brake VOLKSWAGEN CC 2017 Owners Manual

Rear view

Fig. 3 Vehicle rear overview.
Key to ⇒ fig. 3:
(1) Rear window:
– Rear window defroster
– Rear window antenna
(2) High-mounted brake light
(3) Taillights (on both left and right)
(4) Volkswagen emblem. Area for:
– Luggage compartment release
– Rear Assist camera (if equipped)
(5) Threaded hole for the rear towing eye (behind cover)
(6) Roof antenna
(7) Park Distance Control (PDC) sensors (on both left and right, if
equipped)
(8) Area for attaching a trailer hitch

Lower center console

Fig. 7 Overview of the lower center console.
Key to ⇒ fig. 7:
(1) Lever for:
– Manual transmission
– Automatic transmission
(2) Storage compartment with cup holders in the center console
(3) Storage compartment in the center armrest
(4) Buttons for:
– Starter button (vehicles with Keyless Access locking and start-
ing system)
– Electronic parking brake G
– Anti-slip regulation (ASR) m
– Rear window sunshade j
– Park Distance Control (ParkPilot) '
(5) Storage compartment:
– with 12 Volt socket

d Secure animals in the vehicle with a system that corresponds to
their weight and size.
WARNING
Always observe traffic rules and posted speed limits and use
common sense. Your good judgment can mean the difference
between arriving safely at your destination and being seriously
injured in a crash or other kind of accident.
Regular service and maintenance of your vehicle is important
both for operational and driving safety and to help prolong your vehi-
cle's service life. Always follow the scheduled maintenance intervals
in the ⇒ Booklet Warranty and Maintenance, especially for changing
the brake fluid. Hard use, frequent stop-and-go driving, driving in very
dusty areas, trailer towing, and other factors may make it necessary
to have the vehicle serviced more frequently. Ask an authorized
Volkswagen dealer or an authorized Volkswagen Service Facility for
more information.
Driving in other countries

WARNING
After driving through water, mud, sludge, etc., the brakes react
slower and need longer stopping distances.
Always dry the brakes and clean off any ice coatings with a
few careful applications of the brake. Make sure not to endan-
ger other motorists or cyclists or disobey legal requirements.
Avoid abrupt or sudden braking maneuvers immediately after
driving through water.
NOTICE
Vehicle components such as the engine, transmission, sus-
pension or electrical system may be severely damaged by driv-
ing through water.
Never drive through salt water. Salt causes vehicle corrosion.
Thoroughly rinse with fresh water all vehicle parts that were ex-
posed to salt water.

Memory buttons
Personal settings for the front seats and outside mirrors can be as-
signed to each memory button.
These settings can be assigned to individual remote control vehicle
keys. The settings are applied after unlocking the vehicle and opening
the driver door.
Storing driver seat settings and forward driving settings for
outside mirrors
Switch on the ignition.
Manual transmission: Shift the transmission to Neutral (N) and set
the electronic parking brake.
Automatic transmission: Shift the transmission to Park (P).
Adjust the driver seat and outside mirrors.
Press the 3%4 button for at least 1 second ⇒ fig. 57.
Press the desired memory button 1 , 2 , or 3 within 10 seconds. A
chime sounds to confirm that the setting has been stored.
Storing front passenger seat settings to the front passenger seat
memory buttons
Switch on the ignition.
Adjust the passenger seat.
Press the 3%4 button for at least 1 second ⇒ fig. 57.
Press the desired memory button 1 , 2 , or 3 within 10 seconds. A
chime sounds to confirm that the setting has been stored.
Storing passenger-side outside mirror settings for backing up
Set the electronic parking brake.
Switch on the ignition.
Shift the transmission to Neutral (N).
Briefly press the desired memory button 1 , 2 , or 3 on the outside
of the driver seat.
Shift the transmission into Reverse (R).
Adjust the passenger outside mirror to provide good visibility of the
curb, for example.
The adjusted mirror position is automatically stored and assigned
to the vehicle key used to unlock the vehicle. The preselected posi-

If the light switch is in position !54/, a low-light sensor switches the
low beams as well as the instrument and switch lighting on and off
automatically.
Daytime running lights (DRL) parking feature
Some models are equipped with a daytime running lights (DRL) park-
ing feature that switches the daytime running lights off when the vehi-
cle is parked and the ignition is switched on.

Function Action
Switching the DRL off: – Switch the ignition on.
– Turn the light switch to the /
position.
– Set the parking brake.
Switching the DRL back on: – Release the parking brake.

Static cornering lights
Your vehicle may have fog lights under the front bumper, which on
some models are also static cornering lights. On some models the
static cornering lights may be integrated in the headlights. At speeds
below about 25 mph (40 km/h), the light on one side of the vehicle will
come on automatically when you turn a corner. If you turn to the right,
the right fog light comes on; turn left and the left fog light comes on.
The light dims and goes out when the steering wheel is straightened
out again.
When you move the selector lever to Reverse (R), the static cornering
lights on both sides of the vehicle may come on so that you can see
the area around the vehicle better when backing up.
The static cornering lights work only when the headlights are on. If
you are using automatic headlight control (headlight switch in the !54/
position ⇒ fig. 86), they work only when the headlights have been
automatically switched on. The static cornering lights do not come on
when the headlight switch is in the / position or when the fog lights
themselves have been switched on ⇒ Switching lights on and off.

