towing AUDI A3 2016 Owner´s Manual

,....,
N
0 > co ,...., 9. In the veh icle that is being jump started,
switch the heater fan and rear window de­
froster on to reduce any voltage peaks that
may occur when disconnecting the jumper
cab les. The he adlights must be switched off.
10 . With the engines running, remove the cables
i n
reverse order of the way they were instal­
l ed . Make sure the cables do not get caught
in mov ing engine components.
11. Sw itch the heater fan and rear w indow de-
froster off.
12. Close the battery cover .
The battery is vented to the o utside so that not
gases enter the passenger compartment. Make
sure that the connected positive terminal clamps
on the jump start cab le have sufficient contact
with m etal.
.&_ WARNING
Follow the warnings and instructions from
the jump start cable manufacturer to reduce
the risk of serious injuries and vehicle dam­
age. If you are unsure about anything, call
roads ide assistance.
- The jump start cables must be long enough
so that the veh icles do not touch .
-
-Route the jump start cables so they cannot
get caught in the moving parts in the engine
compartment .
- Always read and follow the warnings before
check ing anything in the engine compart­
me nt ¢
page 236.
Connecting jump start cables incorrectly can
destroy the alternator .
- Always connect the positive terminal(+) to
the positive term inal( +) and the negative
term inal(-) to the negat ive termi nal( -) on
the body ground po int, but not the negative
te rminal on t he battery.
- Make sure the screw plugs on the battery
ce lls are installed securely .
If not, tighten
the p lugs before connecting the clamps to
the negat ive termina l on the battery.
- Please note that the connecting p rocess de­
scribed below for the j ump start cables is in-
Emergency s ituatio ns
tended for when your vehicle is be ing j ump
started.
If you are jump starting another ve­
hicle, do not connect the negat ive cab le to
the negative term inal( -) on the dra ined
battery, but rather connect it to a large
metal component that is bolted secure ly to
the engine block, or to the engi ne b lock it­
self . If the batte ry in the veh icle being jump
s tarted is not ven ted to the outside, there is
a risk of explos ion due to hyd rogen gas .
- Make sure that the connected pos itive ter­
m inal clamps have suff ic ien t conta ct with
metal.
- Do not use the battery negative terminal for
jump starting or a m alfunction co ul d o ccur
in the vehicle e lectrica l system.
Towing with a tow truck
General hints
Your Audi requires special handling for towing.
T he following information is to be used by com ­
mercial tow truck operators who know how to op­
e rate th eir equipment safely.
- Ne ver tow your Audi. Towing will caus e dam­
age to the engine and tr ansmi ssion.
- Neve r wrap th e safety ch ains or win ch c able s
a round the brake lin es.
- To pr event unn ecess ary damag e, your Audi
must be tran sport ed with a flat bed tru ck.
- To load th e ve hicl e on to the flat bed, use the
towin g loop found in the v ehicle tools and at ­
t ac h t o the front o r rea r anchorage
¢ page 298 and ¢ page 298 .
.&_ WARNING ~
A vehicle being towed is not safe for passen-
gers. Never allow anyone to ride in a vehicle
being towed, for any reason.
297

Emergency situations
Front towing loop
Fig. 230 Right front bumper: removing the cover
Fig. 231 Right front bumper: towing loop installed
The threaded open ing for the tow ing loop is lo­
cated behind a cover on the right side of the front
bumper .
.,. Remove the towing loop from the vehicle tool
k it ¢
page 280 .
.,. Press inward on the upper left area of the cap
with brief, strong pressure to
remove it from
the bumper
¢fig. 230 .
.,. Tighten the towing loop in the threaded open­
ing until it stops
¢fig. 231 and then tighten it
with a wheel wrench.
.,. After using, place the towing loop back in the
vehicle tool kit.
& WARNING
If the towing loop is not installed securely, it
cou ld loosen from the threads w hile towing
and cause damage to the vehicle or injury to
people.
298
Rear towing loop
Fig. 232 R ig ht rear towing loop : cover
Fig. 233 Right rear towing loop: towing loop ins talled
The towing loop threaded opening is located in
the right of the rear bumper cover under a cover .
