warning VOLKSWAGEN CC 2012 Owners Manual

Page 446 of 578


change or delete system settings (including time, date, personal con-
venience settings, and programming). Check the settings and correct
as necessary once the vehicle battery has built up a sufficient charge.
Warning light

Page 449 of 578


WARNING
Working on the batteries can cause serious acid burns, explo-
sion, or electrical shock.
Always wear eye protection and protective gloves.
Sulfuric battery acid is very corrosive. It can burn unprotect-
ed skin and cause blindness. Always wear protective gloves
and eye protection.
Never tilt the vehicle battery. Acid could spill out of the bat-
tery vents and burn you.
Never open a vehicle battery.
If you get battery acid in your eyes or on your skin, immedi-
ately rinse with cold water for several minutes and then get
immediate medical attention.
If you swallow any battery acid, get medical attention imme-
diately.
Charging, replacing, disconnecting, and connecting the vehicle
battery

Page 451 of 578


Automatic electrical load deactivation
If the vehicle battery drain is high, the intelligent onboard electrical
system management automatically takes steps to help prevent bat-
tery drain.
The idle speed is increased so that the alternator provides more
power.
The power to devices that consume a lot of electricity is cut back or
switched off completely.
When the engine is started, the power supply to the 12 Volt sockets
is temporarily interrupted.
The onboard electrical system management cannot always keep the
battery from being drained. For example, the battery will drain if the
engine is not running, but the ignition is switched on or the parking
lights are left on for a long time when parked.
Battery disconnection in an accident with airbag deployment
In vehicles with a battery in the luggage compartment, the electrical
connection to the battery is disconnected automatically in a collision
with airbag deployment. This helps to prevent a short-circuit.
What drains the vehicle battery?
Long periods when the engine is not running, especially when the
ignition is on.
Using electrical systems or devices when the engine is switched
off.
Leaving the vehicle unlocked for several days when not in use.
The selector lever is left for a long period of time in any position
other than P when the ignition is switched off ⇒  Automatic transmis-
sion: Selector lever.
WARNING
Failure to use the proper battery with proper mounting and
connections may cause short circuits, fires, and serious per-
sonal injuries.
Always use only maintenance-free or cycle-free, leak-proof
batteries with the same specifications and dimensions as the
original equipment battery. Specifications are listed on the bat-
tery housing.

Page 452 of 578


WARNING
When the vehicle battery is charged, it produces highly explo-
sive hydrogen gas.
Charge vehicle batteries only in well-ventilated areas.
Never charge a frozen or thawed battery. A dead battery can
freeze at temperatures around +32 °F (0 °C).
You must replace the vehicle battery if it was frozen.
Incorrectly connected cables can cause a short-circuit. First
connect the positive cable (+) and then the negative cable (-).
NOTICE
Never disconnect the vehicle battery or connect 2 vehicle bat-
teries to each other when the ignition is switched on or the en-
gine is running. Doing this may damage the electrical system or
electronic components.
Never use a vehicle battery that does not meet the specifica-
tions for the vehicle battery for your vehicle. Using the wrong
battery can damage the electrical system or electronic compo-
nents and cause electrical malfunctions.
Never connect power generating equipment, such as a solar
panel or battery charger, to the 12 Volt socket in order to charge
the vehicle battery. This can damage the vehicle's electrical sys-
tem.
Dispose of the vehicle battery according to regulations. Vehicle
batteries contain poisonous substances such as sulfuric acid and
lead.
Battery acid can pollute the environment. Catch leaking operating
fluids and dispose of them properly.

Page 454 of 578


WARNING
Vehicle care products can be dangerous. Improper use can
cause accidents, burns, poisoning, or other serious personal
injuries.
Always store vehicle care products only in original contain-
ers that are securely closed.
Always read and heed all the instructions and all WARNINGS
on the package.
To reduce the risk of poisoning, never use empty food or
beverage containers that might mislead someone into drinking
from them.
Always keep vehicle care products out of the reach of chil-
dren.
Always use such products outdoors or in well-ventilated are-
as, because harmful vapors may be released when these prod-
ucts are used.
Never use fuel, turpentine, engine oil, nail polish remover or
other volatile fluids for vehicle care. They are poisonous and
highly flammable.
WARNING
Improper care and cleaning of vehicle components can impact
the safety features of the vehicle and cause severe injuries.
Always clean and maintain vehicle components according to
manufacturer's instructions.
Only use approved or recommended cleaners.
NOTICE
Vehicle care products containing solvents can damage plastics
and other vehicle the materials.
Wash the vehicle only at specifically designated wash locations
to help prevent water contaminated with oil, grease and fuel from en-
tering the storm drain sewer system. In some areas it is against the
law to wash motor vehicles anywhere than other than at specified
designated car washing locations.

