sensor YAMAHA YZF-R7 1999 Owner's Manual

8 - 29
–+ELECELECTRONIC FUEL INJECTION SYSTEM
1Main switch
5Battery
6Main fuse
CCamshaft sensor
DThrottle position sensor
EIntake air pressure sensor
FAtmospheric pressure sensor
GIntake air temperature sensor
HCoolant temperature sensor
IPickup coil
JECU
KCylinder #1-injector 1
LCylinder #2-injector 1
MCylinder #3-injector 1
NCylinder #4-injector 1
OCylinder #1-injector 2
PCylinder #2-injector 2
QCylinder #3-injector 2
RCylinder #4-injector 2
XFall detection switch
YSpeed sensor
yFuel pump
zMain relay
}Engine stop switch
ŒElectronic fuel injection system fuse
£ECU fuse
TROUBLESHOOTING
NOTE:
• Before troubleshooting, remove the following part(-s):
1) bottom cowling
2) front cowling
• Troubleshoot with the following special tool(-s).
The condition code is displayed by the tachometer.
Check the condition code list to
identify the faulty part. Refer to
“ELECTRICAL CONTROL SYS-
TEM”.
In diagnosis mode, select the
appropriate diagnosis code to
check the operation of the faulty
part.Check the
wiring.Replace.
Co, diagnosis switch box
90890-03171
Test coupler adapter
90890-03149
Out of specifi-
cationNo good

8 - 31
–+ELECELECTRICAL CONTROL SYSTEM
Tachometer display sequence (engine not running)
110,000 r/min for 2.0 seconds
2First condition code (13 = intake air pressure sensor)
3Second condition code (42 = speed sensor)
41st digit of condition code for 1.0 second
510,000 r/min for 0.5 second
62nd digit of condition code for 1.0 second
510Time
(seconds) 5
0 10 Revolution
(´10
3r/min)
46
5
1246
511 3Repeat
Main switch is turnd on

8 - 32
–+ELECELECTRICAL CONTROL SYSTEM
Condition code list
NOTE:
* This condition code is also displayed in the following cases:
- when the starter switch is held down for more than 4 seconds, causing the warning
light to flash
- when the ignition circuit cut-off system stops the engine or prevents it from starting
** This condition code is also displayed when the engine is operated at 5,000 r/min for at
least 30 seconds with the rear wheel at standstill.
*** This condition code is also displayed when the engine stop switch is turned to “ ”
while riding with the transmission in gear. Condition
codeCircuit Defect(s) System response
11 Camshaft sensor • No incoming sig-
nalThe ECU pairs the ignition of cyl-
inders #1 and #4 and cylinders #2
and #3. The motorcycle can be
ridden.
12* Pickup coil • No incoming sig-
nalThe motorcycle cannot be ridden.
13 Intake air pressure
sensor• Disconnected
• Short-circuitThe ECU stays set to an intake air
pressure of 760 mm Hg (29.9 in Hg).
The motorcycle can be ridden.
14 Intake air pressure
sensor hose and
negative pressure
hose• Improper connec-
tion
• Bending
15 Throttle position
sensor• Disconnected
• Short-circuitThe ECU stays set to a wide throt-
tle opening.
The motorcycle can be ridden.
16 Throttle position
sensor• Locked
21 Coolant tempera-
ture sensor• Disconnected
• Short-circuitThe ECU stays set to a coolant
temperature of 80˚C (176˚F).
The motorcycle can be ridden.
22 Intake air tempera-
ture sensor• Disconnected
• Short-circuitThe ECU stays set to an intake air
temperature of 40˚C (104˚F).
The motorcycle can be ridden.
23 Atmospheric pres-
sure sensor• Disconnected
• Short-circuitThe ECU stays set to an atmo-
spheric pressure of 760 mm Hg
(29.9 in Hg).
The motorcycle can be ridden.
41 Fall detection
switch• Disconnected The main relay stays switched off.
The motorcycle cannot be ridden.
42** Speed sensor • Incorrect signal The ECU stays set to 6th gear.
The motorcycle can be ridden.
43*** Monitored voltage • Incorrect The ECU stays set to a monitored
voltage of 12 V.
The motorcycle can be ridden.
44 ROM operation • CO emission
adjustment errorThe CO emission adjustment is
set to 0.

