start stop button VOLVO S60 2009 Owner´s Manual

02 Instruments and controlsIndicator and warning symbols
0252
Warning symbol in the center of the
instrument panel
This symbol shines as a red or yel-
low light depending on the severity
of the discovered fault.
Red symbol - Stop the vehicle as soon as pos-
sible in a suitable location and read the mes-
sage shown in the text window. The symbol
and accompanying text will remain on until the
fault has been corrected.
Yellow symbol - Follow the instructions shown
in the text window. The text can be erased by
pressing the READ button, see page 71, or
will disappear automatically after two minutes.
When the message "
TIME FOR REGULAR
SERVICE
" is displayed, the text can be erased
and the yellow symbol light can be turned off
by pressing the READ button. The text will dis-
appear and the symbol light will go out auto-
matically after two minutes.
Symbols in the instrument panel
G027134
The indicator and warning symbols
1 light up
when you turn the ignition key to the driving
position (position II) before starting. This shows
that the symbols are functioning. When the
engine starts, all symbols go out. If the engine
is not started within 5 seconds, all symbols
exceptCHECK ENGINE and
go
out. Certain symbols may not have their func-
tions illustrated, depending on the vehicle's
equipment. The symbol for the parking brake
goes out when the parking brake is released.
Seat belt reminder
This symbol lights up to indicate
that the driver has not fastened his/
her seat belt.
Supplemental Restraint System SRS
If this light comes on while the
vehicle is being driven, or remains
on for longer than approximately
10 seconds after the vehicle has
been started, the SRS system's
diagnostic functions have detected a fault in a
seat belt lock or pretensioner, a front airbag,
side impact airbag, and/or an inflatable curtain.
Have the system(s) inspected by a trained and
qualified Volvo service technician as soon as
possible.
BRAKE - Brake failure warning lightIf the light comes on while driving or braking,
stop immediately, open the hood and check
the brake fluid level in the reservoir, see
page 193.
Canadian models are equipped
with this warning light.
1On certain engines, the symbol for low oil pressure is not used. Instead, a text warning is provided in the information display.

10 Audio
Radio functions HU-650/HU-850
10``221 Selecting a sound source
The sound source (e.g. AM,
FM, etc.) can be selected in two
ways:
•
Use the sound source buttons (see the
center illustration above).
•
Turn the SOURCE knob (see illustration) to
select a sound source (AM1, AM2, FM1,
FM2, FM3, or CD). Press the knob to select
theAM or FMband of your choice.
The sound source selected will be shown in the
display.
Scan
Press the SCAN button to start
the station scan function. When
a station is found, scanning
stops for approximately 10 sec-
onds, after which scanning will
continue.
Press the SCAN or SOURCE button when a
station has been found if you would like to lis-
ten to that station and to discontinue the scan
function.
Station seek up/downPress
or
to start the seek func-
tion. The radio seeks the next audible station
and tunes it in. Repeat the procedure to con-
tinue the seek function.
Manual station searchPress
or
and hold it down.
MAN will be shown in the display. The radio
scans slowly in the selected direction and will
increase the scanning speed after a few sec-
onds. Release the button when the desired
frequency appears in the display.
The frequency can be fine-tuned by short
presses on the or
keys.
The system will remain in manual search mode
for 5 seconds after the button is released, after
which it will return to seek mode.
Steering wheel key pad (option)
G027901
If the vehicle is equipped with the key pad in
the steering wheel press the right or left arrow
to switch between preset stations.

10 AudioHU-650 - CD player
10226
Starting the CD playerPlease refer to the illustration on page 217 for
the location of the buttons referred to on this
page.
1. Insert a disc into the player.
2.
Press the CD button or turn the SOURCE
knob to CD.Changing tracksBriefly press the
or
keys (or the
corresponding keys on the steering wheel key-
pad) to skip to the previous or next track. The
track number is shown in the display.
Fast forward/backPress and hold down the
or
keys
to search within a track or the entire disc. The
search continues for as long as the buttons are
held in.
NOTE
The corresponding keys on the steering
wheel keypad cannot be used for fast for-
ward/back.Random playThis function plays the tracks on a CD in ran-
dom order (shuffle).1.
Select CD mode and press the RND but-
ton.
RND
is shown in the display as long
as the function is activated.
2.
PressRND again to stop random play.
ScanThis function plays the first 10 seconds of each
track on the CD.
1.
PressSCAN to start the function.
2.
PressSCAN again or EXIT to stop the scan
function and listen to an entire track.CD ejectPress the button (no. 6 in the illustration on
page 218) to eject the disc.
NOTE
•
For reasons of traffic safety, the ejected
CD must be removed within 12 seconds
or it will be automatically drawn back
into the slot and the CD player will
resume playing the most recently
selected track.
•
See page 216 for information on caring
for compact discs.

