lock YAMAHA DT125R 2000 User Guide

6-34
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
93.Remove the headlight connector
and the bulb holder cover.4.Turn the bulb holder counter-
clockwise to remove it and then
remove the defective bulb.
EW000119
wKeep flammable products and your
hands away from a bulb while it is
on, as it is hot. Do not touch a bulb
until it cools down.5.Put a new bulb into position and
secure it in place with the bulb
holder.
12
1.Bulb holder cover
2.Connector
1
1.Bulb holder
6.Install the bulb holder cover, con-
nector and headlight unit.
7.Install the cowling.
8.If the headlight beam adjustment
is necessary, ask a Yamaha
dealer to make that adjustment.
3MB-9-E7 12/27/00 2:52 PM Page 70

6-35
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
1
2
3
1
2
3
1.Screw (´2)
2.Lens
3.Bulb 1.Screw
2.Lens
3.Bulb
EAU01095
Turn signal light bulb
replacement1.Remove the screw and the lens.
2.Remove the defective bulb by
pushing it inward and turning it
counterclockwise.
3.Install a new bulb by pushing it
inward and turning it clockwise.
4.Install the lens and tighten the
screw.
EAU01623*
Tail/brake light bulb
replacement1.Remove the screws and the
lens.
2.Remove the defective bulb by
pushing it inward and turning it
counterclockwise.
3.Install a new bulb by pushing it
inward and turning it clockwise.
4.Install the lens and tighten the
screws.
EC000108
cCDo not over-tighten the screws as
the lens may break.
3MB-9-E7 12/27/00 2:52 PM Page 71

6-41
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
4. Engine overheating
EW000070
wDo not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may be
blown out under pressure, which could cause serious injury. Open the radiator cap as follows. Wait until the
engine has cooled. Remove the radiator cap stopper by removing the screw. Place a thick rag like a towel over
the radiator cap and slowly rotate the cap counterclockwise to the detent. This procedure allows any residual
pressure to escape. When the hissing sound has stopped, press down on the cap while turning counterclock-
wise and remove it.Wait until the
Check the coolant level in the
Level is OK.Level is low, check the
NoLeakage.
Ask a Yamaha dealer to inspectAdd coolant. (See NOTE.)
Restart the engine. If the engine overheats again, ask a
engine has cooled.reservoir tank and/or radiator.cooling system for leakage.
Yamaha dealer to inspect and repair the cooling system. leakage.
and repair the cooling system.
NOTE:
If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that it is changed to the rec-
ommended coolant as soon as possible.
3MB-9-E7 12/27/00 2:52 PM Page 77