replace VOLKSWAGEN ID.4 2022 Owners Manual

incorrectly it may cause injuries even in
a minor accident.
x After an accident, it is vital to replace
any child seats that were in use during
the accident, as they could ha
ve sus-
tained non-visible damage. NOTICE
Please observe the notes and information for
v
ehicles with N1 approval

x
Do not place any damp or wet objects or
items of clothing on the seat.
x Do not spill any liquids on the seat. NOTICE
x To a void damaging the heating elements,
do not kneel on the seats and do not apply
sharp pressure at a single point to the seat
cushion and backrest.
x Liquids, sharp objects and insulating mate-
rials, such as a protective cover or child
seat, may damage the seat heating.
x If an odour develops, immediately switch
off the seat heating and have it checked
by a qualified workshop.
x If the original seat covers are replaced
with another material, the seat heating
can overheat or the seat heating function
may be restricted. To save energy, switch off the seat
heating as soon as possible. Steering wheel heating
Please refer to and at the start of
the chapter on page 120.
The steering wheel heating can function only
when the v

ehicle

1. Touch to show the frequency band.
2.
Touch the marking, move on the fre-
quency band and release at the desired
frequency.
OR: touch a point on the frequency
band. The marking automatically jumps
to the corresponding frequency.
The station at the set frequency is set.
Selecting from station list (FM/DAB) and enter the name of the desired sta-
tion. The list of f

ound stations is auto-
matically updated during input.
OR: select the desired category to filter
stations according to a category.
2. Touch the desired station.
SCAN Searching in SCAN mode (FM/DAB) .
OR: touch and hold a station in the sta-
tion list.
3.

Touch .
OR: touch an already assigned station
button and hold f

or around 3 seconds.
The station is stored to the selected station
button.
If a station was already stored on the station
button, this station will be removed from the
station button and replaced by the new sta-
tion. Online functions in radio
mode
Please refer to and on page 218.
With some equipment le

vels, the Infotain-
ment system has online functions in radio
mode.
Internet Radio is an example of an online
function in radio mode.
Requirements for using online functions in
radio mode:
q The vehicle is equipped with We Con-
nect Start.
q We Connect Start is activated and the
vehicle is assigned to your user account.
q You have a data plan on the SIM-card of
your mobile device and have connected
Radio mode 233
11A012720AB

signed differently depending on the vehicle
equipment le vel and because several electri-
cal consumers may use a single fuse. You can
obtain further information about the fuse as-
signment from a Volkswagen dealership.
Several electrical consumers can share a sin-
gle fuse. Conversely, a single consumer could
have more than one fuse.
Therefore fuses should only be replaced
when the cause of the fault has been recti-
fied. If a new fuse blows again shortly after
fitting, have the electrical system checked by
a qualified workshop as soon as possible.
Fuses for emergency services (high-voltage
system)
High-voltage system fuses in the fuse box
under the steering wheel, behind the stow-
age compartment (left-hand drive) or behind
a cover in the glove box (right-hand drive)
and behind a cover on the right side of the
luggage compartment are identified with
a tag to enable emergency services to de-en-
ergise the vehicle as quickly as possible. Nev-
er attempt to replace these fuses or swap
them with other fuses in other slots

x
The refilled brake fluid must be new. NOTICE
Brake fluid that has leaked or been spilt can
damage the v ehicle paintwork, plastic parts
and tyres. Wipe off brake fluid that has
leaked or been spilled immediately from all
parts of the vehicle. Brake fluid can pollute the environ-
ment. Any spilt service fluids must be
cleaned up and disposed of properly. 12-volt vehicle battery
Introduction to the topic
The 12-
volt vehicle battery is a component of
the electrical system and in event of the
high-voltage system failing, supplies the
safety-relevant systems of the vehicle with
energy. In the scope of maintenance work,
the 12-volt vehicle battery is checked and
where required, replaced.
You should only carry out work on the electri-
cal system if you know exactly how to per-
form the required tasks, are aware of the
general safety procedures and have access to
the correct equipment, service fluids and
suitable tools. Failing to carry out work cor-
rectly can cause serious injuries

x
Children should always be kept away
from electrolyte and the 12-
volt vehicle
battery.
x Always wear eye protection and protec-
tive gloves.
x Electrolyte is very aggressive. It can burn
the skin and can cause blindness. When
working with the 12-volt vehicle battery,
ensure that your hands, arms and face in
particular are protected from acid spill-
age.
x Do not smoke during the work, and nev-
er work near naked flames or sparks.
x When handling cables and electrical
equipment, avoid generating sparks and
electrostatic charge.
x Never short circuit the battery terminals.
x Never use a damaged 12-volt vehicle
battery. It can explode. Damaged 12-
volt vehicle batteries must be replaced
as soon as possible.
x Never use a frozen 12-volt vehicle bat-
tery. Discharged 12-volt vehicle batter-
ies can already freeze at temperatures of
around 0

