retained when slowing down.
Delays
Repeated acceleration and deceleration, as well as long waits at traffic
lights, will lead to bad fuel consumption. Check traffic reports before
leaving and avoid delays as much as possible. When encountering a
delay, gently release the brake pedal to allow the vehicle to move for-
ward slightly while avoiding overuse of the accelerator pedal. Doing so
can help control excessive gasoline consumption.
Highway driving
Control your speed and keep at a constant speed. Also, before stop-
ping at a toll booth or similar, allow plenty of time to release the acceler-
ator and gently apply the brakes. A greater amount of electrical energy
can be retained when slowing down.
Air conditioning
Use the air conditioning only when necessary. Doing so can help con-
trol excessive gasoline consumption.
In summer: In high temperatures, use the recirculated air mode. Doing
so will help to reduce the burden on the air conditioner and reduce fuel
consumption as well.
In winter: Because the gasoline engine will not automatically cut out
until the gasoline engine and the interior of the vehicle are warm, it will
consume fuel. Also, fuel consumption can be improved by avoiding
overuse of the heater such as setting the temperature too high.

75 1-3. Opening, closing and locking the doors
1
Before driving
YARIS_F (including HV)_WE_52C79E
Operation signals
The emergency flashers flash to indicate that the doors have been locked/
unlocked. (Locked: once; Unlocked: twice)
When the door cannot be locked by the lock sensor
Alarms and warning indicators
A combination of exterior and interior alarms as well as warning lights are
used to prevent theft of the vehicle and unforeseeable accidents resulting
from erroneous operation. Take appropriate measures for the warning light
that comes on. (P. 575)
The following table describes circumstances and correction procedures
when only alarms are sounded.
Use your thumb to push the lock sensor.
AlarmSituationCorrection procedure
Exterior alarm
sounds once for 5
secondsAn attempt was made to
lock the doors using the
smart entry & start system
while the electronic key
was still inside the vehicle.Retrieve the elec-
tronic key from the
vehicle and lock the
doors again.
An attempt was made to
lock the vehicle while a
door was open.Close all of the
doors and lock the
doors again.

141
1
1-4. Adjustable components (seats, mirrors, steering wheel)
Before driving
YARIS_F (including HV)_WE_52C79E
Anti-glare inside rear view mirror
Adjusting the height of rear view mirror (vehicles with an auto
anti-glare inside rear view mirror)
Adjust the height of the rear view
mirror by moving it up and down.
Anti-glare function
Vehicles with a manual anti-glare inside rear view mirror
Reflected light from the headlights of vehicles behind can be reduced
by operating the lever.
Normal position
Anti-glare position
The rear view mirror’s position can be adjusted to enable sufficient
confirmation of the rear view in accordance with the driver’s seating
posture.

142 1-4. Adjustable components (seats, mirrors, steering wheel)
YARIS_F (including HV)_WE_52C79EVehicles with an auto anti-glare inside rear view mirror
Responding to the level of brightness of the headlights of vehicles
behind, the reflected light is automatically reduced.
Changing automatic anti-glare
function mode
ON/OFF
When the automatic anti-glare
function is in ON mode, the indi-
cator illuminates.
Except hybrid vehicle
Vehicles without a smart entry &
start system:
The function will set to ON mode
each time the engine switch is
turned to the “ON” position.
Pressing the button turns the
function to OFF mode. (The indi-
cator also turns off.)
Vehicles with a smart entry & start
system:
The function will set to ON mode
each time the “ENGINE START
STOP” switch is turned to IGNI-
TION ON mode. Pressing the but-
ton turns the function to OFF
mode. (The indicator also turns
off.)
Hybrid vehicle
Vehicles without an electronic
key:
The function will set to ON mode
each time the engine switch is
turned to the “ON” position.
Pressing the button turns the
function to OFF mode. (The indi-
cator also turns off.)

2When driving
203
YARIS_F (including HV)_WE_52C79E
2-1. Driving procedures
Driving the vehicle ............ 204
Engine (ignition) switch
(except hybrid vehicle
[vehicles without a smart
entry & start system])...... 224
Engine (ignition) switch
(except hybrid vehicle
[vehicles with a smart
entry & start system])...... 228
Engine (ignition) switch
(hybrid vehicle [vehicles
without an electronic
key]) ................................ 238
Power (ignition) switch
(hybrid vehicle [vehicles
with an electronic key]) ... 243
EV drive mode
(hybrid vehicle) ............... 250
Hybrid transmission .......... 252
Multidrive .......................... 255
Multi-mode manual
transmission ................... 260
Manual transmission......... 265
Turn signal lever ............... 269
Parking brake ................... 271
Horn .................................. 272
2-2. Instrument cluster
Gauges and meters .......... 273
Indicators and warning
lights ............................... 278
Multi-information display ... 2862-3. Operating the lights and
wipers
Headlight switch................ 293
Fog light switch ................. 302
Windshield wiper and
washer ............................ 304
Rear window wiper and
washer ............................ 309
2-4. Using other driving systems
Cruise control.................... 311
Speed limiter ..................... 315
Stop & Start system .......... 318
Driving assist systems ...... 326
Hill-start assist control
(hybrid vehicle) ............... 332
Diesel particulate filter
system ............................ 334
2-5. Driving information
Cargo and luggage ........... 336
Winter driving tips ............. 338
Trailer towing
(hybrid vehicle) ............... 342
Trailer towing (except hybrid
vehicle [except for
South Africa]) .................. 343

270 2-1. Driving procedures
YARIS_F (including HV)_WE_52C79E
If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.

