ECU AUDI A4 1998 B5 / 1.G 01W Transmission Disassemble And Assemble Workshop Manual

34-46


8 -
Shift rod
Installation position Page 34
-62
Replacing shift rod sealing washer Page 34
-62

9 -
Shift detent
Installation position Page 34
-62
10 -
Torx bolt
25 Nm (18 ft lb)With shoulder to secure shift detent spring
11 -
Shift rod with shift fork for 1st/2nd/5th and
reverse gear Disassembling and assembling Page 34
-62

Removing and installing ball sleeve
Page 34
-66
, Fig. 2

12 -
Pinion shaft
Disassembling and assembling Page 35
-21

Adjusting Page 39
-35
Servicing pinion shaft ball bearing Page 35
-21

Pa
ge 10 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4

34-50

Removing

- Place VAG1306 drip tray under transmission.

- Drain transmission oil.

- Secure transmission to assembly stand Page
34
-29
.

Notes: - Remove clutch release lever -A- with release bearing.
Before removing the guide sleeve, slide a shrink tube over the input
shaft splines to protect the seal. Remove the seal in the guide sleeve Page 30
-18
.
- Remove guide sleeve -B-.
- Remove spring washer -C-.
- Remove circlip -D- in front of input shaft ball bearing.
- Note thickness of circlip, if ball bearing, input shaft or transmission
housing is not replaced.
Pa
ge 15 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4

34-57


- Install relay shaft -A-.
- Place inner shift rod -B- sideways into mounting hole in transmission
housing and assemble into mounting eye.
- Carefully turn shift rod in direction shown (arrow).

- Insert shift detent and tighten bolt (arrow) securely.
Pa
ge 22 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4