ECU YAMAHA VX 2009 Owner's Manual

Maintenance and care
71
To install a spark plug:
(1) Clean the gasket surface.
(2) Wipe any dirt from the threads of the
spark plug.
(3) Install the spark plug, and then tighten it
to the specified torque.
(4) Wipe off any water on the spark plug or
inside the spark plug cap, and then install
the cap. Push the spark plug cap down
until it is securely installed.
TIP:
If a torque wrench is not available when you
are installing a spark plug, a good estimate of
the correct torque is 1/4 turn to 1/2 turn past
finger tight using the spark plug wrench in-
cluded in the tool kit. Have the spark plug ad-
justed to the correct torque with a torque
wrench as soon as possible.
(5) Install the seat.
EJU34422Lubrication points
To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.

Throttle cable (handlebar end)
Loosen the adjuster and disconnect the
outer cable from the bracket. Spray a rust
inhibitor into the outer cable. Connect the
outer cable, and then adjust the throttle ca-ble free play. (See page 69 for adjustment
procedures.)

Steering cable (handlebar end)

Steering cable (jet thrust nozzle end) Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Spark plug tightening torque:
12.5 Nm (1.27 kgf-m, 9.2 ft-lb)
Recommended water-resistant grease:
Yamaha Marine Grease/Yamaha
Grease A
1Adjuster
UF2L70E0.book Page 71 Thursday, June 19, 2008 8:38 AM

Maintenance and care
72

For VX Deluxe/VX Cruiser:
Shift cable (reverse gate end)
EJU34452Checking the battery
Check the level of the battery electrolyte and
make sure that the negative (–) and positive
(+) battery leads are tightened securely.
WARNING
EWJ00791
Battery electrolyte is poisonous and dan-
gerous, causing severe burns, etc. Elec-
trolyte contains sulfuric acid. Avoid
contact with skin, eyes, or clothing.
Antidotes
External: Flush with water.
Internal: Drink large quantities of water or
milk. Follow with milk of magnesia, beaten
egg, or vegetable oil. Call a physician im-
mediately.
Eyes: Flush with water for 15 minutes and
get prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flames, cigarettes, etc., well away.
If using or charging the battery in an en-
closed space, make sure that it is well ven-
tilated. Always shield your eyes when
working near batteries.
Keep out of the reach of children.
To remove the battery:
Disconnect the negative (–) battery lead first,
then the positive (+) battery lead and breatherhose, and then remove the battery from the
watercraft.
To replenish the battery:
(1) Make sure that the electrolyte level is be-
tween the maximum and minimum level
marks.
(2) If the electrolyte level is low, add distilled
water to raise it to the specified level.
NOTICE: Use only distilled water for
replenishing the battery, otherwise
battery life could be shortened.
[ECJ00241]
To recharge the battery:
NOTICE
ECJ00250
Do not attempt to charge a battery hastily.
Battery life could be shortened.
It is recommended to have a Yamaha dealer
charge the battery. If you charge the battery
yourself, be sure to read and follow the in-
structions provided with the battery tester and
charger you use.
To install the battery:
(1) Place the battery in the battery compart-
ment. Connect the red lead to the positive
(+) battery terminal, and then connect the
black lead to the negative (–) battery ter-
minal. NOTICE: Reversal of the battery
leads will damage the electrical parts.
[ECJ00261]
1Maximum level mark
2Minimum level mark
UF2L70E0.book Page 72 Thursday, June 19, 2008 8:38 AM

Maintenance and care
73
(2) Connect the breather hose to the battery.
(3) Secure the battery in place. WARNING!
Fire or explosion could result if the
breather hose is damaged, obstruct-
ed, or not connected properly.
[EWJ00451]
EJU34491
Fuel injection system
If the fuel injection system is malfunctioning,
have a Yamaha dealer service the watercraft.
EJU34500Checking the trolling speed
(1) Place the watercraft in the water.
(2) Start the engine and warm it up. Use the
tachometer in the multifunction informa-
tion center to check the trolling speed.
If the trolling speed is out of specification,
have a Yamaha dealer service the watercraft.
1Positive (+) battery terminal: Red lead
2Negative (–) battery terminal: Black lead
3Breather hose
Trolling speed:
1650 ±50 r/min
UF2L70E0.book Page 73 Thursday, June 19, 2008 8:38 AM

Trouble recovery
80
system damage and possible fire.
[EWJ00801]EJU34711Towing the watercraft
WARNING
EWJ00811

The operator of the towing boat must
keep speed to a minimum and avoid traf-
fic or obstacles which could be a hazard
to the operator on the watercraft.

