engine AUDI A4 1995 B5 / 1.G Mechanical Throttle Control Servising

20-187

Accelerator pedal cable, adjusting
(vehicles with 1.8 ltr. turbo engine)


Accelerator pedal cable -5- connected to accelerator pedal and routed
over the throttle actuator control module cable quadrant.
Note:
Either use a second technician or a mechanical device to depress the
accelerator pedal. - Remove clip -2- from notched section of outer cable sleeve -1-.
- Fully depress accelerator pedal to Wide Open Throttle position.
Pa
ge 2 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-189

Vehicles with automatic transmission,
checking adjustment

Test and auxiliary equipment required

Fluke 83 Multimeter
VW 1594 Adaptor kit

- Disconnect 2-pin harness connector from kick-
down switch.
In engine compartment on firewall.

- Connect multimeter between kick-down switch terminals using jumper
wires from VW 1594 adaptor kit.
- Measure resistance across switch.
Specified Value:
- Slowly depress accelerator pedal until Wide Open Throttle is reached.
If properly adjusted, following conditions will be met:
Shortly after kick-down point, resistance must drop to 0 Accelerator pedal must almost be up to the full travel stop
Pa
ge 4 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-190

Accelerator pedal cable, adjusting
(vehicles with 2.8 ltr. engine)


Accelerator pedal cable -1- connected to accelerator pedal and routed
over the Throttle actuator control module cable quadrant.
Note:
Either use a second technician or a mechanical device to depress the
accelerator pedal. - Remove clip -3- from notched section of cable sleeve -4-.
- Fully depress accelerator pedal to Wide Open Throttle position.
Pa
ge 5 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-192

Vehicles with automatic transmission,
adjustment checking

Test and auxiliary equipment required

Fluke 83 Multimeter
VW 1594 Adaptor kit

- Disconnect 2-pin harness connector from kick-
down switch
In engine compartment on firewall

- Connect multimeter between kick-down switch terminals using jumper
wires from VW 1594 adaptor kit.
- Measure resistance across switch.
Specified Value:
- Slowly depress accelerator pedal until Wide Open Throttle is reached.
If properly adjusted, following conditions will be met:
Shortly after kick-down point, resistance must drop to 0 Accelerator pedal must almost be up to the full travel stop
Pa
ge 7 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-193

Accelerator pedal cable, removing and
installing (vehicles with 1.8 ltr. turbo
engine)


Removing

- Remove driver's side storage compartment.

Repair Manual, Body Interior, Repair Group
70


- Disconnect end of accelerator pedal cable -1- from top of accelerator
pedal -2-.

- Release accelerator pedal cable ferrule -5- from location in quadrant.
- Pull notched section of cable sleeve -1- out of grommet -4- in bracket -
3-.
Pa
ge 8 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-195

Installing
Installation is performed in the reverse order of
the removal procedure, during installation, note
the following:

- See notes Page 20
-186
.

Vehicles with manual transmission

- Slide cable with cable bracket -3- and cable positioner -1- out of the
engine compartment and through the front and rear plenum walls in -
direction of the arrow-.
- Attach cable bracket with retaining clip -2- behind firewall, in the
plenum.
Pa
ge 10 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-196

Vehicles with automatic transmission

- Slide cable with cable bracket -3- and cable mounting -1- out of the
plenum toward the front, through the firewall to the engine and
backward through the fire wall to the vehicle interior.
Arrow points in installation direction.
- Attach cable bracket with retaining clip -2- in front of firewall in the
plenum.

- Connect kick-down-switch harness connector -arrow-.
Pa
ge 11 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-198

Accelerator pedal cable, removing and
installing (vehicles with 2.8 ltr. engine)


Removing

- Remove driver's side storage compartment

Repair Manual, Body Interior, Repair Group
70


- Disconnect cable -1- from top of accelerator pedal -2- (dotted lines).

- Remove engine cover -arrows-.
Pa
ge 13 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-200

Vehicles with automatic transmission

All vehicles
Note:
For vehicles with a manual transmission (no kick-down switch), the clip is
located on the cable bracket behind the front plenum. - Disconnect harness connector -2- from kick-down switch.
- Remove retaining clip -1- from the kick-down switch.

-
Twist cable positioner approx. 90 in counter-clockwise direction -
arrow 1- and pull out through the firewall side of plenum in direction of -
arrow 2- toward the engine. - Remove the accelerator pedal cable.
Pa
ge 15 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6

20-202

Vehicles with automatic transmission

- Slide accelerator pedal cable -3- (with kick-down switch bracket) and
cable positioner -1- through the back and front plenum walls as shown
in illustration.
-arrow- shows installed position
- Secure kick-down switch bracket with retaining clip -2-.On engine compartment side of plenum

- Connect kick-down-switch harness connector -arrow-.
Pa
ge 17 of 18 Mechanical throttle control, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.6