fuel ASTON MARTIN DB AR1 Q 2003 Owners Guide

F - Owner Maintenance
1-F-5
Dangerous Substances
WARNING: Many liquids and other substances used in motor vehicles are
poisonous and should under no circumstances be consumed and should, so far
as possible, be kept from contact with the skin. These substances include battery
electrolyte, antifreeze, oil, brake and clutch fluid, petrol, windscreen washer
additives, lubricants, refrigerant and various adhesives. Particular care should
be taken to avoid unnecessary contact with used engine oil. Always read carefully
the instructions printed on labels or stamped on components and follow them
carefully. Such instructions are included for reasons of your health and personal
safety. Never disregard them. Dangerous substances should be kept out of reach
of children.
Engine Oils
WARNING: Prolonged and repeated contact with used engine oils can cause
serious skin disorders, including dermatitis and cancer. Avoid excessive contact,
wash thoroughly after contact. Keep out of reach of children. When your oil is
changed, be sure that it is done by an experienced person. In addition, observe
all laws regarding the disposal of waste oil and toxic fluids.
Protect The Environment
WARNING: It is illegal to pollute drains, water courses, or soil. Use authorised
waste disposal facilities, including civic amenity sites and garages providing
facilities for receipt of used oil. If in doubt, contact your local authority for advice.
Fuel Tank Filling
WARNING: Petrol is highly flammable and, in confined spaces, is also explosive
and toxic. In the event of spillage, switch off the engine, use no naked flame or
light. Do not smoke. Do not inhale fumes.

F - Owner Maintenance
1-F-41 Boot Fusebox
F1 10A Reverse Light Relay
F2 20A Security System & Tilt Sensors
F3 5A +12V Ignition
F4 5A Boot Switch Logic Relay, Security System Control Unit
F5 30A Accessory Terminal
F6 5A RH Fog Lamp, Powertrain Control Modules
F7 20A Fuel Pump 2, Secondary Powertrain Control Module
F8 10A HM Stop Light, LH Stop Light
F9 10A Boot Lamps, Radio Aerial Motor
F10 10A Accessory Socket
F11 20A Not Used
F12 20A Not Used
F13 10A Airbag Control Unit
F14 30A Not Used
F15 20A Fuel Pump 1, Primary Powertrain Control Module
F16 10A Rear Fog Light Relay
F17 10A Manual Gearbox Cooling Pump
F18 10A Accessory Terminal
F19 10A RH Tail, Side, Side Marker and
Number Plate Lamps
F20 20A Premium ICE Amplifier
F21 10A LH Tail, Side, Side Marker and
Number Plate Lamps
F22 20A Manual - Exhaust By-pass System
Automatic - Not Used

F - Owner Maintenance
1-F-45
On Board Headlight Aiming (where fitted)
The headlight assemblies (main and dipped beam lights) are factory set to
give correct forward illumination under average load conditions. Should
your headlight aiming require adjustment, it may be corrected as follows:
1. Ensure that the tyres are inflated to the specified pressures.
2. Fill the car with fuel.
3. Park the car on level ground.
NOTE: Any error in ground level will adversely influence the accuracy of the
vertical beam alignment check
4. Have an adult person sit in the drivers seat.
5. Load the boot with the normal items you carry.
6. Open the bonnet.
Horizontal Beam Alignment Check
1. Check the gauge labelled Horizontal Angle Gauge. The green line on the
collar must be aligned with the pointer at the side of the spirit level. If
adjustment is required, rotate the screw and collar until the green line
is aligned with the pointer.

