change time AUDI A4 1995 B5 / 1.G AC System On Board Diagnostic Workshop Manual

01-5

Notes:

For m.y. 1997, changes that affect monitoring of
the A/C system by A/C control head -E87- were
made.
Monitored components, locations pages 87
-
101
and Page 87
-113
.

Additional technical data and notes page 01
-
1 .

If a replacement A/C control head is not coded
after installation or if an unrecognized code was
entered, code "04142" (Audi A4 -4cyl. -USA) is
stored.
The A/C control head is no longer connected to
terminal 30 (vehicle electronics). The last input
setting (into the A/C control head) is stored
when the ignition is switched off and retained
when the ignition is switched on.
The duration of time when ignition is off is
calculated by the A/C control head. When
ignition is switched on, the previous "standing
time" is calculated by monitoring a time signal
from the instrument cluster. If more than 4
hours pass since ignition was switched off, the
actual measured values of the outside
Pa
ge 6 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-57

Code Control Module (function 07)


A/C control head -E87- coding, vehicles 1996

Notes:

A/C control head coding 1997 page 01
-
59
.

A/C control head coding 1998 page 01
-
61
.
A/C control head -E87- coding shows market
application, compressor type and engine type.

Notes:

Zexel A/C compressors are installed from start
of production. During m.y. 1996, Nippondenso
type compressors are installed as a running
change. These compressors are not equipped
with A/C speed sensor G111.
Each time A/C control head -E87- is coded,
basic setting must be performed page 01
-
52
.

If a the display of a newly installed A/C control
head -E87- flashes after switching ignition on
(for approximately 2 minutes), code the control
Pa
ge 81 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1