transmission oil AUDI A4 1997 B5 / 1.G 01W Transmission Drive Flange Seal Workshop Manual

39-5

Installing

- Lubricate area between sealing lip and dust lip
with a thin layer of multi-purpose grease.

- Lightly oil outer circumference of seal.

Note:
If reinstalling an old drive flange, the seal must be pressed in
approximately 6.5 mm (0.256 in.) so that the new seal does not sit on the
running surface of the old seal. - Drive in new right-hand drive flange seal 5.5 mm (0.217 in.) below
transmission housing surface, without canting.

Note:
If reinstalling an old drive flange, the seal must be pressed in
approximately 6.5 mm (0.256 in.) so that the new seal does not sit on the
running surface of the old seal. - Drive in new left-hand drive flange seal 5.5 mm (0.217 in.) below
transmission cover surface, using VW195 arbor, without canting.
- Drive in drive flange using VW295 needle bearing drift.
- Bolt drive axle to drive flange.
Pa
ge 6 of 7 Drive flan
ge seal, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.1

39-6

- Install heat shield for drive axle.

- Check transmission oil level Page 34
-36
.

Tightening torques

Component

Tightening
torque
Drive axle to drive
flange M8 40 Nm (30 ft lb)

M10 77 Nm (57 ft lb)
Heat shield for drive axle 23 Nm (17 ft lb)
Pa
ge 7 of 7 Drive flan
ge seal, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.1