jack points ARIEL ATOM 2 2006 Owners Manual

iii

TABLE OF CONTENTS
Non-Liability of Manufacturer.................................................................................................... 1
Using This Manual.................................. .................................................................................... 2
Specification Overview ............................. ................................................................................. 3
Vehicle Layout ..................................... ....................................................................................... 4
Dash Layout........................................ ........................................................................................ 5
Safety Harnesses ................................... ................................................................................. 6-7
On-board Extinguisher System ....................... .......................................................................... 8
Start Sequence ..................................... ...................................................................................... 9
Shift Patterns ..................................... ......................................................................................... 10
Vehicle Run-in Procedures .......................... .............................................................................. 11
Brake Bedding Procedures ........................... ............................................................................ 12
Jack Points ........................................ ......................................................................................... 13
Jacking up the Car ................................. .................................................................................... 14
Tie Down Points for Transporting Your Ariel Atom ... .............................................................. 15
Brake Packages..................................... ................................................................................ 16-20
Parking Brake Adjustments.......................... ........................................................................ 21-22
Tire & Wheel Maintenance ........................... .............................................................................. 23
Wheels ............................................. ........................................................................................... 24
Drivetrains ........................................ ..................................................................................... 25-28
Engine Mount Specifications ........................ ............................................................................ 29
Electrical Specifications .......................... .................................................................................. 30
Fuse Panels ........................................ ................................................................................... 31-34

13

JACK POINTS

At the front of the vehicle, the mounting point wher e the front of the lower A-arm attaches to the frame is the
preferred jacking point. At the rear of the vehicle , the lower horizontal tube is the preferred jacking point.

21

PARKING BRAKE ADJUSTMENT


There are two adjustment points on your vehicle’s par king brake assembly, the parking brake actuator and th e
cable slack. Refer to the photos on the following page . To adjust the assembly:

1. Place chocks or blocks in front and in back of the fr ont wheels to prevent the car from rolling.
2. Place the parking brake handle in the forward-most position and put the car in neutral.
3. Jack up the rear of your Atom until the rear whee ls are clear of the ground.
4. Place safety stands under the car.
5. Ensure that the car is stable.
6. Make sure that there is a little slack in the cables where they exit their covers at the rear of the car near
the rear axle.
7. Take a 1/4 in. Allen wrench and turn the internal hex bolt in the center of the large end of the parking
brake application lever clockwise until the wheel cannot be turned by hand. (Track & Race package.)
8. Turn the Allen bolt counter-clockwise about 1/16 of a turn. At this point the parking brake is initialized
and the cables can be adjusted.
9. Loosen the locknut on the cable housings with a 9/16 in. wrench and screw the adjuster barrel counter-
clockwise until there is less than 1/2 in. of vertical sla ck in the cable.
10. Tighten the locknut while holding the cable housi ng stable with a 1/2 in. wrench.