Page 455 of 578


When buying vehicle care products, try to choose those that are
not harmful to the environment.
Never throw out vehicle care products with ordinary household
waste. Always read and heed all the instructions and all WARNINGS
on the package.
Washing the vehicle

Page 456 of 578


Rinse the sponge or glove thoroughly and often.
Clean the wheels and under the door sills last. Use a different sponge
or wash mitt.
WARNING
After the vehicle has been washed, the wet brakes or, in winter,
brake discs or pads coated with ice, react slower and need
longer stopping distances.
Always dry the brakes and clean off any ice coatings with a
few careful applications of the brake. Make sure not to endan-
ger other motorists or cyclists or disobey legal requirements.
CAUTION
Sharp edges under the vehicle can cut exposed skin.
Always protect your hands and arms from cuts on sharp
metal edges when cleaning the underbody, the inside of the
wheel housings, etc.
NOTICE
The water temperature must not be more than +140 °F
(+60 °C).
To help prevent damage to the paint, do not wash the vehicle
in direct sunlight.
Do not use insect sponges, abrasive kitchen sponges or simi-
lar things to clean the vehicle. These can damage the paint fin-
ish.
Never clean headlights with a dry cloth or sponge. Always use
a wet cloth or sponge. For best results use soapy water.
When washing or rinsing the vehicle in cold weather, do not
let water get into the lock cylinders or point the hose at gaps
around the doors, hood, or luggage compartment lid. The water
could freeze on the locks and seals and make it difficult to open
the vehicle!

Page 458 of 578


WARNING
Improper use of power washers can cause serious invisible
permanent damage leading to tire failure and loss of vehicle
control. This can cause accidents and severe personal injury.
Keep sufficient distance between water jet and tires. Never
wash tires with a nozzle that sprays the water out in a direct
stream regardless of the distance to the tire and even for a very
short time.
Never use “dirt blasters” to clean tires. Even spraying from a
relatively long distance for a very short time can do visible or
invisible damage to tires.
WARNING
After the vehicle has been washed, the wet brakes or, in winter,
brake discs or pads coated with ice, react slower and need
longer stopping distances.
Always dry the brakes and clean off any ice coatings with a
few careful applications of the brake. Make sure not to endan-
ger other motorists or cyclists or disobey legal requirements.
NOTICE
Water temperature should not be more than +140 °F (+60 °C).
To help prevent damage to the paint, do not wash the vehicle
in direct sunlight.
In order for Park Distance Control to work correctly, the sen-
sors in the rear bumper must be kept clean and clear of snow
and ice.
When using a power washer or steam cleaner, only spray the
sensors directly for a short period of time and always keep the
nozzle at least 4 inches (10 cm) from the sensor.
Do not clean icy or snow-covered windows with a power
washer.
When washing or rinsing the vehicle in cold weather, do not
let water get into the lock cylinders or point the hose at gaps
around the doors, hood, or luggage compartment lid. The water

Page 460 of 578


Removing ice
The best way to remove ice is with a deicer spray. When using an ice
scraper always scrape in one direction, never back and forth. Dirt can
scratch the glass when moving the scraper backward.
WARNING
Dirty or fogged up windows reduce visibility and increase the
risk of accidents and severe injuries.
Don't drive until you have clear visibility through all windows.
Remove ice, snow and condensation from all inside and out-
side window surfaces.
NOTICE
Never mix recommended cleaning agents with other cleaning
agents in the windshield washer reservoir. If you do, this could
cause sediments or other by-products that can clog the wind-
shield wiper nozzles.
Never use warm or hot water to remove snow and ice from
windows and mirrors. This could cause the glass to crack!
The heating elements for the rear defroster are on the inside of
the rear window. Do not put stickers over the heating elements
on the inside of the rear window and never clean the inside of
the windows with corrosive or acidic cleaning agents or other
chemicals that could damage the heating elements.
Antennas installed on the insides of windows can be damaged
by abrasive objects or by corrosive or acidic cleaning agents or
other chemicals. Do not place any stickers on the windshield-
integrated antenna and never clean the antenna with corrosive
or acidic cleaning agents or other chemicals.

Page 462 of 578


Changing wiper blades
Lift the wiper arm(s) away from the windshield.
Press and hold the release button ⇒ fig. 172 (1).
While lifting the wiper blade in the direction of the wiper arm, pull
off the wiper blade in the direction of the arrow. This may require
moderate force.
Install a new wiper blade of same length and type onto the wiper
arm by pushing in the opposite direction of the arrow until it latches.
Carefully fold the wiper arm back down onto the windshield.
WARNING
Worn or dirty wiper blades reduce visibility and increase the
risk of accidents and severe injuries.
Always change wiper blades if they are damaged or worn,
and if they cannot clean the windows sufficiently.
NOTICE
Damaged or dirty wiper blades can scratch the windshield.
Solvents, abrasive sponges and sharp-edged objects will
damage the graphite coating on the wiper blades.
Do not clean the windows with gasoline, nail polish remover,
paint thinner or similar fluids.
To help prevent damage to the engine hood and the wind-
shield wiper arms, lift the wiper arms away from the windshield
only when they are in the service position.
Waxing and polishing vehicle paint

Page:   < prev 1-10 ... 131-140 141-150 151-160 161-170 171-180 181-190 191-200 201-210 211-220 ... 220 next >