lock AUDI A4 1996 B5 / 1.G Brakes Erase DTC Memory End Output Workshop Manual

01-13

Selecting functions

The communication link was established. The
control module version has been checked and
the button was pressed.
Rapid data transfer
HELP
Select function XX

Indicated on display:(function selection, for example 02 "Check DTC
Memory")
It is now possible to select one of the functions listed below. Start the
troubleshooting procedure using the "Check DTC Memory" function (02).
01 - Check Control Module Version
02 - Check DTC Memory
03 - Output Diagnostic Test Mode (DTM)
04 - Basic Setting
05 - Erase DTC Memory
06 - End Output
07 - Code Control Module
08 - Read Measuring Value Block
10 - Adaptation
11 - Login Procedure
Pa
ge 3 of 15 Erase DTC Memor
y (function 05
), End Out
put
(function 06
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.2

01-22

Test requirements

Vehicle equipped with approved wheel and
tire sizes, which must be the same on all four
wheels. All tire inflation pressures checked
according to specification.
The mechanical/hydraulic components of the
brake system are OK. Hydraulic connections
and lines are sealed properly (visual check
at hydraulic unit, brake calipers, wheel
cylinders, tandem master brake cylinder).
Wheel bearings and wheel bearing play OK
Wheel speed sensors installed correctly

Repair manual, Brake System, Repair Group
45


Supply voltage OK (at least 10.0 volts).
Harness connector is properly connected at
ABS control module -J104-, locking
mechanism is engaged.

Pa
ge 12 of 15 Erase DTC Memor
y (function 05
), End Out
put
(function 06
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.2