.,. Remove the towing loop from the vehicle tool
kit¢
page 280 .
.,. To remove the cap from the bumper, press in
on the
upper area of the cap -arrow-with brief,
strong pressure and lift it up from the
lower
area ¢fig. 232.
.,. Tighten the towing loop in the threaded open­
ing until it stops ¢
fig. 233 and then tighten it
with a wheel wrench.
.,. After using, p lace the tow ing loop back in the
vehicle tool k it.
Depending on the model , the shape of the cove r
can vary.
~ WARNING
If the tow ing loop is not installed securely, it
could loosen from the threads while towing
and cause damage to the vehicle or injury to people.

Consumer information
Consumer information
Warranty coverages
Your Audi is covered by the following warran­
ties:
- New Vehicle Limited Warranty
- Limited Warranty Against Corrosion Perfora-
tion
- Emissions Control System Warranty
- Emissions Performance Warranty
- California Emissions Control Warranty (USA
vehicles only)
- California Emissions Performance Warranty
(USA vehicles only)
Detailed information regarding your warranties
can be found in your
Warranty & Maintenance
booklet .
Operating your vehicle
outside the U.S.A. or
Canada
Government regulati ons in the United States and
Canada require that automobi les meet specific
emission regulations and safety standards.
Therefore, vehicles built for the U.S.A. and Cana ­
da differ from vehicles sold in other countries.
If you plan to take your vehicle outside the conti­
nenta l limits of the United States or Canada,
there is the poss ibility that:
- un leaded fue ls for vehicles with catalytic con­
verter may not be available;
- fuel may have a considerably lower octane rat­
ing . Improper fuel may cause engine damage;
- service may be inadequate due to lack of proper
service facilities, tools or testing equipment;
- r eplacement parts may not be readily available.
- Nav igation systems for veh icles built for the
U.S .A . and Canada will not necessarily work in
Europe, and may not work in other countries
outside North America.
306
(D Note
Audi cannot be responsib le for mechanical
damage that could result from inadequate
fuel, service or parts ava ilability.
Audi Service Repair
Manuals and Literature
Audi Official Factory Service Manuals and Litera ­
ture are published as soon as poss ible after mod­
el introduction . Service manuals and literature
are available to order from the Audi Technical Lit ­
erature Ordering Center at :
www.audi.techliterature .com
Maintenance
General '
Your vehicle has been designed to help keep
maintenance requirements to a minimum. How­
ever, a certain amount of regular maintenance is
still necessary to assure your vehicle's safety,
economy and reliability . For detailed vehicle
maintenance consult your Warranty & Mainte­
nance booklet .
Under difficult operating conditions, for exam ­
ple at extremely low outside temperatures, in
very dusty regions, when towing a trailer very fre­
quently, etc., some service work should be per­
formed between the intervals specified. This ap­
plies particularly to:
- oil changes, and
- cleaning or replac ing the a ir filter .
'
@) For the sake of the environment
By regularly maintain ing your vehicle, you
help make sure that em iss ion standards are
maintained, thus minimizing adverse effects
on the environment .
Important considerations for you and your
vehicle
The increasing use of electronics, sophisticated
fuel injection and emission control systems, and
the generally increas ing technica l complexity of ..,_

Index
Sun visors ..... .................. ..... 52
Switching daytime running lights on and off
Switching the ignition on/off (with key) .. ..
Symbols 49
80
refer
to Indicator lights . . . . . . . . . . . . . . . . 13
System indicator light (MIL) . . . . . . . . . . 23, 26
T
Tachometer .. .. ... ............ .... . 10, 11
TDI clean diesel
refer to Ad Blue . . . . . . . . . . . . . . . . . . . . . . 234
Technical Data . . . . . . . . . . . . . . . . . . . . . . . 301
Technical modifications . . . . . . . . . . . . . . . . 308
Temperature display
Coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
10
Outside tern perature . . . . . . . . . . . . . . . . . . 11
Tether anchors . . . . . . . . . . . . . . . . . . . . . . . 225
Tether strap . . . . . . . . . . . . . . . . . . . . . . . . . 225
The first 1,000 miles (1,500 km) and after-
wards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
77
Tie-downs . . . . . . . . . . . . . . . . . . . . . . . . 66, 173
Tips for the environment
Saving fuel . . . . . . . . . . . . . . . . . . . . . . . . . . 69
tiptronic (automatic transmission) . . . . . . . . 94
Tire Mobility System . . . . . . . . . . . . . . . . . . .
