belt AUDI A4 1996 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual

13-20

Crankshaft bearing caps, installing


- Bearing -1- is at the toothed belt end; bearing -4-
is at the flywheel end.

Tightening sequence:
- Stage 1 Tighten all bolts in the sequence shown (1 - 16) to 30 Nm.
- Stage 2 Tighten all bolts in the sequence shown (1 - 16) to 60 Nm.
- Stage 3 Using a fixed wrench, turn all bolts in the sequence shown (1 -
16) 90 further. - Tighten bolts -A- to 25 Nm.
Pa
ge 7 of 26 C
ylinder block, crankshaft and fl
ywheel, disassembl
y and assembl
y
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.13.2

13-23

Crankshaft oil seals, replacing


A - Toothed belt end

- Remove toothed belt Page 13-4 .

- Remove toothed belt sprocket from crankshaft

Note:
Do not lubricate sealing lip or outer circumference of seal before pressing
in. - Pull out oil seal with oil seal extractor 3203.
- Clean contact surface and sealing surface.
- Push on seal using fitting sleeve 3202/1.

- Press in seal until flush using fitting sleeve 3265 and central bolt.
Pa
ge 10 of 26 C
ylinder block, crankshaft and fl
ywheel, disassembl
y and assembl
y
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.13.2