278
2-2. Instrument cluster
YARIS_F (including HV)_WE_52C79E
Indicators and warning lights
The indicators and warning lights on the instrument cluster and cen-
ter panel inform the driver of the status of the vehicle’s various sys-
tems.
For the purpose of explanation, the following illustration displays all
indicators and warning lights illuminated.
Except hybrid vehicle
Instrument cluster (vehicles without a tachometer type A):
Instrument cluster (vehicles without a tachometer type B):

282 2-2. Instrument cluster
YARIS_F (including HV)_WE_52C79E
*1: Except hybrid vehicle: These lights turn on when the engine switch
is turned to the “ON” position (vehicles without a smart entry & start
system) or the “ENGINE START STOP” switch is turned to IGNI-
TION ON mode (vehicles with a smart entry & start system) to indi-
cate that a system check is being performed. They will turn off after
the engine is started, or after a few seconds. There may be a mal-
function in a system if a light does not come on, or if the lights do
not turn off. Have the vehicle inspected by any authorized Toyota
dealer or repairer, or another duly qualified and equipped profes-
sional.
*1
(if equipped)
Stop & Start cancel indi-
cator (P. 319)
(hybrid
vehicle)
EV drive mode indicator
(P. 250)
*1,*2,4
(if equipped)
Slip indicator (P. 327)
*2
(hybrid
vehicle)
“ECO MODE” indicator
(P. 253)
*1
(if equipped)
“TRC OFF” indicator
(P. 328)
(hybrid
vehicle)
EV indicator (P. 50)
*1
(if equipped)
VSC OFF indicator
(P. 328)
(hybrid
vehicle)
Driving ready indicator
(P. 238, 243)
“PASSENGER AIR BAG” indicator
(P. 177)

283 2-2. Instrument cluster
2
When driving
YARIS_F (including HV)_WE_52C79E
*2: Hybrid vehicle: These lights turn on when the engine switch is
turned to the “ON” position (vehicles without an electronic key) or
the “POWER” switch is turned to ON mode (vehicles with an elec-
tronic key) to indicate that a system check is being performed. They
will turn off after the hybrid system on, or after a few seconds. There
may be a malfunction in a system if a light does not come on, or if
the lights do not turn off. Have the vehicle inspected by any autho-
rized Toyota dealer or repairer, or another duly qualified and
equipped professional.
*3: The light turns on when the engine coolant temperature is low.
*4: The light flashes to indicate that the system is operating.
Warning lights
Warning lights inform the driver of malfunctions in any of the
vehicle’s systems. (P. 565)
(red)(if equipped)
(if equipped)(yellow:
hybrid
vehicle)(if equipped)(if equipped)(diesel
engine)(if equipped)(if equipped)
(if equipped)(diesel
engine)(diesel
engine)(hybrid
vehicle)(hybrid
vehicle)
(hybrid
vehicle)(hybrid
vehicle)
*1,*2*1,*2*1,*2*1,*2*1*1,*2*1,*2*1,*2
*1,*2*1,*2,6*2*5,*7*1,5*1*3*4
*1*1*2*2
*2*2

284 2-2. Instrument cluster
YARIS_F (including HV)_WE_52C79E
*1: Except hybrid vehicle: These lights turn on when the engine switch
is turned to the “ON” position (vehicles without a smart entry & start
system) or the “ENGINE START STOP” switch is turned to IGNI-
TION ON mode (vehicles with a smart entry & start system) to indi-
cate that a system check is being performed. They will turn off after
the engine is started, or after a few seconds. There may be a mal-
function in a system if a light does not come on, or if the lights do
not turn off. Have the vehicle inspected by any authorized Toyota
dealer or repairer, or another duly qualified and equipped profes-
sional.
*2: Hybrid vehicle: These lights turn on when the engine switch is
turned to the “ON” position (vehicles without an electronic key) or
the “POWER” switch is turned to ON mode (vehicles with an elec-
tronic key) to indicate that a system check is being performed. They
will turn off after the hybrid system on, or after a few seconds. There
may be a malfunction in a system if a light does not come on, or if
the lights do not turn off. Have the vehicle inspected by any autho-
rized Toyota dealer or repairer, or another duly qualified and
equipped professional.
*3: These lights turn on when the engine switch is turned to the “ON”
position (vehicles without a smart entry & start system) or the
“ENGINE START STOP” switch is turned to IGNITION ON mode
(vehicles with a smart entry & start system) to indicate that a system
check is being performed. They will turn off after the engine is
started, or after a few seconds.
*4: The light flashes in yellow to indicate a malfunction. The light
flashes quickly in green to indicate that the steering lock has not
been released.
*5: Except hybrid vehicle: The light flashes to indicate a malfunction.
*6: The light turns on to indicate a malfunction.
*7: Hybrid vehicle: The light comes in yellow to indicate a malfunction.