checking oil AUDI A4 1996 B5 / 1.G AEB ATW Engines Lubrication System Components Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1996, Model line: A4, Model: AUDI A4 1996 B5 / 1.GPages: 33, PDF Size: 0.6 MB
Page 5 of 33

17-3
 
  
8 - 
Bolt 
25 Nm (18 ft lb)
9 - 
Nut 25 Nm (18 ft lb)
10 - 
Brace 
11 - 
Nut 25 Nm (18 ft lb)
12 - 
Side brace 
13 - 
Bolt 20 Nm (15 ft lb)
14 - 
Oil pump housing 
15 - 
Gears Backlash, checking  Fig.  1Axial clearance, checking   Fig.   2
16 - 
Oil pump cover with pressure relief valve 
Opening pressure: 5.7-6.7 bar (82.65-
97.15 psi) 
17 - 
Bolt 25 Nm (18 ft lb)
18 - 
Bolt 
Pa
ge 5 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1 
Page 12 of 33

17-8
 
    
Fig. 1  Checking oil pump backlash
New: 0.05 mm (0.002 in.) Wear limit: 0.20 mm (0.008 in.)
    
Wear limit: 0.15 mm (0.006 in.)  Fig. 2  Checking oil pump axial clearance
Pa
ge 12 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1 
Page 27 of 33

17-22
      
Oil pressure and oil pressure switch, 
checking
 
     
Function of dynamic oil pressure warning 
system  
     
Warning lamp, checking 
      With engine switched off and ignition on (terminal 
15 on), oil pressure warning lamp will be lit (not 
for vehicles with Auto Check system).  
     
Warning criteria 
     
Engine switched off and oil pressure switch 
closed. 
     Coolant temperature less than 60 C (140
F), engine speed higher than 300 RPM and 
oil pressure switch open. 
     
Coolant temperature greater than 60 C 
(140 F). 
     
At engine speeds greater than 5000 RPM, 
an active oil warning won't be erased 
independent of oil pressure switch setting. 
     A Diagnostic Trouble Code (DTC) is 
recognized when oil pressure switch is open 
Pa
ge 27 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1 
Page 30 of 33

17-24
      
Oil pressure switch, checking  
     
-  Disconnect line from oil pressure switch.
    
Note:  
While starting engine, watch pressure tester and LED as oil pressure 
switch may open during start.  -  Remove oil pressure switch and install VAG1342 oil pressure tester.
-  Install oil pressure switch into VAG1342 oil pressure tester.
-  Connect brown wire -1- of tester to Ground (GND).
-  Using VAG1594 adapter, connect VAG1527B voltage tester to oil 
pressure switch and Battery Positive Voltage (B+). 
   LED must not be lit.
-  If LED is lit, replace oil pressure switch.
- Start engine.
   At 1.2-1.6 bar (17.4-23.2 psi) LED must be lit.
-  If LED does not light, replace oil pressure switch.
Pa
ge 30 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1 
Page 31 of 33

17-25
      
Oil pressure, checking  
     
-  Disconnect line from oil pressure switch.
    
If specified values are not obtained, the pressure relief valve or the oil 
pump is faulty.  -  Remove oil pressure switch and install VAG1342 oil pressure tester.
-  Install oil pressure switch into VAG1342 oil pressure tester.
- Start engine.
Engine oil temperature approximately 80 C (176 F). Oil pressure at idle: 1.0-3.5 bar (14.5-50.75 psi)Oil pressure at 3000 RPM: 5.0-7.0 bar (72.5-101.5 psi)
-  Replace oil pump   Page 17
-21
 .
Pa
ge 31 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1 
Page 33 of 33

17-27
      
Oil level, checking
 
     
Test conditions 
     
Minimum engine oil temperature: 60 C 
(140 F) 
     
Vehicle on level ground 
     After stopping engine, wait a few minutes to 
allow oil to flow back into oil pan 
     
-  Withdraw dipstick, wipe off using clean cloth and 
reinsert fully. 
     
-  Withdraw dipstick again and read oil level.
    
Range of markings on dipstick:  
CAUTION! 
Do not overfill with oil past the MAX mark on the oil dipstick. 
Damage to the Three Way Catalytic Converter (TWC) could result.  a - Oil MUST NOT be topped off.
b - Oil may be topped off. After topping off, oil may reach range -a-.
c - Oil MUST BE topped off. After topping off, it is sufficient if oil level is 
somewhere in range -b- (shaded area). 
Pa
ge 33 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1