engine AUDI A4 1995 B5 / 1.G ATQ Engine Output Diagnostic Test Mode Workshop Manual

01-56


Output Diagnostic Test Mode
(DTM) (function 03)

Notes:

Output Diagnostic Test Mode (DTM) is only
possible with engine idle and ignition switched
on.
Output Diagnostic Test Mode (DTM) is aborted
if engine is started or an RPM signal is
recognized.
In output Diagnostic Test Mode (DTM),
individual actuators (with the exception of the
fuel injectors) are activated for approximately 1
minute unless the next actuator is selected
earlier by pressing the " button.
Actuators are checked either acoustically or by
touch.
The electric Fuel Pump (FP) runs during all of
output Diagnostic Test Mode (DTM).
Engine must be started before repeating output
Diagnostic Test Mode (DTM). (ECM must
recognize an engine speed of above 300 RPM).
Pa
ge 1 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3

01-58

Test requirement:

Fuses for engine electronics OK

Test sequence

- Connect VAS5051 tester or VAG1551 scan tool
and select the control module for engine
electronics using "address word" 01 Page 01
-
9 .

Ignition must remain switched on for this.Rapid data transfer
HELP
Select function XX

When indicated on display:
- Press buttons -0- and -3- to select "output Diagnostic Test Mode" and
press -Q- button to confirm input.
Rapid data transfer
Q
03-Output Dia
gnostic Test Mode

Indicated on display:
Activating the EVAP canister purge regulator valve (tank vent valve)
Note:
The Fuel Pump (FP) relay must trigger, the Fuel Pump (FP) must run,
flowing noise at fuel pressure regulator is clearly audible. If Fuel Pump
(FP) does not run, check activation Page 24
-52
. - Confirm input using the -Q- button.
Pa
ge 3 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3

01-59

Output Diagnostic Test Mode EVAP canister pur
ge re
gulator valve -N80

Indicated on display:
If valve is not activated (does not click):
Activating the Secondary Air Injection (AIR) solenoid valve (Indicated on VAG1551: from EVAP canister purge regulator valve -
N80-)

This valve is activated for approx. 1 minute (clicks), unless - button
is pressed first to switch to the next actuator. - Check Evaporative Emission (EVAP) canister purge regulator valve -
N80- Page 24
-128
.
-
Press button.
Output Diagnostic Test Mode Secondar
y air in
jection solenoid valve -N112

Indicated on display:
If valve is not activated (does not click):
Repair Manual, Engine Mechanical, Repair Group 26; Secondary Air
Injection (AIR) system
Activating the Secondary Air Injection (AIR) pump relay
This valve is activated for approx. 1 minute (clicks), unless - button
is pressed first to switch to the next actuator. - Check Secondary Air Injection (AIR) solenoid valve -N112-:
Pa
ge 4 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3

01-60

Output Diagnostic Test Mode Secondar
y air in
jection pump rela
y -J299

Indicated on display:
If the Secondary Air Injection (AIR) pump motor -V101- does not run in
intervals:
Repair Manual, Engine Mechanical, Repair Group 26; Secondary Air
Injection (AIR) system
Activating intake manifold change-over valve The Secondary Air Injection (AIR) pump relay -J299- (in 3-socket relay
carrier in the E-box, at left in the plenum chamber , position 2) switches
the Secondary Air Injection (AIR) pump motor -V101- on for approx. 1
minute in intervals unless the next actuator is selected first by pressing
the button. - Check Secondary Air Injection (AIR) pump relay -J299-:-
Press button.
Output Diagnostic Test Mode Intake manifold chan
geover valve -N156

Indicated on display:
If valve is not activated (does not click):
This valve is activated for approx. 1 minute (clicks), unless - button
is pressed first to switch to the next actuator. - Check intake manifold change-over valve -N156- Page 24
-67Pa
ge 6 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3

01-61

Activating camshaft adjustment valves

-
Press button.Output Diagnostic Test Mode Camshaft ad
justment 1

Indicated on display:
If valves are not activated (do not click).
Repair Manual, Engine Mechanical, Repair Group 15; Camshaft
adjustment, checking; Function of camshaft adjustment, checking
Activating Leak Detection Pump (diagnostic pump for tank
ventilation system) Valve -1- for camshaft adjustment -N205- and valve -2- for camshaft
adjustment -N208- are activated for approximately 1 minute (they click)
unless output Diagnostic Test Mode (DTM) is ended first by pressing
the " button
- Check camshaft adjustment valves:-
Press button.
Output Diagnostic Test Mode Leak detection pump Tank vent valve system

Indicated on display:
Th change-over valve in the LDP is activated for approximately 1
minute (clicks), unless button is pressed first to switch to the next
actuator.
Pa
ge 7 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3

01-65

-
Press button.Output Diagnostic Test Mode Cyl. 5 fuel injector -N83

Indicated on display:
-
Press button.
Output Diagnostic Test Mode Cyl. 5 fuel in
jector -N83

Indicated on display:
If injector does not click: Fuel injector must click 5 times after arrow button is pressed.
- Check fuel injectors Page 24
-36
.
Output Diagnostic Test Mode END

Indicated on display:
-
Press button.
Rapid data transfer
HELP
Select function XX

Indicated on display (function selection):
Note:
Before re-initiating output Diagnostic Test Mode (DTM), engine must be
started and the ignition must be switched off and on again.
Pa
ge 12 of 12 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3