ABS AUDI A4 1996 B5 / 1.G AWM Engine Motronic Injection System Servicing Workshop Manual

24-3

Rules of cleanliness

When working on the fuel supply or fuel injection
systems, the following "6 rules of cleanliness"
should be carefully observed:

Thoroughly clean all connections and the
surrounding area before disconnecting.
Place parts that have been removed on a clean
surface and cover. Use lint-free cloths only!
Carefully cover over opened components or
seal, if repairs are not carried out immediately.
Only install clean components: Only unpack
replacement parts immediately prior to
installation. Do not use parts that have been
stored loose (in tool boxes etc.)
When the system is open: Do not work with
compressed air if it can be avoided. Do not
move vehicle unless absolutely necessary.
Disconnected electrical harness connectors:
Protect from dirt and moisture. Be sure harness
connector is dry before connecting.
Pa
ge 4 of 79 Motronic in
jection s
ystem, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.24.1

24-68

Intake system, checking for leaks
(unmetered air)


Special tools and equipment

Notes:
Test sequence
VAS5051 with VAG5051/1Engine leak detection spray G 001 800 A1The negative pressure in the intake system sucks in the leak detection
spray with the unmetered air. Leak detection spray decreases ignition
quality and performance of the fuel mixture. This causes a reduction in
engine speed and a sharp increase of CO content. It is absolutely necessary to follow the safety precautions listed on the
can.
- Connect VAS5051 tester Page 01
-7 and select vehicle system "01 -
Engine electronics". Engine must run at idle for this.
Pa
ge 77 of 79 Motronic in
jection s
ystem, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.24.1