automatic AUDI A3 2006 8P / 2.G RNS_E Navigation System Manual

Drives45
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP


Never expose CDs to direct sunlight.Tips
I f y o u w a i t l o n g e r t ha n 3 0 s e c o n d s wi t h o u t re m o v i n g t he C D, t h e CD
will be pulled back into the CD changer automatically.Applies to vehicles: with CD changer with magazineCD changer with magazine
CD changer with magazine:
fig.44
Sliding door to close the CD slot
CD magazine slot
Cartridge eject button
CD Changer Magazine
fig.45
Upper side of the magazine
Lower side of the magazine
As a r ul e , t h e C D ch a n g e r a n d m a g a z in e a re i n s t a l l e d i n t h e lu gg a g e
compartment of most vehicles. In other models, they may be
in s t a ll e d i n a c o mp a r tm e n t in t h e re a r s id e t r i m o r b e h i n d t h e d ri v e r
seat. Please refer to your Owner's Manual for the exact location.
Note
The CD changer is intended for use with 12 cm (4.7 inch) discs
only.
Fig. 44 CD changer
with magazine
Fig. 45 CD magazine
A;AA A;A

Drives 46Removing and inserting the magazineYou can load and remove the CD magazine with the Naviga-
tion System switched on or off.
Removing the magazine from the CD changer
– Slide the changer door open
fig.46.
– Press the cartridge eject button
fig.46. The maga-
zine automatically comes out.
– Remove the magazine .
Inserting the magazine in the CD changer
– Open the sliding door of the CD slot
fig.46.
– Slide the magazine all the way in with the inscription
“disc” on top. While doing this, the arrow on the maga-
zine must point towards the magazine slot
fig.46.– Close the changer door .
After inserting the magazine, you will hear a “working noise” from
t h e CD c ha n g e r. Th e d e v i c e i s s im p l y c o u n t i n g h o w ma ny C Ds a r e i n
the changer.
If there is no magazine in the CD changer, a read error is shown in
the display.
Fig. 46 CD changer
with magazine
A1
A2
A3
A;
A1

Drives51
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Tips
If outside temperatures are unusually high or low, the navigation
DVD function may be temporarily unavailable. A thermal switch has
been installed to protect the navigation DVD and the laser
scanner.Handling the navigation DVD or CD
Correct handling of the data carrier being used helps
to extend its life.Alwa ys hold a N avigatio n DVD o r CD either b y the hole in the center
or by the outer edge
fig.52.
The CDs should never be forced into the slot. The CD will be pulled
into the CD changer automatically.
When inserting a CD into the drive, insert it with the printed side
facing up and straight.
Error messagesThe following may be the reason for a read error in the display:

The navigation DVD, audio CD or MP3 CD is contaminated.


The navigation DVD, audio CD or MP3 CD was inserted upside
down (with the printed side down).


The navigation DVD, audio CD or MP3 CD is scratched.


There is condensation on the navigation DVD, audio CD or MP3
CD.


The mechanism for the CD changer, the navigation DVD drive or
the MP3 card reader is malfunctioning.
Check the navigation DVD, audio CD, MP3 CD or SD/MMC memory
card for damage.
Cl e a n th e n a v i g a t io n DV D, a ud i o C D o r M P 3 C D b y w i p i n g it f ro m t he
center toward the outside with a soft, lint-free cloth.
In cold weather and in rain showers, moisture (condensation) can
collect in the housing or on the data carriers. This can cause skips
or make playback impossible. When moisture is no longer present,
it should be possible to play them.
If the mechanism for the CD changer with magazine malfunctions,
remove the magazine from the changer
page 46 and inspect the
CDs for damage and for correct positioning in the magazine
page 48.
I f t h e m e c h a n i s m f o r t h e A u d i c d c h a n g e r m a l f u n c t i o n s , p u s h t h e C D
Eject button and the corresponding illuminated button to eject the
CD page 44. Inspect the CD for damage.
Try to resume DVD/CD operation. If the malfunction persists, please
consult a qualified dealership.
Fig. 52 Holding your
Navigation DVD or CD

RADIO 58
function button
– Press the function button in the radio menu.
Each time the button is pressed, the frequency
band changes.The following frequency bands are available:Main radio menuGeneral
The radio station list for the selected frequency band is
displayed in the main radio menu.The station lists for the FM and AM range differ in their behavior.
The FM station list
fig.55 is adapted automatically (dynamically)
and the AM station list page 59, fig.56 has to be updated manu-
ally (statically).
The station list in the XM Satellite Radio*
page 60, f i g .5 7 o r S i r i u s
Satellite Radio* main menu is updated dynamically.
The title line of the Display shows you whether the radio station is
operating in FM, AM, XM* or Sirius*. The frequency band can be
selected with Band control button
page 57.
Tips
The radio station currently set and the frequency band is shown in
the instrument cluster display.Radio station list on the FM band
The FM station list is dynamic and adapts automati-
cally to the current reception status.Fig. 55 Radio: Station list in main FM menu– Press the function button if another menu is
currently being displayed.
– Select the desired radio station in the main FM radio
menu with the control knob.
Frequency band
Abbreviation
Frequency modulation
FM
Amplitude modulation
AM
Satellite Radio
XM* Radio or
Sirius*
FM
AM
FM
AM
FM
AM
FM
AM