F - Owner Maintenance
1-F-59 When returning the car to normal service, set the tyre pressures to normal
specification before driving on the road.
Extended Storage
For storage periods exceeding six months the following additional measures
are recommended;
Run the car until there is as small a quantity of fuel in the tank as is practical
for storage purposes.
Caution: Do Not Drain The Fuel System
Add Engine Oil to the remaining fuel in the tank to ensure a concentration
of 2% (i.e. 20ml per 1 litre of fuel) and then run the engine for not less than
ten minutes to circulate the mixture thoroughly through the entire fuel
system.
Inspect the rubber connections of the cooling system and have them
renewed if necessary.
Wash the bodywork of the car thoroughly and repair any paint
blisters or patches of rust in order to prevent any further deterioration.
Apply a suitable polish.
Clean the carpets and upholstery thoroughly. Dust them with an
anti-moth powder and store in a dry place. Treat all leather upholstery
with an appropriate leather conditioner.
If the storage building is dry leave the car windows slightly open. If
there is any tendency towards dampness close the car doors and
windows and place an anti-moisture compound such as Silica desiccant
bags in an open metal container inside the car.
Cover the car with it's fabric cover.

F - Owner Maintenance
1-F-60
Recommissioning After Storage
Provided that the car has been stored in accordance with the recommended
procedure, the following points only should require attention before using
the car on the road.
Check the tyre pressures, inflate if necessary and lower the car to the ground.
Fully charge and refit the battery. Reset the clock and electric windows.
Drain the engine sump and final drive unit, fit a new engine oil filter element,
then refill with the approved oils. Check the coolant level and if necessary
top up with the correct antifreeze/water solution.
Check all fluid levels and top-up as necessary. Fill the fuel tank
Caution: Starting the engine without sufficient lubrication can cause serious engine
damage. Take care to establish engine oil pressure as directed in the following steps
before allowing the engine to start.
Press and hold the accelerator hard to the floor (kickdown switch actuated).
This will temporarily inhibit the fuel injectors during cranking. Turn on the
ignition. Press and hold the starter button to crank the engine until normal
oil pressure is indicated on the oil pressure gauge. Release the starter button
and the accelerator pedal.
Start the engine normally and check that the oil pressure and ignition
warning lights go out as the engine starts indicating correct oil pressure and
battery charging. Raise the bonnet and check for leaks of fuel, oil and
coolant.
Finally, check the operation of all instruments, lights and accessories.

G - Specifications
1-G-2
Body
Two door Roadster with 2+0 seating.
Steel underframe and body panels. Steel front wings, boot lid, sills and front
and rear bumper aprons. Steel doors, bonnet inner, boot inner and rear
quarters. Side impact protection in the doors.
Engine
All alloy, quad overhead cam 48 valve V12. 5935 cc. Compression ratio
10.3:1.
Twin EECV engine management systems with multi-point sequential fuel
injection and 'Coil on Plug' Ignition System.
Fuel 95 RON Unleaded or 98 RON Super Unleaded.
(USA - Premium Unleaded). 2 in-tank fuel pumps.
Emission control 4 Oxygen sensors / three-way catalytic convertors,
Exhaust gas recirculation, Evaporative loss purge
Bore 89.0mm
Stroke 79.5mm
Spark Plugs NGK - PTR6E-13
Spark Plug Gap 1.3 ± 0.1mm
Lubrication system Wet sump pressurised lubrication
Alternator Denso L3BHE 120A
Voltage Regulation 13.8V ±0.5V @ 20°C
Battery Varta 90AH
(Manual) (Automatic)
Max Power 324 kW (435 bhp) 309kW (420 bhp)
@ 6000 rpm @ 6000 rpm
Max Torque 556 Nm (410 lb/ft) 542 Nm (400 lb/ft)

G - Specifications
1-G-11
Capacities
Europe UK USA
Engine sump (incl. filter) 11 litres (20.0 pints) (11.5 Qts)
Engine sump (excl. filter) 10 litres (18 pints) (10.3 Qts)
Engine cooling system 14.35 litres (25.25 pints) (15.2 Qts)
Screen washer reservoir 2.8 litres (5.0 pints) (3.2 Qts)
Manual gearbox 4.0 litres (7.0 pints) (4.2 Qts)
Automatic gearbox 12.8 litres (22.5 pints) (13.5 Qts)
Final drive 1.6 litres (2.8 pints) (1.7 Qts)
Fuel tank 82 litres (18 galls) (21.5 galls)
Note: Approximately 7 litres of the total fuel capacity specified above is
required to prime the fuel system and is therefore not usable.