The towline should be long enough so
that the watercraft will not collide with
the towing boat when slowing down.
If the watercraft becomes inoperative in the
water, it can be towed to shore.
When the watercraft is towed using a towline,
the operator should hold onto the handlebars
and ride the watercraft in order to balance it.
Use a towline that is three times the combined
length of the towing boat and the watercraft.
Tow the watercraft at 5 mph (8 km/h) or less.
The bow must be kept up out of the water dur-
ing towing to prevent water from entering the
engine compartment.
EJU36151Submerged watercraft
If the watercraft is submerged or flooded with
water, follow the procedure below and consult
a Yamaha dealer as soon as possible. Failure
to do so could result in serious engine dam-
age.
(1) Beach the watercraft and remove the
stern drain plugs to drain the water from
1Electrical box
2Cap
3Fuse
4Spare fuse
1Fuse puller
Fuse amperage:
Battery fuse:
30 A
Main relay drive fuse:
10 A
Electronic throttle valve fuse:
10 A
Security system fuse:
3 A
Main fuse:
20 A1Bow eye
UF2L70E0.book Page 80 Thursday, June 19, 2008 8:38 AM

Index
Operation of controls and other
functions ............................................... 23
Operation requirements ........................... 11
Owner’s/operator’s manual and tool kit .... 64
P
Periodic maintenance chart...................... 66
Post-operation care .................................. 60
Pre-operation check list............................ 40
Pre-operation check points ...................... 42
Pre-operation checks ............................... 40
Primary Identification (PRI-ID) number ...... 1
R
Reboarding step (for VX Cruiser) ............. 28
Recommended equipment ....................... 13
Remote control transmitter
(for VX Deluxe/VX Cruiser) ................... 24
Reverse on waterways
(for VX Deluxe/VX Cruiser) ................... 59
Riding with passengers ............................ 52
S
Safe boating rules .................................... 17
Seat .......................................................... 23
“SECURITY” indicator light
(for VX Deluxe/VX Cruiser) ................... 34
Selecting the operation mode
(for VX Deluxe/VX Cruiser) ................... 30
Shift cable, checking
(for VX Deluxe/VX Cruiser) ................... 69
Shift lever and reverse gate
(for VX Deluxe/VX Cruiser) ................... 45
Shift lever (for VX Deluxe/VX Cruiser) ..... 27
Shifting (for VX Deluxe/VX Cruiser) ......... 50
Spark plugs, cleaning and adjusting ........ 70
Speedometer............................................ 31
Start switch............................................... 26
Starting the engine ................................... 48
Starting the watercraft .............................. 52
Steering system ................................. 27, 45
Stern drain plugs ...................................... 44
Stern eyes ................................................ 28
Stopping the engine ................................. 49
Stopping the watercraft ............................ 58
Storage..................................................... 62
Storage compartments ............................. 35
Submerged watercraft .............................. 80Switches ................................................... 46
T
Tachometer .............................................. 31
Throttle cable, checking and adjusting ..... 69
Throttle lever ...................................... 26, 45
Towing the watercraft ............................... 80
Transporting ............................................. 61
Trolling speed, checking .......................... 73
Troubleshooting ....................................... 75
Troubleshooting chart .............................. 75
Turning the watercraft .............................. 57
W
Water separator ....................................... 43
Watercraft characteristics ......................... 14
Water-skiing ............................................. 16
Y
Yamaha Engine Management System
(YEMS) ................................................. 28
Yamaha Security System
(for VX Deluxe/VX Cruiser) ................... 29
Yamaha Security System settings
(for VX Deluxe/VX Cruiser) ................... 29
UF2L70E0.book Page 2 Thursday, June 19, 2008 8:38 AM