fuel AUDI A4 1997 B5 / 1.G Suspension Rear Axle All Wheel Drive Workshop Manual

42-58


- Check for factory markings (colored dots -arrows-) for aligning drive
flange on driveshaft -A- to drive flange on rear final drive -B-. If
necessary, apply colored dots (arrows).
- Remove bolts from drive flange.

Repair Manual, Brake System, Repair Group 46

Note:
If the same rear axle is to be re-installed, only disconnect the parking
brake cables at the parking brake lever, underbody and at the fuel tank.
Leave the parking brake cables in position at the rear axle and at the
brake calipers. - Support driveshaft using wire attached to underside of vehicle (arrows)
and place wooden block -1- below driveshaft.
- Remove parking brake cables:
Pa
ge 24 of 32 Rear axle, servicin
g (all-wheel-drive vehicles
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.3

42-61


CAUTION!
Be careful not to damage the edge of the wheelhousing. - While coil spring is still compressed, remove bolts (arrows) from
suspension strut mounting bracket.
- Swivel suspension strut outward at top and relieve coil spring tension.
- Using above procedure, remove suspension strut from opposite side.
- Remove exhaust system bracket from rear final drive.

CAUTION!
Be careful not to damage the fuel tank. - Support final drive using VAG1383A engine/transmission lifter and
VAG1359/2 universal mount.
- Secure rear final drive with strap.
Pa
ge 27 of 32 Rear axle, servicin
g (all-wheel-drive vehicles
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.3