Turn the adjusting knob to the L position.
Adjust the left outside mirror. The right (passenger) outside mirror
will automatically adjust at the same time.
If needed, correct the position of the right mirror by turning the ad-
justing knob to the R position.
Auto-dimming outside mirror on the driver side
Some models are equipped with an auto-dimming outside mirror,
which is controlled together with the auto-dimming inside mirror ⇒ 
Inside mirror.
Memory for front passenger side mirror (when backing up)
On vehicles equipped with memory seats ⇒ page 136, Memory seats,
the passenger side mirror settings for backing up can be stored as
follows:
Choose the remote control vehicle key that will be used with the
settings about to be made.
Unlock the vehicle with that remote control vehicle key.
Set the electronic parking brake.
Switch on the ignition.
Activate the function Mirror down in the Settings - Convenience
menu.
Turn the adjusting knob for the side mirrors to the R position.
Shift the transmission into Reverse (R).
Adjust the passenger outside mirror for a clear view of the curb, for
example.
The adjusted mirror position is automatically stored and assigned
to the vehicle key used to unlock the vehicle. The preselected posi-
tion will be recalled when the key assigned to that mirror adjustment
position is used again.
Recalling passenger side mirror settings
Turn the adjusting knob for the side mirrors to the R position.
Shift the transmission into reverse gear with the ignition switched
on.
The mirror moves back to the regular position when the vehicle
moves forward faster than about 10 mph (15 km/h) or the adjusting
knob is turned to the O or L position.

WARNING
Heavy loads will influence the way your vehicle handles and
increase stopping distances. Heavy loads that are not properly
stowed or secured can cause loss of control and serious injury.
Secure the load properly to keep it from shifting.
Always remember when transporting heavy objects that a
change in the center of gravity also changes the way your vehi-
cle handles:
– Always distribute the load as evenly as possible.
– Secure heavy objects properly as far forward in the lug-
gage compartment as possible.
– Always tie down heavy items securely with suitable straps
using the tie-downs in the luggage compartment.
Securely latch the rear seat backrest in the upright position.
Never exceed the Gross Axle Weight Rating or the Gross Ve-
hicle Weight Rating on the safety compliance sticker on the left
door jamb. Exceeding permissible weight can cause the vehicle
to skid and handle differently.
Always adapt your speed and driving to the heavier load and
the weight distribution in the vehicle. Take road, weather, traf-
fic, and visibility conditions into account as well.
Always accelerate gently and avoid sudden braking and driv-
ing maneuvers.
Always brake earlier than you would if you were not driving a
loaded vehicle.
Stowing luggage

Brake earlier than you would if you were not driving a loaded vehi-
cle.
If applicable, observe information about driving with a trailer ⇒ 
Trailer towing.
If applicable, observe information about driving with a roof rack ⇒ 
Roof rack.
WARNING
Heavy loads can change the way your vehicle handles and in-
crease stopping distances. Heavy loads that are not properly
stowed or secured can shift suddenly, causing loss of control
and serious injury.
Secure the load properly to keep it from shifting.
Always remember when transporting heavy objects that they
change the vehicle's center of gravity and also the way it han-
dles.
– Always distribute the load as evenly as possible.
– Secure heavy objects as far forward in the luggage com-
partment as possible.
– Secure luggage in the luggage compartment using suitable
straps and the tie downs ⇒ Tie-downs. Also see ⇒  Luggage
compartment.
Always tie down heavy items securely with suitable straps.
Securely latch the rear seat backrest in the upright position.
Never exceed the Gross Axle Weight Rating or the Gross Ve-
hicle Weight Rating on the safety compliance sticker on the left
door jamb. Exceeding permissible weight can cause the vehicle
to skid and handle differently.
Always adapt speed and driving to the heavier load and the
weight distribution in the vehicle. Take road, weather, traffic,
and visibility conditions into account as well.
Always accelerate gently and avoid sudden braking and driv-
ing maneuvers.
Always brake earlier than you would if you were not driving a
loaded vehicle.

WARNING
Transporting heavy objects causes the handling characteristics
of the vehicle to change and increases braking distances.
Heavy loads which are not properly stowed or secured in the
vehicle can lead to a loss of vehicle control and cause serious
personal injury.
Transporting heavy items causes the handling characteris-
tics of the vehicle to change by shifting the vehicle's center of
gravity.
Always distribute luggage evenly and as low as possible
within the vehicle. The vehicle capacity weight figures apply
when the load is distributed evenly in the vehicle (passengers
and luggage).
Always stow luggage and heavy items in the luggage com-
partment as far forward of the rear axle as possible and secure
them with appropriate straps to the tie-downs provided.
Never exceed the vehicle's Gross Vehicle Weight Rating or
Gross Axle Weight Ratings, which are printed on the Safety
Compliance Certification Label located on the door jamb of the
driver door. Exceeding the permissible weight can cause the
vehicle to skid and behave differently.
Always adapt your speed and driving style to accommodate
your payload and its weight distribution within your vehicle.
Be especially cautious and gentle when stepping on the ac-
celerator pedal and avoid sudden braking and other maneu-
vers.
Brake earlier than you would if you were not driving a loaded
vehicle.
NOTICE
The defroster heating wires or antenna in the rear window can
be damaged by objects that rub against them.
The ventilation slots between the rear window and the shelf be-
hind the rear seat backrest must not be blocked so that stale air can
escape from the vehicle.