VOLKSWAGEN PASSAT 2015 B8 / 6.G Owners Manual

Page 361 of 397


Opening the luggage compartment lid from inside the luggage
compartment

Fig. 199 Behind the rear seat backrest on the driver side: releasing the rear seat backrest.

Fig. 200 Inside the luggage compartment: Unlocking the luggage compartment lid.

Page 362 of 397


Emergency closing of the power sunroof

Fig. 201 In headliner: Removing cover.

Fig. 202 Hexagonal head screw for closing the power sunroof.

Page 363 of 397


x Have the power sunroof checked by an authorized Volkswagen dealer or an authorized Volkswagen Service Facility. Emergency closing may cause the power sunroof and its pinch protection to malfunction.
Emergency release for the selector lever lock

Fig. 203 Removing the selector gate cover.

Fig. 204 Releasing the selector lever lock.

Page 364 of 397


x Slip the cover up and over the selector lever ⇒ .
Emergency release for the selector lever
x Push the release lever ⇒ fig. 204 in the direction of the arrow and hold it in this position.
x Press the release button in the selector lever handle and shift the selector lever to Neutral (N).
x Carefully press the selector gate cover back in place, making sure that the electrical wiring stays in the correct position and is not pinched or damaged
WARNING
Never shift the transmission out of Park (P) without first firmly applying the parking brake. Otherwise, the vehicle can start to roll unexpectedly, especially on hills or inclines, and cause an accident and serious injuries.
NOTICE
Even with the selector lever is in N (Neutral), the automatic transmission will be damaged if the vehicle is towed (or you let it coast) for an extended period or at high speed with the engine shut off.

Page 365 of 397


Vehicle tool kit

Page 366 of 397


Storage

Fig. 205 In the luggage compartment under the floor panel: Compact spare wheel and vehicle tool kit.

Page 367 of 397

Page 368 of 397


Wheel trim

Page 369 of 397


Wheel bolt caps

Fig. 207 Pulling cover caps off wheel bolts.

Page 370 of 397


x Slide the lug wrench through the clip ⇒ fig. 208 and pull the wheel cover off in the direction of the arrow.
Installing the wheel cover
Where applicable: Before installing the wheel cover, the anti-theft wheel bolt must be screwed into
position ⇒ fig. 210 (2) or (3) in relation to the position of the tire valve. Otherwise, the wheel cover cannot be installed.
Make sure that the valve cutout is aligned with the valve ⇒ fig. 210 (1), and press the wheel cover onto the wheel rim. Make sure that the wheel cover is latched onto the rim along the entire circumference.

Page:   < prev 1-10 ... 321-330 331-340 341-350 351-360 361-370 371-380 381-390 391-400 400 next >