check engine light AUDI A3 1997 8L / 1.G ATW Engine Ignition System Workshop Manual

28-7


If LED does not light up:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
If LED lights up:
Checking voltage supply
Test requirement:
Electrical Wiring Diagrams, Troubleshooting & Component Locations - Connect VAG1527B voltage tester as follows:Harness connector
Terminal
Measure to
2 B+
4 B+

LED must light up.
- Check wire connections.
- Check voltage supply
Fuses for engine electronics OK
Pa
ge 8 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1

28-46
Component location Overview of component
locations Page 24
-5
The Camshaft Position (CMP) sensor provides
the ignition position for cylinder 1.
For failure, knock control is switched off and the
ignition angle is retarded slightly since a cylinder
allocation is no longer possible. In addition, the
boost pressure of the turbocharger is decreased.
Engine will continue to run without Camshaft
Position (CMP) sensor signal and can also be
restarted:

When a malfunction is recognized, the Engine
Control Module (ECM) initiates one ignition
spark per cylinder for each crankshaft rotation.
The offset of one engine rotation will have no
noticeable effect on the injection. Instead of
occurring with intake valves open, injection will
be "pre-loaded" (in front of closed intake valve).
This has only a minor effect on the quality of the
mixture preparation.
Pa
ge 50 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1