seat adjustment VOLVO S60 2009 Owner´s Manual

Contents
4
00
00 IntroductionGeneral information.................................. 10
Volvo and the environment....................... 11
Important warnings................................... 13
01
01 SafetyOccupant safety........................................ 16
Seat belts.................................................. 18
Supplemental Restraint System............... 20
Front airbags............................................. 21
Occupant Weight Sensor (OWS).............. 25
Side impact (SIPS) airbag......................... 28
Volvo Inflatable Curtain (VIC).................... 29
Whiplash Protection System (WHIPS)...... 30
Child safety............................................... 32
Child restraint systems............................. 34
Infant seats............................................... 36
Convertible seats...................................... 38
Booster cushions...................................... 40
ISOFIX lower anchors............................... 41
Top tether anchors.................................... 43
Child restraint registration and recalls...... 44
02
02 Instruments and controlsInstrument overview.................................. 48
Instrument panel....................................... 50
Indicator and warning symbols................. 52
Buttons in the center console................... 56
Steering wheel adjustment....................... 58
Lighting panel........................................... 59
Fuel filler door–unlocking manually........... 61
Left-side steering wheel lever................... 62
Right-side steering wheel lever................. 64
Hazard warning flashers, door mirror
defroster.................................................... 66
Trip computer........................................... 67
Cruise control............................................ 69
Parking brake............................................ 71
12-volt socket........................................... 72
Power windows......................................... 73
Mirrors....................................................... 75
Power moonroof (option).......................... 78
HomeLink® Wireless Control System
(option)...................................................... 80

02 Instruments and controls
Mirrors
0277
After you have adjusted the mirror(s), press the
L or R switch again (the LED will go out) to
deactivate the adjustment control.
WARNING
The mirrors should always be adjusted prior
to driving. Objects seen in the passenger's
side wide-angle door mirror are closer than
they appear to be.Remote central locking and door mirror
memory–optionIf you lock the vehicle and later unlock it with
thesame remote control and open the driver's
door, the door mirrors (and the driver's seat)
will automatically move to the position they
were in when you left the vehicle. This feature
will work in the same way with all of the remote
control transmitters (up to 3) that you use with
your vehicle. This feature will not function if you
lock your vehicle with the key.

03 ClimateElectronic climate control, ECC
0390
Blower control
Turn the control clockwise to
increase or counterclockwise
to decrease the blower
speed. Pressing the AUTO
switch will automatically reg-
ulate blower speed and over-
ride manual adjustment.
Turning the blower control counterclockwise
until an orange LED comes on will turn both the
blower and the air conditioning off.Air distributionAir flow to windows
Air through panel vents
Air through floor vents
G027267
PressAUTO to automatically regulate air flow
or press any combination of the controls
shown in the illustration to manually adjust air
flow. An LED in the switch will light up if an air
flow control has been pressed.Heated front seats (option)•
Press the switch once for maximum seat
heating. Both LEDs in the switch will be lit.
•
Press the switch a second time for comfort
heating. One LED in the switch will be lit.
•
Press the switch a third time to turn the
heating off completely. The LED will go off.
The seat heating for the passenger seat should
be switched off when the seat is not occupied.
A/C - ON/OFF
Press the switch to turn the air
conditioning on or off. The
"ON" or "OFF" LED will light up
to indicate if the system is
switched on or off. Other func-
tions will still be regulated auto-
matically (if the AUTO switch is on).
•
The air conditioning functions only at tem-
peratures above 32 °F (0 °C).
•
While the Defroster function is selected,
the air conditioning is temporarily activated
to dehumidify the air, even if you have man-
ually switched the air conditioning off. This
will only function if the blower is not
switched off.
Recirculation
Press this switch to engage the
recirculation function (air in the
passenger compartment recir-
culates - no fresh air enters the
compartment). The LED in the
switch will light up to indicate
that the function is engaged.
MANAUT€
Use this function if the outside air is con-
taminated with exhaust gases, smoke, etc
or to heat/cool the vehicle quickly.
€
Recirculation should not be used for more
than 15 minutes. If your windows begin to
fog or mist, make sure that the recirculation
function is switched off.
€
SelectingDefroster automatically
switches recirculation off.

04 InteriorFront seats
0494
Manually adjusted front seats
G027214
1. Front-rear adjustment: lift the bar and
move the seat to the position of your
choice.
2. Raise/lower the front edge of the seat
cushion (option): use the control to pump
the front edge of the cushion up or down.
3. Raise/lower seat height: pump the seat up
or down.
4. Lumbar support: turn the control for firmer
or softer lumbar support.
5. Backrest tilt: turn the control to adjust the
angle of the backrest.6. Control panel for optional power seat (see
page 94 for more information).
WARNING
Do not adjust the seat while driving. The
seat should be adjusted so that the brake
pedal can be depressed fully. In addition,
position the seat as far rearward as comfort
and control allow.
Check that the seat is securely locked into
position after adjusting.Folding the backrests in the front seat
G014805
The front passenger seat backrest can be
folded to a horizontal position to make room for
a long load. Fold the backrest as follows:•
Move the seat as far back as possible.
•
Adjust the backrest to the upright position.
•
Lift the catches on the rear of the backrest.
•
Without releasing the catches, push the
backrest forward.
•
Move the seat as far forward as possible
so that the head restraint slides under the
glove compartment.WARNING
Cover sharp edges on the load to help pre-
vent injury to occupants. Secure the load to
help prevent shifting during sudden stops.Power seat - (option on certain models)OperationDriver's seat: The seat can be adjusted if the
ignition key is in position I, II or if the engine is
running. It can also be adjusted as follows with
the ignition off:

