fuse diagram AUDI A3 1997 8L / 1.G ATW Engine Tank Ventilation Workshop Manual

24-110

Checking voltage supply

Test requirements:

Fuse for the EVAP valve OK.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations

Fuel Pump (FP) relay OK; checking Page 24
-53
.

Note:
Voltage is supplied to the EVAP valve via the
Fuel Pump (FP) relay.

- Disconnect connector at EVAP valve.

- Connect VAG1527B voltage tester as follows:Harness connector
Terminal
Measure to
1 Engine Ground (GND)
- Operate starter briefly (engine can also start).

LED must light up.
Pa
ge 4 of 6 Tank ventilation, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.3

24-111
If LED does not light up:

- Check wire connection from terminal 1 of
connector to Fuel Pump (FP) relay via fuse for
open circuit:

Electrical Wiring Diagrams, Troubleshooting &
Component Locations
- Repair open circuit if necessary.
If LED lights up:

- Checking activation.

Checking activation

- Connect VAG1527B voltage tester to connector terminals 1 (B+) and 2.
- Initiate output DTM and activate Evaporative Emission (EVAP) canister
purge regulator valve -N80- Page 01
-49
.

LED must blink.
Pa
ge 5 of 6 Tank ventilation, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.3