280
Tire Mobility System (tire repair set) . . . . . . 281
Tire repair set . . . . . . . . . . . . . . . . . . . . . . . . 280
Tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 253
Low aspect rat io tires . . . . . . . . . . . . . . . . 270
Repair set . . . . . . . . . . . . . . . . . . . . . . . . . . 281
Replacing . . . . . . . . . . . . . . . . . . . . . . . . . . 283
Service life . . . . . . . . . . . . . . . . . . . . . . . . . 261
Tire pressure . . . . . . . . . . . . . . . . . . . . . . . 263
Tire pressure monitoring system ... 271,272
Tire pressure table . . . . . . . . . . . . . . . . . . . 264
Tread wear indicators . . . . . . . . . . . . . . . . 261
Unidirectional. . . . . . . . . . . . . . . . . . . . . . . 255
Uniform tire quality grading . . . . . . . . . . . 271
Tires and wheels
Glossary of tire and loading terminology .
255
Tires and vehicle load limits . . . . . . . . . . . 266
Tool ...... .. .. .. .. . .......... .. .. .. . 280
Torn or frayed safety belts . . . . . . . . . . . . . . 178
Towing
Tow trucks
Towing loop
322
297
298
TPMS (tire pressure monitoring system) . . . 272
Trailer mode . . . . . . . . . . . . . . . . . . . . . . . . . 127
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 128
Trailer towing
Operating instructions. .. .. .. .... ... ..
127
Technical requirements ........... 127, 128
Transmission malfunction (indicator light) . . 95
Transport Canada . . . . . . . . . . . . . . . . . . . . . 174
Travel mode . . . . . . . . . . . . . . . . . . . . . . . . . . 49
Trunk
refer to Luggage compartment. . . . . . . . . . 64
Trunk lid
Trunk escape latch . . . . . . . . . . . . . . . . . . .
280
Turning light . . . . . . . . . . . . . . . . . . . . . . . . . . 46
Turn signals . . . . . . . . . . . . . . . . . . . . . . . . . . 48
Indicator light . . . . . . . . . . . . . . . . . . . . . . . 26
u
ULSD No. 2 (Diesel fuel) . . . . . . . . . . . . . . . . 229
Unfastening safety belts . . . . . . . . . . . . . . . 181
Uniform tire quality grading 271
Unlocking/locking
by remote control . . . . . . . . . . . . . . . . . . . . 3 7
with the central locking switch . . . . . . . . . .
39
with the convenience key . . . . . . . . . . . . . . . 38
with the door lock . . . . . . . . . . . . . . . . . . . . 39
V
Vanity mirror . . . . . . . . . . . . . . . . . . . . . . . . . . 52
Vehicle
Care/cleaning .. .. .. .. ... .......... ..
274
Dimensions .. .. .. .. .. .. ........... .. 302
Out of service . . . . . . . . . . . . . . . . . . . . . . . 279
Transport . . . . . . . . . . . . . . . . . . . . . . . . . . 108
Vehicle control modules. . . . . . . . . . . . . . . . 158
Vehicle identification label . . . . . . . . . . . . . 301
Vehicle Identification Number (VIN ) . . . . . . 301
Vehicle jack . . . . . . . . . . . . . . . . . . . . . . 280, 286
Vehicle key . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Vehicle sound . . . . . . . . . . . . . . . . . . . . . . . . 100
Vehicle tool kit . . . . . . . . . . . . . . . . . . . . . . . 280
w
Warning/indicator lights
System indicator light (MIL) . . . . . . . . . . . .
23