2-A-5
A - Service Schedules
Pre-delivery Inspection (PDI)
Before you receive your DB AR1, it will undergo a comprehensive pre-
delivery inspection at the Dealer's premises to ensure that it meets Aston
Martin's quality standards. The following checks will be made:
Levels and Leaks
Engine oil
Power steering oil
Brake Fluid
Clutch fluid (manual only)
Engine coolant level
Engine coolant specific gravity
Windscreen washer fluid
Fuel system
Gearbox oil/Auto transmission fluid
Rear axle oil - Differential
Battery
Mechanical Functions
Auto transmission
Selection and P & N functions
Manual gear selection
Clutch operation (manual only)
Throttle pedal operation
Parking brake operation
Steering column adjustment and lock
operation
Seat adjuster rails
Bonnet (Hood) release and catch
Door operation and locks
Storage compartments
Rear view mirror
Wheels and Tyres
Road wheel nuts
Tyre pressures
Front wheel tracking
Electrical Checks
Battery condition
Heated windscreen
Windscreen washers
Windscreen wipers
Air-conditioning controls
Gauges and warning lights
Radio/Cassette/CD player
Navigation (where fitted)
All speakers
Electric aerial
Inertia switch
Window mechanisms
Side and headlights (main and dip)
Front fog lights
Rear fog lights (where fitted)
Hazard warning lights
Instrument illumination and dimmer
Air conditioning panel illumination
Auto Trans. PRNDL illumination
Horns
Interior/map lights
Cigar lighter
Seat adjustment - all functions
Door mirror adjustments
Reset clock (if necessary)
Door / boot courtesy lights
Central locking system
Filler flap lock operation
Seat belt operation
Seat belt warning system
Security system / Remote control
Clutch pedal start inhibit
Interrogate DTC codes (not N.
America)
Record battery open-circuit voltage

A - Service Schedules
2-A-6
Road Test
Engine
Clutch (manual only)
Manual transmission
Auto transmission
Rear axle differential
Steering
Brakes
Wheel balance
Dampers
Noise vibration or harshness
Air conditioning performance
Instruments operation
Seat belt and buckle operation
Steering wheel alignment
Traction control
Final Checks
Drive belt tensions
Fuel / brake pipe security
Fuel / fluid leaks
Cooling systems hose security
Exhaust catalyst security
Hand-over Preparation
Assemble / Check function of all keys
and key fobs
Clean bodywork
Clean off all transit labels
Valet Vehicle
Degrease windscreen
Fit carpets
Remove interior protection
Check Owner's Guide/Quick Guide
Check tools
Install license plates

2-A-7
A - Service Schedules
Service Schedules
The following service schedules are recommended for DB AR1. The schedules may
be modified if necessary. Please consult your Aston Martin Dealer for details of any
service schedule updates.
Road Test Evaluation
1000mls 7500mls 15000mls
1500km 12000km 24000km
3 months 6 months 12 months
x x x Pre-Maintenance Road Test Evaluation
Fluids Filters and Leaks Checks
1000mls 7500mls 15000mls
1500km 12000km 24000km
3 months 6 months 12 months
x x x Renew the engine oil
x x x Renew the engine oil filter
x x x Check for engine oil leaks
- - x Renew the air cleaner elements
x x x Check auto transmission for leaks
x x x Check man. gearbox for leaks.
Top-up if necessary
- - x Renew rear axle oil
x - - Check / top-up rear axle oil
- x - Check rear axle for leaks, top up if necessary
- - 30000 Renew engine coolant - check S.Gravity
x x x Check/top-up engine coolant
x x x Check cooling and heating systems for leaks
- - 60000 Renew fuel filters
x x x Check for fuel leaks
Every 2 years 30,000 miles Renew brake fluid
x x x Check / top-up brake fluid reservoir
x x x Check / top-up clutch fluid reservoir
x x x Check / top-up power steering reservoir
x x x Check power steering system for leaks
x x x Check brake hoses, pipes and unions for leaks
x x x Check suspension dampers for leaks
x x x Top-up windscreen washer reservoir
x x x Check exhaust system for leaks
x x x Check air conditioning system for leaks