stop start AUDI A4 1997 B5 / 1.G Suspension Wheel Alignment Workshop Manual

44-37

Adjusting toe constant "S"

Checking toe constant after adjusting
The alignment unit checks the toe constant again. - Loosen nut -A-.
- Back out bolt -B- approx. 4 mm (1/8 in.).
- Push tie rod end downward onto stop.
- Turn in adjusting bolt -B- until exact specifications are achieved.
- Tighten nut -A- to 45 Nm (33 ft lb) and check values.
- Tighten bolt -B- to 7 Nm (62 in. lb).
- Lower vehicle to defined starting position B1.
- Screw threaded spindle down.
- On vehicles with standard suspension, bounce suspension several
times.
If the second check shows that the values are within the check value
tolerance, the setting is OK. If the values are outside the check value tolerance, the setting must
be adjusted again in position B2. Position B2: + 60 mm (2.36 in.).
Pa
ge 36 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2