8 - 36
–+ELECELECTRICAL CONTROL SYSTEM
Diagnosis code list
Diagnosis
codeInspected item System responseTachometer display
(0 ~ 10,000 r/min)
00 — — —
01 Voltage The tachometer displays the volt-
age ´ 500.
Example:
If the voltage is 12.5 V, the tachome-
ter displays 12.5 ´ 500 = 6,250 r/min.0 r/min (0 V) –
10,000 r/min (20 V)
02 Atmospheric
pressureThe tachometer displays the atmo-
spheric pressure sensor signal.
Example:
If the atmospheric pressure is 760
mm Hg (29.9 in Hg), the tachometer
displays 8,000 r/min.
03 Intake air pres-
sureThe tachometer displays the differ-
ence between the minimum intake
air pressure sensor signal and the
atmospheric pressure sensor signal
after the main switch is turned to
“ON” in the diagnosis mode.0 r/min (0 mm Hg)
– 1,000 r/min
(100 mm Hg)
04 Throttle position
sensorThe tachometer displays the throttle
position sensor signal.1,300 r/min (0.68 V) –
5,900 r/min (2.93 V)
05 Throttle position
sensorThe tachometer displays the mini-
mum throttle position sensor signal.5,500 r/min (0.68 V) –
10,000 r/min (1.25 V)
06 Intake air temper-
atureThe tachometer displays the intake
air temperature signal.4,800 r/min (20˚C) –
5,700 r/min (30˚C)
07 Coolant tempera-
tureThe tachometer displays the coolant
temperature sensor signal.4,900 r/min (20˚C) –
9,200 r/min (100˚C)
08 Speed sensor The tachometer displays the speed
sensor signal when the rear wheel is
rotated by hand.0 –
09 Fall detection
switchThe tachometer displays whether
the fall detection switch is on or
whether it is off or disconnected.0 r/min (on), 8,000 r/
min (off) or 10,000 r/
min (disconnected)
10 Sidestand switch The tachometer displays whether
the sidestand switch is on or off.
The tachometer displays 0 r/min
when the sidestand is down (switch
on) and 10,000 r/min when the side-
stand is up (switch off).0 r/min (on) or
10,000 r/min (off)
11 — — —

8 - 38
–+ELECELECTRICAL CONTROL SYSTEM
17 Injector 1 for cyl-
inder #1CO, diagnosis switch box method
Before selecting a code, discon-
nect the fuel pump coupler from
the wire harness.
Within one second after the
MODE switch is released, the
main relay is turned on, and the
selected injector is operated once
every second for the next five
seconds. During this time, the
warning light lights up for 0.5
second once every second.
Test coupler adapter method
Within one second after the
engine stop switch is turned to
“ ”, the selected injector is
operated for once every second
for the next five seconds. During
this time, the warning light lights
up for 0.5 second once every sec-
ond. 18 Injector 1 for cyl-
inder #2
19 Injector 1 for cyl-
inder #3
20 Injector 1 for cyl-
inder #4
21 Injector 2 for cyl-
inder #1
22 Injector 2 for cyl-
inder #2
23 Injector 2 for cyl-
inder #3
24 Injector 2 for cyl-
inder #4
25 ~ 28 — — —
29 Condition code
record of mal-
functionsThe condition code of any fixed mal-
function is recorded in the ROM and
displayed by the tachometer. Refer
to the condition code list in “USER
MODE” for details on the condition
codes.Condition codes 11
– 44
30 ROM (Clearing
the condition
code record)Selecting this diagnosis code clears
the condition code record of mal-
functions stored in the ROM.
If an error has occurred in a sensor
signal, it was recorded in the ROM
and the tachometer displays 10,000
r/min. If no error has occurred, the
tachometer displays 0 r/min.
CO, diagnosis switch box method
Press the UP switch eight times
within four seconds to clear the con-
dition code record from the ROM.
Test coupler adapter method
Remove the rear cowling.
Disconnect the relay unit coupler
from the relay unit.
Press the start switch ten times
within four seconds to clear the con-
dition code record from the ROM.0 r/min (no error) or
10,000 r/min (errors)
When the error
record is cleared, 0
r/min is displayed.
31 ROM program
versionThe version number of the ROM pro-
gram is displayed in the tachometer. Diagnosis
codeInspected item System responseTachometer display
(0 ~ 10,000 r/min)

