belt AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual

[x] Cancel search | Manufacturer: AUDI, Model Year: 1996, Model line: A4, Model: AUDI A4 1996 B5 / 1.G
Pages: 47, PDF Size: 0.92 MB
AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual A4 1996 B5 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/934/w960_934-0.png AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual
Search: (OBD port, roof rack, gas mileage, radiator, MPG, brake pads)

Page 8 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-8 Ribbed belt drive for power steering pump, Generator and viscous fan Note: Mark the direction of rotation with chalk or felt pen before removing the ribbed belt. If the belt rotates in

Page 9 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-9 Parts List 4 - Ribbed V-belt Removing and installing Page 13 -18 . Check for wearRouting of ribbed belt Fig. 2 , Page 13 -17 5 - Bolt (special type) Always replaceUse only

Page 10 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-10 8 - 23 Nm 9 - Tensioner for ribbed belt Turn with open end spanner to loosen ribbed belt Page 13 -18 . Hold in position by inserting a suitable pin or Allen key in holes. 10 - 4

Page 11 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-11 14 - Generator Removing: - Disconnect battery Ground strap - Remove air duct hose to charge air cooler. - Loosen ribbed belt and take belt off Generator Page 13 -18 . - Remove

Page 14 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-14 Ribbed belt drive for air conditioner - assembly overview CAUTION! The air conditioner refrigerant circuit must not be opened. Note: Mark the direction of rotation with chalk or fel

Page 15 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-15 2 - Air conditioner compressor Do not loosen or disconnect refrigerant hoses or lines. After removing compressor from mountings, secure to chassis side member with wire or similar. Do

Page 16 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-16 7 - Washer 8 - 23 Nm 9 - Ribbed V-belt Removing and installing Page 13 -18 . Check for wearDo not kinkRouting of ribbed belt Fig. 2 , Page 13 -17 10 - Washer 11 - 25 Nm

Page 17 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-17 Parts List The vibration damper can only be installed in one position. The hole - arrow- in the vibration damper must fit over the projection on the toothed belt sprocket. Fig. 1 I

Page 18 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-18 Ribbed belt, removing and installing Note: Mark the direction of rotation with chalk or felt pen before removing the ribbed belt. If the belt rotates in the wrong directi

Page 19 of 47

AUDI A4 1996 B5 / 1.G AWM Engine Assembly Workshop Manual 13-19 Note: - Turn tensioner in direction of arrow to loosen ribbed belt. - Remove ribbed belt from Generator and release tensioner. When the lock carrier is in the service position, t
Page:   1-10 11-20 21-30 next >
Search: (fuse box location, windshield wipers, remote control, height, key, diagnostic menu)