display AUDI A4 1996 B5 / 1.G Instrument Cluster OBD From Model Year 2000 User Guide

01-93
Diagnostic Trouble Code (DTC) table for instrument cluster

Notes:

The following table lists all malfunctions that can be recognized by the instrument cluster and printed out by the VAG1551
scan tool. The malfunctions are listed in order according to their 5-digit numbers.
DTC numbers appear only on the print-out.
Before replacing a component shown as faulty, check the wiring and connections to the component as well as the Ground
(GND) connections according to wiring diagram.
After repairs and function test of the system, DTC memory must always be checked again using the VAG1551 scan tool
and erased.
DTC memory stores all static and sporadic malfunctions: If a malfunction occurs and persists for at least 2 seconds, it is
identified as a static malfunction (outside temperature malfunction at least 60 seconds, coolant temperature sensor only
after at least 30 minutes with engine running). If a malfunction does not occur again, it is registered as sporadic. "/SP" will
appear at right on scan tool display.
When the ignition is switched on, all existing malfunctions are automatically re-classified as sporadic malfunctions and will
only register as static malfunctions if they still occur after testing.
Sporadic malfunctions which no longer occur during 50 driving cycles (ignition on at least 5 minutes, vehicle speed 30
km/h) are erased automatically.
Pa
ge 17 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-94

VAG 1551 scan tool display
Possible causes
Corrective action
00562
Oil level thermal sensor -
G266-

Open circuit/short circuit to
B+
Short circuit to Ground
Implausible signal
Open circuit or short circuit
between oil level thermal sensor
-G266- and instrument cluster Oil level thermal sensor -G266-
faulty -G266- faulty Electronic part in sensor faulty- Locate malfunction using wiring diagram
- Repair open circuit
- Oil level thermal sensor -G266- faulty Replace -
G266-
00667
Outside temperature signal

Open circuit/short circuit to
B+
Short circuit to Ground
implausible signal (is
indicated incorrectly and
must be disregarded)
Open circuit or short circuit
between instrument cluster and
A/C control head -E87- A/C control head -E87- faulty
Repair Manual, Heating & AirConditioning, Repair
Group 01
- Locate malfunction using wiring diagram
- Repair open circuit
- A/C system OBD
00668
Vehicle voltage, terminal 30

Voltage supply too low
Battery was disconnectedOpen circuit or short circuit to a
control module or sensor - Perform automatic test sequence in order to
determine the control module responsible for the
DTC check voltage supply of malfunctioning
control module
- Locate malfunction using wiring diagram
Pa
ge 18 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-95

VAG 1551 scan tool
display Possible causes
Corrective action
00771
Sender for fuel gauge -G-

Open circuit/short
circuit to B+
Short circuit to Ground
Open circuit or short circuit between sender for fuel
gauge -G- (Front Wheel Drive/All Wheel Drive) and
instrument cluster
Sender for fuel gauge -G- (Front Wheel Drive/All
Wheel Drive) is faulty - Locate malfunction using wiring
diagram
- Repair open circuit
- - Replace Sender for fuel gauge -
G- (Front Wheel Drive/All Wheel
Drive)
00779
Outside air temperature
sensor -G17-

Open circuit/short
circuit to B+
Short circuit to Ground
Open circuit or short circuit
Outside air temperature sensor -G17- faulty - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace outside air temperature
sensor -G17-
01039
Engine Coolant
Temperature (ECT) sensor
-G2-

Open circuit/short
circuit to B+
Short circuit to Ground
Open circuit or short circuit between Engine Coolant
Temperature (ECT) sensor -G2- and instrument
cluster
Engine Coolant Temperature (ECT) sensor -G2-
faulty - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace Engine Coolant
Temperature (ECT) sensor -G2-
Pa
ge 20 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-96

VAG 1551 scan tool
display Possible causes
Corrective action
01300
Control module for
navigation with CD
mechanism -J401-

no communication
Open circuit or short circuit
Incorrect control module, that is, control module does
not support CAN
A control module that supports CAN is not indicated with
a "1" in measuring value block Page 01
-132
If control
module for navigation with CD-mechanism -J401- is not
displayed with "1"
Adaptation for the instrument cluster was not performed
properly - Locate malfunction using
wiring diagram
- Repair open circuit
- Replace control module with
a control module that supports
CAN
- Select adaptation channel 62
and input the correct
adaptation value Page 01
-
190
.
01304
Radio

no communication
Open circuit or short circuit
Incorrect control module, that is, control module does
not support CAN
A control module that supports CAN is not indicated with
a "1" in measuring value block Page 01
-132
.
Adaptation for the instrument cluster was not performed
properly - Locate malfunction using
wiring diagram
- Repair open circuit
- Replace control module with
a control module that supports
CAN
- Select adaptation channel 62
and input the correct
adaptation value Page 01
-
190
.
Pa
ge 21 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-97

