ignition AUDI A4 1995 B5 / 1.G Brakes ESP Electrical Testing Workshop Manual

01-302

Test requirements

The "Automatic Test Sequence" was carried
out and it was determined that the
Transmission Control Module (TCM) and
Engine Control Module (ECM) only contain
DTCs relating to ABS.

- Connect the VAG1551 Scan Tool (ST) and
select the address word 00 with ignition
switched on;

- After completing electrical test, check and
erase DTC memories of Transmission Control
Module (TCM) and Engine Control Module
(ECM).

Multi-pin harness connector for ABS control module -J104- in proper
condition, with no bent, broken or corroded terminals. Replace any
damaged terminals using VAS1978 wiring repair kit.
Pa
ge 2 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-303

Note:
The operation manual for the VAS1978 wiring
harness repair kit generally forbids the repair of
any lines in the ABS or related systems. This rule
only pertains to the shielded lines in these
systems.

Ignition and electrical consumers switched
off before beginning testing (headlights,
lighting, fan, etc.).
For steps 13 through 16, raise the vehicle
until the wheels rotate freely. On vehicles
with manual transmission put the gear shift
lever in neutral. On vehicles with automatic
transmission move the selector lever to
position "N".
Pa
ge 3 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-305

Connecting VAG1598/20 test box and
checking ESP system

- Switch ignition off.

- Remove ABS control module -J104-.

Repair manual, Brake System, Repair Group
45


- Disconnect multi-pin connector from ABS control
module -J104-.

- Check multi-pin connector between harness
connector and ABS control module -J104-.

The socket designations on the VAG1598/20 test box are identical to the
terminal designations on the ABS control module -J104- and on the wiring
harness connector.
Electrical Wiring Diagrams, Troubleshooting & Component Locations - Connect VAG1598/20 test box to multi-pin connector of wiring harness.
Pa
ge 5 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-323
Electrical test; steps 13-27

Function test
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective action
13
1)
Bridge
1 + 2,
28+37
2)
28+36 3) Inlet valve -N101
and front left
brake line
connection
Ignition on

- for vehicles with
automatic transmission,
engage neutral position
"N"
- Bridge terminals 5 +
28
- Depress brake pedal
and hold.
Left front
wheel can
be rotated
by hand - If the wheel does not rotate, check the
other wheels for free rotation. If yes, then
hydraulic brake lines are mixed-up
(switched). Check brake line connections
and coupling pieces. Make sure every
component is OK.

See continuation on next page
Outlets on ABS control module -J104- differ depending on installed equipment
1) This test step requires two technicians.
Pa
ge 25 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-325

Function test
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective action
14
1)
Bridge
1 + 2,
28+37
2)
28+36 3) Inlet valve -N99-
and front right
brake line
connection
Ignition on

- for vehicles with
automatic transmission,
engage neutral position
"N"
- Bridge terminals 26 +
28
- Depress brake pedal
and hold.
Right front
wheel can
be rotated
by hand - If the wheel does not rotate, check the
other wheels for free rotation. If yes, then
hydraulic brake lines are mixed-up
(switched). Check brake line connections
and coupling pieces. Make sure every
component is OK.

See continuation on next page
Outlets on ABS control module -J104- differ depending on installed equipment
1) This test step requires two technicians. 2) Vehicles with control module 4B0 907 389
Pa
ge 29 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-327

Function test
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective action
15
1)
Bridge
1 + 2,
28+37
2)
28+36 3) Inlet valve -
N134- and rear
left brake line
connection
Ignition on

- for vehicles with
automatic transmission,
engage neutral position
"N"
- Bridge terminals 53 +
28
- Depress brake pedal
and hold.
Left rear
wheel can
be rotated
by hand - If the wheel does not rotate, check the
other wheels for free rotation. If yes, then
hydraulic brake lines are mixed-up
(switched). Check brake line connections
and coupling pieces. Make sure every
component is OK.

See continuation on next page
Outlets on ABS control module -J104- differ depending on installed equipment
1) This test step requires two technicians. 2) Vehicles with control module 4B0 907 389
Pa
ge 33 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-329

Function test
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective action
16
1)
Bridge
1 + 2,
28+37
2)
28+36 3) Inlet valve -
N133- and rear
right brake line
connection
Ignition on

- for vehicles with
automatic transmission,
engage neutral position
"N"
- Bridge terminals 6 +
28
- Depress brake pedal
and hold.
Right rear
wheel can
be rotated
by hand - If the wheel does not rotate, check the
other wheels for free rotation. If yes, then
hydraulic brake lines are mixed-up
(switched). Check brake line connections
and coupling pieces. Make sure every
component is OK.

See continuation on next page
Outlets on ABS control module -J104- differ depending on installed equipment
1) This test step requires two technicians. 2) Vehicles with control module 4B0 907 389
Pa
ge 37 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-331

Function test: ABS warning light -K47-
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective
action
17 - Function of ABS
warning light -K47- DTC memory checked and no DTC present
in DTC memory of ABS control module -
J104-. Ignition switched off Multi-pin connector connected to ABS
control module -J104- and retainer catch
engaged.

See continuation on next page
Pa
ge 41 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-332
Continuation: Function test: ABS warning light -K47-
Test
step VAG
1598/20
sockets Test of
Test
requirements
- Additional work
steps Specified value
Corrective action
17 - Function of
ABS warning
light -K47- - Switch on
ignition ABS warning light -
K47- lights up for two
(2) seconds and then
goes out. - If ABS warning light does not come on,
check voltage of electrical system and test
wiring from terminal 32 of ABS control
module -J104- to instrument cluster for short
circuit to Ground (GND).

See continuation on next page
Pa
ge 42 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16

01-334

Function test: Red brake warning symbol
Test
step VAG
1598/20
sockets Test of
Test requirements
- Additional work stepsSpecified
value Corrective
action
18 - Function of red "brake
system malfunction"
symbol
Repair Manual, Brake System, Repair
Group 47

Brake fluid level is OK Function of ABS warning light -K47-
already checked in step 17. Multi-pin connector connected to ABS
control module -J104- and retainer
catch engaged. Switch on ignition

See continuation on next page
Pa
ge 44 of 65 Electronic Stabilization Pro
gram
(ESP
), electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.16