check engine light AUDI A4 1996 B5 / 1.G AHA Engine Multiport Fuel Injection And Ignition System Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1996, Model line: A4, Model: AUDI A4 1996 B5 / 1.GPages: 166, PDF Size: 0.91 MB
Page 122 of 166

24-96
       If the fuel pump does not respond:  
     
-  Check fuel pump relay actuation   page 24
-
99
 . 
      If the LED test light does not light up:  
     
-  Repeat test at other terminal of fuse 28.
    
If the LED light still does not light up:  
-  Check wiring for open or short circuits between fuse 28 and terminal 30 
at relay position 6, using the applicable wiring diagram. Repair wiring 
as necessary. 
  
Specified value: max. 1.5 
    
Note:  
This step lets the fuel pump run without the engine running. The closed 
throttle position switch must be closed during the test, or the selected fuel 
injector will discharge fuel when it is actuated 5 times.  -  Connect VAG1527B LED voltage tester between Ground and one of 
the two terminals for fuse 29. 
Pa
ge 122 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
Page 124 of 166

24-97
       If the LED test light does not light up:  
     
-  Repeat test at other terminal of fuse 29.
    
If the LED test light still does not light up:  
-  Check wiring for open circuit between fuse 29 and terminal 30 at relay 
position 6, using the applicable wiring diagram. Repair wiring as 
necessary. 
  
Specified value: max. 1.5 
    
Note:  
This step lets the fuel pump run without the engine running. The closed 
throttle position switch must be closed during the test, or the selected fuel 
injector will discharge fuel when it is actuated 5 times.  -  Connect VAG1527 LED voltage tester between Ground and one of the 
two terminals of fuse 34. 
-  Initiate output Diagnostic Test Mode (DTM) and advance to test of 
cylinder 1 fuel injector -N30-   page 01
-51
 . 
 
LED test light must light up
 Fuel pump relay must be activated
Pa
ge 124 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
Page 140 of 166

24-110
      
Checking for leaks  
     
-  Conduct output DTM, actuating cylinder 1 
injector -N30-   page 01
-51
 (fuel pump must be 
running). 
     
Note:  
     This step lets the fuel pump run without the 
engine running. The closed throttle position 
switch must be closed during the test, or the 
selected fuel injector will discharge fuel when it is 
actuated 5 times. 
     
-  Visually check injector for leaks.
     
   With fuel pump running, only 1 to 2 drops can 
drip in a minute (per injector). 
      If fuel loss is greater:  
     
-  Replace leaking injector
      Installation of the injectors is in reverse order of 
removal.  
     
-  Replace O-rings on all injectors and coat O-rings 
lightly with clean engine oil. 
     
Pa
ge 140 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
Page 158 of 166

24-121
      
Checking EVAP canister purge regulator 
valve voltage supply  
     
Test conditions  
     
Fuse for EVAP canister purge regulator 
valve OK 
     
-  Disconnect harness connector from EVAP 
canister purge regulator valve. 
    
If LED test light does not light:  
If wiring is OK:  -  Connect VAG1527B LED voltage tester between connector terminal 1 
(B+) and engine Ground. 
-  Operate starter motor. 
   Specified value: LED must light up
-  Check wiring for open circuit between connector terminal 1 and fuse, 
according to wiring diagram; repair if necessary. 
  
Specified value: 1.0   max.-  Check fuel pump relay   page 24
-95
 .
Pa
ge 158 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
Page 162 of 166

24-125
      
Voltage supply, checking  
    
If LED tester does not light:  -  Disconnect harness connector for LDP -V144-.
-  Connect VAG1527B LED voltage tester between connector terminal 3 
(B+) and engine Ground. 
-  Start engine and run engine at idle.
   LED must light up.
-  Check fuse for LDP -V144-.
-  Check wiring for open circuit between terminal 3 and fuse, according to 
wiring diagram. 
  
Specified value: max. 0.5  .-  Check fuel pump relay and signal to relay   page 24
-95
 .
Pa
ge 162 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1