YZF-R7 WIRING DIAGRAM
1
Main switch

2
Rectifier/regulator

3
Generator

4
Backup fuse (odometer)

5
Battery

6
Main fuse

7
Starter relay

8
Starter motor

9
Diode

0
Relay unit

A
Diode

B
Sidestand switch

C
Camshaft sensor

D
Throttle position sensor

E
Intake air pressure sensor

F
Atmospheric pressure sensor

G
Intake air temperature sensor

H
Coolant temperature sensor

I
Pickup coil

J
ECU

K
Cylinder #1 - injector 1

L
Cylinder #2 - injector 1

M
Cylinder #3 - injector 1

N
Cylinder #4 - injector 1

O
Cylinder #1 - injector 2

P
Cylinder #2 - injector 2

Q
Cylinder #3 - injector 2

R
Cylinder #4 - injector 2

S
Cylinder #1 - ignition coil

T
Cylinder #2 - ignition coil

U
Cylinder #3 - ignition coil

V
Cylinder #4 - ignition coil

W
CDI unit

X
Fall detection switch

Y
Speed sensor

Z
Neutral switch

[
Meter assembly

\
Fuel level indicator light

]
Warning light (oil level indicator)

^
Neutral indicator light

a
Tachometer

b
Combination meter

c
Warning light (coolant temperature indicator)
d
High beam indicator light
e
Turn signal indicator light
f
Meter light
gWarning light (engine trouble indicator)
hOil level switch
i
Horn
jHeadlight
kRear turn signal light (right)
lRear turn signal light (left)
mFront turn signal light (right)
nFront turn signal light (left)
oTail/brake light
pRear brake light switch
q
Left handlebar switch
rClutch switch
sLights switch
t
Pass switch
uDimmer switch
vTurn signal switch
wHorn switch
xTurn signal relay
yFuel pump
zMain relay
{
Right handlebar switch|Front brake light switch
}Engine stop switch
~Start switch
Œ
Electronic fuel injection system fuseCYCLELOCK Signaling system fuse
¢Headlight fuse£
ECU fuse¤Radiator fan motor fuse
¥Thermo switch
¦Radiator fan motor
COLOR CODE
B ............ black
Br ........... brown
Ch .......... chocolate
Dg .......... dark green
G ............ green
Gy .......... gray
L ............ blue
Lg .......... light green
O ............ orange
P ............ pink
R ............ red
Sb .......... sky blue
W ........... white
Y ............ yellow
B/L ......... black/blue
B/R ......... black/red
B/W ....... black/white
B/Y ......... black/yellow
Br/G ....... brown/green
Br/L ........ brown/blue
Br/R ....... brown/red
Br/W ...... brown/white
G/B ........ green/black
G/R ........ green/red
G/W ....... green/white
G/Y ........ green/yellow
Gy/B ...... gray/black
Gy/G ...... gray/green
Gy/R ...... gray/red
L/B ......... blue/black
L/G ......... blue/green
L/R ......... blue/red
L/W ........ blue/white
L/Y ......... blue/yellow
Lg/R ....... light green/red
Lg/Y ....... light green/yellow
O/B ........ orange/black
O/G ........ orange/green
P/B ......... pink/black
P/L ......... pink/blue
P/W ........ pink/white
R/B ......... red/black
R/G ........ red/green
R/L ......... red/blue
R/W ....... red/white
R/Y ......... red/yellow
W/B ....... white/black
W/G ....... white/green
W/L ........ white/blue
W/Y ....... white/yellow
Y/B ......... yellow/black
Y/G ........ yellow/green
Y/L ......... yellow/blue
Y/R ......... yellow/rod