check engine AUDI A4 1995 B5 / 1.G AFC Engine Cylinder Block Crankshaft And Flywheel Component Assembly Manual

13-8


12 -
Dual mass flywheel or drive plate
Removing and installing, installation
dimensions page 13
-17

Removing and installing pilot needle
bearing page 13
-16

Adjusting engine speed (RPM) sensor
bracket -G28- page 13
-20

13 -
Main bearing shell
Checking radial clearance page 13
-21
14 -
Seal
Replacing page 13
-14
15 -
10 Nm (7 ft lb)
16 -
25 Nm (18 ft lb)
Thread bolts in hand-tight before tightening
crankshaft main bearing caps
17 -
Cylinder block
Pa
ge 5 of 32 C
ylinder block, crankshaft and fl
ywheel, com
ponent la
yout
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.13.4

13-11

Toothed belt, removing and installing


Removing

CAUTION!

Mark the direction of belt travel before
removing, using a crayon or marker.
Reinstalling a used belt in the opposite
direction could damage the belt.

- Remove ribbed belt page 13
-9 .

- Unclip toothed belt guard on both sides.

- Crank engine by hand to Top Dead Center (TDC) position.
- Check camshaft position. Large holes in camshaft sprocket locking
plates must face toward each other. If not, turn crankshaft one more
revolution.
- Remove Crankshaft Position (CKP) sensor from left-hand side of
cylinder block.
The TDC hole in the crankshaft must be aligned with the hole for the
removed crankshaft position sensor (check by looking and feeling).

- Thread crankshaft holder 3242 into hole left by crankshaft position
sensor, and tighten slightly.
- Remove ribbed-belt tensioner.
Pa
ge 9 of 32 C
ylinder block, crankshaft and fl
ywheel, com
ponent la
yout
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.13.4

13-19


Note:
Before installing the engine, make sure that the engine-to-transmission
dowel sleeves are installed in the cylinder block flange. - Check clearance -a- between drive plate and cylinder block in three
places and calculate average value.
Dimension -a-:

Transmission 01V: 18.1-19.7 mm (0.713-0.776 in.)
- If necessary, install other shims to achieve correct clearance
dimension.

Tightening torque: 60 Nm (44 ft lb) plus 1/4-turn (90 )
Pa
ge 19 of 32 C
ylinder block, crankshaft and fl
ywheel, com
ponent la
yout
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.13.4