washer AUDI A4 1995 B5 / 1.G APB Engine Lubrication System Components Workshop Manual

17-2


Crankcase breather and oil spray jets,
removing and installing

Removing and installing oil pump, oil pan, oil filter
and oil cooler Page 17
-32

1 -
Bolt, tightening torque: 20 Nm
2 -
Washer
3 -
Tensioning roller
4 -
Bolt, tightening torque: 45 Nm
5 -
Idler wheel
For toothed belt
Pa
ge 2 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1

17-6


23 -
Washer
24 -
Bearing bush
For tensioning lever
25 -
Washer
26 -
Bolt, tightening torque: 25 Nm
27 -
Tensioning lever
28 -
Bearing bush For tensioning roller
Pa
ge 6 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1

17-62

Chain sprocket for oil pump on
crankshaft, removing and installing


Removing
Removing and installing front sealing flange and
oil pump drive chain Page 17
-55
.

Installing
Notes: - Pull chain sprocket off crankshaft using a normal commercial-type
puller -2-: use a suitable washer -1- to protect end of crankshaft.
-
Heat chain sprocket in oven for about 15 minutes at 220 C.
Wear protective gloves. Installation position: it should be possible to read the lettering on the
chain sprocket.

Removing and installing front sealing flange and oil pump drive chain
Page 17
-55
. - Using pliers, install chain sprocket on end of crankshaft and push
against stop on crankshaft with drift sleeve 30-100. If necessary knock
on carefully using a plastic hammer.
Pa
ge 67 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1