Replacing the 12-volt vehicle battery
The 12-
volt vehicle battery has been devel-
oped to suit the conditions of its installation
location and has special safety features. If
a 12-volt vehicle battery has to be replaced,
discuss the electromagnetic compatibility,
size and necessary servicing, output and safe-
ty requirements for the new 12-volt vehicle
battery with a Volkswagen dealership before
purchase. The ventilation opening of the 12-
volt vehicle battery must always be on the
negative terminal side: the ventilation open-
ing on the positive terminal side must always
be sealed.
Only maintenance-free 12-volt vehicle bat-
teries compliant with the standards
TL 825 06 and VW 7 50 73 should be used.
These standards must be dated October 2014
or later.
Always have the 12-volt vehicle battery re-
placed by a qualified workshop, as the vehicle
electronics must be adapted as part of the
replacement process. Only qualified work-
shops have the technology required to carry
out this adjustment correctly. Volkswagen
recommends that the 12-volt vehicle battery
is replaced by a Volkswagen dealership.
Disconnecting the 12-volt vehicle battery
Please observe the following if the 12-volt
vehicle battery has to be disconnected from
the electrical system in the vehicle:

Changing a wheel
Introduction to the topic
You should carry out a wheel change yourself
only when the v
ehicle is parked safely, you
are familiar with the safety procedures and
have access to the correct equipment. Some
models are delivered from the factory with-
out a jack or box spanner. If this is the case,
wheels should be changed by a qualified
workshop.
The jack supplied with the vehicle is only de-
signed for changing a wheel when one vehi-
cle tyre is damaged and has to be replaced. If
both tyres on one side of the vehicle, both
tyres on one axle, or all tyres are damaged,
seek expert assistance. to the P position to reduce the risk of
unintended v

ehicle movement.
x Switch on the electronic parking brake.
x The wheel bolt tightening torque should
be checked with a correctly functioning
torque wrench immediately after chang-
ing a wheel.
x In the case of vehicles with a Tyre Pres-
sure Loss Indicator, the system must be
re-synchronised immediately after
a wheel change

Accessories, modifica-
tions, repairs and renewal
of parts
Accessories and parts
V olkswagen recommends that you seek ad-
vice from a Volkswagen dealership before
purchasing accessories, replacement parts or
service fluids, for example if the vehicle is to
be retrofitted with accessories or if parts
have to be renewed. Volkswagen dealerships
can recommend accessories, parts and serv-
ice fluids suitable for your requirements. They
can also answer any questions you might
have regarding official regulations.
Volkswagen recommends that you use only
approved Volkswagen accessories and Volks-
wagen Genuine Parts

Customers in Europe, Asia, Australia, Africa,
Central and South America:
Please contact a V
olkswagen dealership or
qualified workshop or register on the erWin
online portal (electronic repair and workshop
information):
https://erwin.volkswagen.de
Customers in North America and Canada:
To order printed service information please
contact:
Volkswagen Technical Literature Ordering
Center
literature.vw.com
You can also register online in the erWin in-
ternet portal:
https://erwin.vw.com
Vehicles with special auxiliary equipment or
body parts
Auxiliary equipment and second stage manu-
facturers must ensure that the equipment
and bodies (conversions) adhere to the stipu-
lated environmental laws and regulations,
particularly the EU directive 2000/53/EC con-
cerning end-of-life vehicles and EU directive
2003/11/EC concerning the restriction on the
marketing and use of certain dangerous sub-
stances and preparations.
The vehicle owner must keep all assembly
documentation for these conversions and
pass it on to the scrapping company upon ve-
hicle handover if the vehicle is scrapped. This
is intended to facilitate environmentally re-
sponsible disposal for all vehicles, including
refitted vehicles.
Windscreen repairs
To function properly, some items of equip-
ment require an electrical or electronic mod-
ule, which is located on the inside of the
windscreen near the interior mirror. If the
windscreen has been damaged in the viewing
field of the electrical or electronic module,
e.g. by stone impact, the windscreen must be
replaced. Repairing the crack can lead to mal-
function or functional faults in the equip-
ment. After changing the windscreen, the camera
and sensors must be adjusted and calibrated
by a qualified workshop.
Impairment or damage to sensors and cam-
eras
Incorrectly perf
ormed repairs, structural
changes to the vehicle, e.g. lowering the sus-
pension, retrofitted add-on parts or changes
to the trim can lead to sensors and cameras
being displaced or damaged. This can also be
caused by collisions when parking, or also
even by minor damage such as stone impacts
on the windscreen.
The area in front of and around the sensors
and cameras must not be covered by stickers,
additional headlights, trim frames for number
plates or similar. Observe the position of sen-
sors and cameras on the vehicle