compression AUDI A3 1998 8L / 1.G ATW Engine Ignition System Workshop Manual

28-2

Safety precautions

To reduce the risk of personal injury and/or
damage to the fuel injection and ignition system,
always observe the following:

Do not touch or disconnect ignition wires when
engine is running or turning at starting RPM.
Always switch ignition off before disconnecting
or reconnecting wires for the injection and
ignition system, including high voltage wiring
and test leads.
If engine is to be cranked at starting RPM
without starting (e.g. for compression testing),
disconnect connector from ignition coils and
from fuel injectors.
It is possible that the control module will
recognize a malfunction and store a DTC during
some tests. After completing all tests and
repairs, DTC memory should therefore be
checked and erased if necessary. Readiness
code must be generated after DTC memory is
erased Page 01
-73
.

Always switch ignition off before cleaning
engine.
Pa
ge 2 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1

28-40

Knock recognition control stop,
checking

If a DTC is stored regarding "Knock control
regulation limit reached":

- Perform following tests:

Possible cause
Corrective action
DTC for all cylinders

Poor fuel quality
Operating instructions - Change fuel quality
or
Cylinder 1/2 or 3/4
Knock sensor tightened to incorrect torque- Loosen knock sensors and tighten to 20 Nm

Knock sensor faulty- Check knock sensor Page 28
-41


Corrosion at harness connector- Check harness connector

Engine accessories loose- Secure engine accessories
DTC for one Cylinder
Engine damage- Check compression pressure

Engine accessories loose- Secure engine accessories
Pa
ge 44 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1