VAG 1551 scan
tool display Possible causes
Corrective action
01311
Data-BUS
information

faulty
in single wire
mode
Open circuit or short circuit to a control module in
information data-BUS
Incorrect control module in information data-BUS,
that is, control module does not support CAN.
A control module that supports CAN is not indicated
with a "1" in measuring value block Page 01
-132
.
During adaptation of the instrument cluster, a control
module that supports CAN was not concurrently
adapted
Data bus is operating on only one wire (this can
cause EMV problems) - Locate malfunction using wiring diagram
- Repair open circuit
- Replace control module with a control
module that supports CAN
- Select adaptation channel 62 and input
the correct adaptation value Page 01
-
190
.
- Check data exchange Page 01
-196
.
Pa
ge 22 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-98

VAG 1551 scan tool
display Possible causes
Corrective action
01312
Powertrain data-BUS

faulty
Open circuit or short circuit to a control module in
powertrain data-BUS
A control module in the powertrain data-BUS is incorrect,
that is, control module does not support CAN
A control module that supports CAN is not indicated with a
"1" in measuring value block Page 01
-129
.
During adaptation of the instrument cluster, a control
module that supports CAN was not concurrently adapted - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace incorrect control module
with a control module that supports
CAN
- Select adaptation channel 60 and
input the correct adaptation value
Page 01
-183
.
01314
Engine Control
Module (ECM)

no communication
Open circuit or short circuit
Incorrect control module, that is, control module does not
support CAN
A control module that supports CAN is not indicated with a
"1" in measuring value block Page 01
-129
If Engine
Control Module (ECM) is not displayed with "1"
Adaptation for the instrument cluster was not performed
properly - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace control module with a
control module that supports CAN
- Select adaptation channel 60 and
input the correct adaptation value
Page 01
-183
.
Pa
ge 23 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-99

VAG 1551 scan tool
display Possible causes
Corrective action
01315
Transmission Control
Module (TCM)

no communication
Open circuit or short circuit
Incorrect control module, that is, control module does not
support CAN
A control module that supports CAN is not indicated with
a "1" in measuring value block Page 01
-129
.
Adaptation for the instrument cluster was not performed
properly - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace control module with a
control module that supports CAN
- Select adaptation channel 60
and input the correct adaptation
value Page 01
-183
.
01320
Climatronic control
module -J255-

no communication
Open circuit or short circuit
Incorrect control module, that is, control module does not
support CAN
A control module that supports CAN is not indicated with
a "1" in measuring value block Page 01
-130
If
climatronic control module -J522- is not displayed with "1"
Adaptation for the instrument cluster was not performed
properly - Locate malfunction using wiring
diagram
- Repair open circuit
- Replace control module with a
control module that supports CAN
- Select adaptation channel 60
and input the correct adaptation
value Page 01
-183
.
Pa
ge 24 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-100

VAG 1551 scan
tool display Possible causes
Corrective action
01336
Comfort system
data-BUS

faulty
in single wire
mode
Open circuit or short circuit to a control module in
comfort system data-BUS
A control module in the comfort system data-BUS
is incorrect, that is, the control module does not
support CAN
A control module that supports CAN is not
indicated with a "1" in measuring value block
Page 01
-131
.
During adaptation of the instrument cluster, a
control module that supports CAN was not
concurrently adapted
Data bus is operating on only one wire (this can
cause EMV problems) - Locate malfunction using wiring diagram
- Repair open circuit
- Replace control module with a control
module that supports CAN
- Select adaptation channel 61 and input the
correct adaptation value Page 01
-187
.
- Check data exchange Page 01
-196
.
01402
Data wire from
navigation

Unplausible
signal
Open circuit in clock, enable or data wire
Problem in interface between navigation and
instrument cluster
Disturbance due to electromagnetic radiation
inside and outside vehicle Repair Manual, Radio,
Telephone,Navigation, Repair Group 91
- Check cabling of data wires for damage
- Check for cause of electromagnetic
disturbance
- Repair open circuit
65535
Control module Instrument cluster faulty
- Replace instrument cluster Page 90
-27
.
Pa
ge 25 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

01-101

Output Diagnostic Test Mode (scan tool
function 03)


Notes:

Output Diagnostic Test Mode is only possible
when vehicle is stationary and engine is not
running!
If malfunctions are found during output
Diagnostic Test Mode, determine cause of
malfunction and replace instrument cluster if
necessary.

During the "output Diagnostic Test Mode"
function, all actuators that are installed in the
instrument cluster and coded are activated in
sequence.
There is also a simultaneous parallel sweep
through the indicator range of all analog display
instruments (Engine Coolant Temperature
(ECT) gauge, tachometer, speedometer, fuel
gauge)
Activation of warning lamps
Activation of seat belt warning light

Pa
ge 27 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2

Activation of chime
Segment test of driver information system, LCD
clock/date display, and LCD trip odometer and
daily odometer.
Pa
ge 28 of 99 Instrument cluster with lon
g service life, On Board Dia
gnostic
(OBD
) (from m.
y. 2000
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.01.2