10 Audio
HU-850 - internal CD changer
10
227
Starting the CD changerThe HU-850 is equipped with an internal, 6-
disc CD changer.
Please refer to the illustration on page 218 for
the location of the buttons referred to on this
page.To load discs into the changer:1.
Press the CD button or turn the SOURCE
knob to CD.
2. Select an empty position by pressing one
of the preset buttons. The display shows
which positions are empty.
LOAD DISC
must be displayed before a disc is inserted
into the player.
3. Insert a disc.
If there are discs in the player when CD mode
is selected, the changer will resume playing the
disc and track that were most recently played.
Selecting a disc position (number)Use the station setting buttons 1-6 to select the
disc to be played. The number of the disc and
the track being played are shown in the display.Changing tracksBriefly press the
or
keys (or the
corresponding keys on the steering wheel key-
pad) to skip to the previous or next track. The
track number is shown in the display.
Fast forward/backPress and hold down the
or
keys
to search within a track or the entire disc. The
search continues for as long as the buttons are
held in.
The corresponding keys on the steering wheel
keypad cannot be used for fast forward/back.
Random playThis function plays the tracks on a CD in ran-
dom order (shuffle).•
SelectCD mode and press the RND but-
ton.
RND
is shown in the display as long
as the function is activated. Random tracks
from randomly selected discs will be
played.
•
PressRND again to stop random play.
ScanThis function plays the first 10 seconds of each
track on the CD.
1.
PressSCAN to start the function.
2.
PressSCAN again or EXIT to stop the scan
function and listen to an entire track.
Scan only works on the selected disc.CD ejectThis function makes it possible to eject a single
disc, or to eject all of the discs in the changer.
•
Press the eject button briefly to eject the
disc that is currently playing.
•
A longer press (more than 2 seconds)
starts the process of ejecting all of the
discs in the changer.NOTE
The
EJECT ALL
function can only be used
while the vehicle is at a standstill and will be
cancelled if the vehicle begins to move.
For reasons of traffic safety, you have
12 seconds in which to remove the ejected
disc. After that, the disc automatically rein-
serts into the player, and the CD player will
resume playing the most recently selected
track.
See page 216 for information on caring for
compact discs.

10 AudioExternal CD changer (option)
10228
G027181
The optional 10-CD changer is mounted in the
cargo compartment.
Please refer to the illustrations on pages 217
and 218 for the location of the buttons referred
to on this page.
Turn the SOURCE knob to select the external
CD changer.To load discs into the changer:1. Slide the cover on the CD change open.
2. Press the eject button on the CD changer.
3. Pull the magazine out of the changer and
insert the disc(s).
4. Press the magazine back into the changer
and slide the cover back into place.If there are discs in the player when CD mode
is selected, the changer will resume playing the
disc and track that were most recently played.
Selecting a disc position (number)Use the station setting buttons 1 – 6 to select
the disc to be played. Continue to press button
6 to select discs 7 – 10.
The number of the disc and the track being
played are shown in the display.Changing tracksBriefly press the
or
keys (or the
corresponding keys on the steering wheel key-
pad) to skip to the previous or next track. The
track number is shown in the display.
Fast forward/backPress and hold down the
or
keys
to search within a track or the entire disc. The
search continues for as long as the buttons are
held in.
The corresponding keys on the steering wheel
keypad cannot be used for fast forward/back.
Random playThis function plays the tracks on a CD in ran-
dom order (shuffle).
1.
SelectCD mode and press the RND but-
ton.
RND
is shown in the display as longas the function is activated. Random tracks
from randomly selected discs will be
played.
2.
PressRND again to stop random play.
ScanThis function plays the first 10 seconds of each
track on the CD.
1.
PressSCAN to start the function.
2.
PressSCAN or EXIT to stop the scan func-
tion and listen to an entire track.
Scan only works on the selected disc.