VOLKSWAGEN PASSAT CC 2013 1.G Owner's Manual

– Back
▪ Lights & Vision
– Coming Home
– Leaving Home
– Footwell light
– Conv. turn sig. (convenience turn signal)
– Factory setting
– Back
▪ Time
– Hours
– Minutes
– 24 hr. mode
– Daylight save
– Back
▪ Snow tires (winter tires)
– On
– + 10 km/h
– - 10 km/h
– Back
▪ Compass (vehicles without navigation system)
▪ Units
– Temperature
– Consump./dist.
– Air pressure
– Back
▪ Tire pressure
▪ Alt. speed dis.
▪ Service
– Info
– Reset
– Back
▪ Factory setting
Using the instrument cluster menus

Fig. 12 Right side of the multi-function steering wheel: Controls for menus in the instrument cluster.

x Confirm the selection with /+
Switching all driver assistance systems on or off
x Press and hold the button (arrow) longer than one second to switch the driver assistance sys-
tems selected in the Assistants menu on or off at the same time.
x If no driver assistance system was activated in the Assistants menu, all systems are switched
on.
Main menu

To display the distance driven on trips 1 and 2, select the Route item in the MFI menu. Press the /+
button ⇒ fig. 12 to toggle between Route 1 and Route 2 (trip 1 and trip 2). Push and hold the /+ button
to manually reset a trip memory to zero.

1 Single trip
memory
The memory accumulates and stores information about distance driven
and fuel used from the time the ignition was switched on until the time it
was switched off.
If the ignition stays off for 2 hours or more, stored information is auto-
matically deleted. If the trip is continued within 2 hours after the ignition
was switched off, the new values are added.
2 Total trip memory
The memory displays and stores the accumulated driving and fuel
consumption data of any number of single trips up to a total driving
time of 99 hours and 59 minutes, and up to a total distance of
9,999 miles (9,999 km). If one of the maximum values is exceeded,
then the memory is automatically cleared and starts again from 0.

Possible MFI menu displays
The following displays can be accessed in the MFI menu if enabled under Settings > MFI data.
Displays that are not enabled will not appear.

Display Function
Travel time -- h/min Driving time in hours (h) and minutes (min) corresponding to trip mem-
ories 1 and 2 (toggle).
Consumption
--.- mpg
Current fuel consumption in miles per gallon (l/100 km) while driving.
When units are set to miles, dashes appear instead of a number when
the engine is running and the vehicle is standing still.
When units are set to kilometers, the display shows liters consumed
per hour when the engine is running and the vehicle is standing still.
Consumption
--.- l/100 km
Av. consumption
--.- mpg
Average fuel consumption in miles per gallon (l/100 km) on trips per trip
memories 1 and 2 (toggle) is displayed once the vehicle has been
driven about 330 feet (100 m). Until then, dashes appear instead of a
number. The value displayed is updated every 5 seconds. Av. consumption
--.- l/100 km
Range  -- mi Estimated distance in miles (km) that the vehicle can go with the fuel
left in the tank the way you are currently driving. Takes account of the
current fuel consumption, among other things. Range  -- km
Route -- mi Distance driven in miles (km) per trip memories 1 and 2 (toggle).
Route -- km
Average speed
-- mph
Average speed on trips per trip memories 1 and 2 (toggle). Displayed
once the vehicle has been driven about 300 feet (100 m). Until then,
dashes may appear instead of a number. The value displayed is up-
dated every 5 seconds. Average speed
-- km/h
-- mph Digital display of current vehicle speed.
-- km/h
Oil temp. Current engine oil temperature (digital display; 3.6 liter engine only).
Speed warning
--- mph
When the set speed (from 20–155 mph or 30–250 km/h) is exceeded,
an acoustic warning sounds and a visual message may also appear in

Display Function
Speed warning
--- km/h
the instrument cluster display.

Switching between the displays
x Use the arrow up and down buttons * and + on the multi-function steering wheel.
Storing speed for the speed warning
x Navigate to MFI > Speed warning (Speed warning -- mph or Speed warning -- km/h)
display.
x Press the /+ button to save the current speed and to activate the warning.
x If the speed is not right, press buttons * or + on the multi-function steering wheel to set a different
speed within about 5 seconds. Then press the /+ button a second time or just wait a few seconds. The
speed is saved and the warning is activated.
x To deactivate, toggle to --- mph or --- km/h and press the /+ button. The set speed is deleted.
Manually erasing trip memory 1 or 2
x Navigate to MFI > Route.
x Select the memory to be erased.
x Press the /+ button for about 2 seconds.
Enabling and disabling displays
Use the Settings menu, submenu MFI data to enable displays you want to be available under the
MFI menu in the instrument cluster display. The units in which data is displayed can also be changed
Applicable only in the United States
Settings menu

Settings menu Function
Units Set the units in which temperature, fuel consumption, and distances should be
displayed (for example, whether to show distance driven in miles or kilome-
ters).
Alt. speed
dis.
Activate/deactivate alternative speed display (mph or km/h).
Service Display service messages or reset service reminder display.
Factory
setting
Reset the functions in the Settings menu back to the factory settings.

Applicable only in Canada
Settings menu

Convenience submenu

Lights &
Vision menu
Function
Footwell light Set footwell lighting brightness or switch this feature on or off
Conv. turn
sig.
Enable/disable lane change flash (convenience turn signal). When the feature
is enabled, the turn signal flashes at least 3 times when the turn signal is
tapped 98.
Factory
setting
Resets the functions in the Lights & Vision submenu back to the factory
settings.
Back The display returns to the Settings menu.

Personal convenience settings

Driving checklists and warnings

d Properly fasten your safety belt before driving the vehicle and wear your safety belt properly at all
times while driving. Make sure that all passengers do the same
d Only transport as many passengers as there are seats and safety belts available.
d Never drive if your driving ability has been impaired, for example by medication, alcohol or illegal
drugs.
d Never let passengers or phone calls distract you while driving, and never take your attention off the
road while using vehicle software or adjusting vehicle equipment or accessories.
d Always adapt your speed and driving style to visibility, weather, road, and traffic conditions.
d Always obey traffic laws and speed limits.
d On long trips make frequent rest stops – at least once every 2 hours.
d Secure animals in the vehicle with a system that corresponds to weight and size.
WARNING
Always observe traffic rules and posted speed limits and use common sense. Your good
judgment can mean the difference between arriving safely at your destination and being se-
riously injured in a crash or other kind of accident.
Regular service and maintenance of your vehicle is important both for operational and driving
safety and to help prolong your vehicle's service life. Always follow the scheduled maintenance inter-
vals in the ⇒ Booklet Warranty and Maintenance, especially for changing the brake fluid. Hard use,
frequent stop-and-go driving, driving in very dusty areas, trailer towing, and other factors may make it
necessary to have the vehicle serviced more frequently. Ask an authorized Volkswagen dealer or an
authorized Volkswagen Service Facility for more information.
Driving in other countries