RADIO 58
function button
– Press the function button in the radio menu.
Each time the button is pressed, the frequency
band changes.The following frequency bands are available:Main radio menuGeneral
The radio station list for the selected frequency band is
displayed in the main radio menu.The station lists for the FM and AM range differ in their behavior.
The FM station list
fig.55 is adapted automatically (dynamically)
and the AM station list page 59, fig.56 has to be updated manu-
ally (statically).
The station list in the XM Satellite Radio*
page 60, f i g .5 7 o r S i r i u s
Satellite Radio* main menu is updated dynamically.
The title line of the Display shows you whether the radio station is
operating in FM, AM, XM* or Sirius*. The frequency band can be
selected with Band control button
page 57.
Tips
The radio station currently set and the frequency band is shown in
the instrument cluster display.Radio station list on the FM band
The FM station list is dynamic and adapts automati-
cally to the current reception status.Fig. 55 Radio: Station list in main FM menu– Press the function button if another menu is
currently being displayed.
– Select the desired radio station in the main FM radio
menu with the control knob.
Frequency band
Abbreviation
Frequency modulation
FM
Amplitude modulation
AM
Satellite Radio
XM* Radio or
Sirius*
FM
AM
FM
AM
FM
AM
FM
AM

RADIO61
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Memory control buttonUsing the memory list
Up to 30 stations from all available frequency bands
can be saved in the memory list.Fig. 58 Radio: Memory listSaving a new station in the memory list
– Select the desired radio station in the main radio menu
with the control knob.
–Press the Memory control button.
– By rotating and pressing the control knob, select Store
station station-ID
fig.58.– Select your desired memory location by rotating the
control knob.
– Press the control knob to save the station.
Selecting a station from the memory list
–Press the Memory control button in the radio menu.
– By rotating and pressing the control knob, select a
station from the memory list.
In addition to the lists of available radio stations (
page 58), the
radio function gives you the option of collecting the radio stations
that you want in a memory list.
The frequency band
page 57 is indicated in each case to the right
of the station name fig.58.
When you save a new station, an empty memory location will be
offered automatically. You may also select any other memory loca-
tion or you can replace one that is already taken. If a station is
already stored there, it is overwritten.
If the current station is already saved in the memory, you are not
given the option Store station station-ID.
When you have selected the station you want in a radio station list
page 59, fig.56, you can switch to the memory list by pressing
and holding the control knob to save this station.
I n S e t u p r a d i o , y o u c a n d e l e t e s a v e d r a d i o s t a t i o n s f r o m t h e m e m o r y
list using the Delete stored stations function
page 67.
Starting on
page 62 you can find how to set and save radio
stations manually.

RADIO63
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Automatic seek modeFig. 60 Radio: Automatic seek mode forward–Press the Tu n i n g control button in the FM/AM radio
menu.
–Select >| (“Seek up”)
fig.60 or |< (“Seek down”) in the
Display by rotating the control knob.
– Press the control knob to begin automatic frequency
search.B y b r i e f l y p r e s s i n g t h e c o n t r o l k n o b , y o u s t a r t a u t o m a t i c s e e k , w h i c h
stops at the next receivable frequency. Since a station often broad-
casts on different frequencies (e.g. “Bayern 3”), the seek stops at
each of the receivable frequencies. So “Bayern 3” is found several
times.
Saving stations (STORE)Fig. 61 Radio: Store station
Fig. 62 Radio: Saving stations in the memory list

RADIO 64
–Press the Tu n i n g control button in the FM/AM radio
menu.
– Using “Manual station search”
page 62 or “Automatic
seek”
page 63, select the station (or frequency) that
you wish to save.
– By rotating and pressing the control knob, select STORE
(“Store station”)
page 63, fig.61.
– Select your desired memory location by rotating the
control knob.
– Press the control knob to save the station.Using the control wheel, you can also save manually set radio
stations
page 62.
When you save a new station, an empty memory location will be
offered automatically. You can also choose any other memory loca-
tion.
You can find additional information about radio stations starting on
page 61. In Setup radio you can delete saved radio stations from
the memory list
page 67.
Automatic station scan (SCAN)Fig. 63 Radio: SCAN function–Press the Tuning control button in the FM/AM radio
menu.
– By rotating the control knob, select SCAN
fig.63.
– Press the control knob to begin scan. The receivable
stations are played for a few seconds.To s e l e c t t h e s t a t io n t h a t i s c urre n t l y b e i n g p l a y e d , p re s s t h e c o n t ro l
knob again.

RADIO65
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Setup Radio (FM/AM range)Opening and closing SetupFig. 64 Setup Radio: Main menu– In a Radio menu, press the button to open the
main Setup menu for the radio function
fig.64.
– Press the button again to close the main Setup
menu again.The following settings are possible in Setup Radio:

Station reception
page 65


Station display
page 66


Delete stored stations
page 67The sound and tuning settings and the brightness of the display can
be entered using the control buttons
page 169.
Tips
We recommend that you enter these settings when the vehicle is
stationary. In this way, you can be sure that you are not unneces-
sarily distracted from traffic when performing the procedures that
follow. Please note
page 9, “Notes on Traffic Safety”.
Station reception (FM/AM range)
The selectivity for the automatic seek function can also
be adjusted.Fig. 65 Setup Radio: Station reception
SETUP
SETUP

RADIO 66
– Press the function button in the FM/AM radio
menu.
– Select Station reception
page 65, fig.65.Local station reception
Automatic seek
page 63 s t o p s o n l y a t s t a t i o n s o r f r e q u e n c i e s w i t h
strong reception.
Distant station reception
Automatic seek page 63 also stops at distant, weaker stations or
frequencies.
Station display (FM/AM range)
Ticker texts broadcast by radio stations can be
stopped.Fig. 66 Setup Radio: Station display– Press the function button in the FM/AM radio
menu.
– Select Station display.
–Under Station display, select on. The texts/names broad-
c ast fo r t h e r ad i o st a t i o n cu rre n t l y se l ec t e d ar e s h o w n , o r
–Under Station display, select off. The te xts/names broad-
cast for the radio station currently selected are not
shown.
SETUP
SETUP