04 Interior
Front seats
04``95
•
Within several minutes after the driver's
door has been unlocked from the outside,
has been opened, and remains open.
•
Within a short period if the driver's door has
just been closed.
•
Within a short period if the driver's door has
not been opened after the ignition has
been switched off.
Passenger seat: The seat can only be
adjusted if the ignition key is in position I, II or
if the engine is running.
G027036
Power seat control panel
Front edge of seat (raise/lower)Front - rear
Rear edge of seat (raise/lower)Backrest tilt
Seat adjustmentIf your Volvo is equipped with power seats, the
following may be adjusted with the two
switches at the side of the seat:
NOTE
The power seats have an overload protector
that activates if a seat is blocked by any
object. If this occurs, switch off the ignition
(key in position 0) and wait for a short period
before operating the seat again.Emergency stopIf the seat accidentally begins to move, press
any of the buttons to stop the seat.
Remote keyless entry system and the driv-
er's seat
The remote control transmitter also controls
the position of the electrically operated driver's
seat in the following way:
1. Adjust the seat to your preferences.
2. When you leave your vehicle, lock it using
the remote control.
The position of the seat is now stored in the
remote control.
Automatic seat adjustmentTo move the seat to the position in which you
left it:
1. Unlock the driver's door with the same
remote control (the one used to lock the
doors)
2. Open the driver's door within 2 minutes.
The driver's seat will automatically move to the
position in which you left it.
NOTE
•
The seat will move to this position even
if someone else has moved it to a dif-
ferent seating position and locked the
vehicle with a different remote control.
•
This feature will work in the same way
with all of the remote control transmit-
ters (up to 3) that you use with your
vehicle.
•
This feature will not function if you lock
your vehicle with the key.

04 InteriorFront seats
0496
WARNING
•
Because the driver's seat can be
adjusted with the ignition off, children
should never be left unattended in the
vehicle.
•
Movement of the seat can be STOPPED
at any time by pressing any button on
the power seat control panel.
•
Do not adjust the seat while driving. The
seat should be adjusted so that the
brake pedal can be depressed fully. In
addition, position the seat as far rear-
ward as comfort and control allow.
•
The seat rails on the floor must not be
obstructed in any way when the seat is
in motion.
Programming the memory (option)
G027037
Three different seating and door mirror posi-
tions can be stored in the driver seat's memory.
The following example explains how button 1
can be programmed. Buttons 2 and 3 can be
programmed in the same way.
To program (store) a seat position in button 1:
1. Move the seat to the desired position using
the seat adjustment controls (see
page 95).
2.
Press and hold down the MEM (memory)
button.3.
With the MEM button depressed, press
button 1 briefly to store the seat's current
position.
To move the seat to the position that it was in
when button 1 was programmed:
Press and hold down button 1 until the seat
stops moving.
As a safety precaution, the seat will stop auto-
matically if the button is released before the
seat has reached the preset position.

10 AudioRadio functions HU-650/HU-850
10220
The volume level for the auxiliary device can
now be adjusted.
Press EXIT to save the setting and exit the
menu.Sound settings
G027191
Optimal sound reproductionThe audio system is calibrated for optimal
sound reproduction through the use of digital
signal processing. This calibration takes into
account the speakers, amplifier, cabin acous-
tics, the seating position of the listener, etc., for
each combination of vehicle and audio system.
There is also dynamic calibration that takes
into account the setting of the volume control,radio reception, and the vehicle's speed. The
sound settings described in this manual, such
as
BASS
,TREBLE
, and
EQUALIZER
are only
intended to enable the user to adapt sound
reproduction to his/her personal preferences.
Bass
Adjust the bass by pressing the button to
extend the control and turning it to the left (less
bass) or to the right (more bass). A "detent"
indicates "equalized" bass. Press the button
back in when you have made the adjustment.
Treble
Adjust the treble by pressing the button to
extend the control and turning it to the left (less
treble), or to the right (more treble). A "detent"
indicates "equalized" treble. Press the button
back in when you have made the adjustment.
Fader - Balance front/rear
Adjust front/rear speaker balance by pressing
the button to extend the control and turning it
to the left (more sound from the rear speakers)
or to the right (more sound from the front
speakers). A "detent" indicates "equalized"
balance. Press the button back in when you
have made the adjustment.
Balance right/left
Adjust left/right speaker balance by pressing
the button to extend the control, and turning itto the left (more sound from the left speakers)
or to the right (more sound from the right
speakers). A "detent" indicates "equalized"
balance. Press the button back in when you
have made the adjustment.
MID EQ level
This function is used to fine-tune the balance
of sound in the speakers. To set the level:
1.
PressSOURCE.
2.
Turn the SOURCE knob, select
ADVANCED MENU
and press SOURCE.
3.
Turn the SOURCE knob, select
AUDIO
SETTINGS
and press SOURCE.
4.
Turn the SOURCE knob, select
MID EQ
LEVEL
and press SOURCE.
5.
Turn the SOURCE knob, select the desired
level and press SOURCE.
6.
PressEXIT.