26-1
Exhaust system components,
removing and installing
WARNING!
Do not re-use any fasteners that are worn or
deformed in normal use.
Some fasteners are designed to be used only
once, and are unreliable and may fail if used
a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and
cotter pins. Always follow the
recommendations in this manual-replace
these fasteners with new parts where
indicated, and any other time it is deemed
necessary by inspection.
Note:
Always replace gaskets and self-locking nuts.
After exhaust system repairs, make sure
exhaust system is not under stress and that it
has sufficient clearance from the bodywork. If
necessary, loosen double clamps and align
muffler and exhaust pipe so that sufficient
clearance is maintained to the bodywork and
the support rings are evenly loaded.
Pa
ge 1 of 35 Exhaust s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.1
26-21
Three Way Catalytic Converter (TWC),
removing and installing
Removing
Note:
Replace gaskets and self-locking nuts.
Flexpipe in front exhaust pipe must not be bent
more than 10 , otherwise it may be damaged.
- Disconnect harness connector for heated oxygen sensor (arrow) and
set aside.
Note: - Remove coolant expansion tank -2- (arrows)
- Remove wiring from Engine Coolant Level (ECL) warning switch -F66-
and lay coolant expansion tank to side.
Pa
ge 27 of 35 Exhaust s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.26.1
