oil AUDI A4 1998 B5 / 1.G 01W Transmission Disassemble And Assemble Workshop Manual

34-47


13 -
Transmission cover
Coat sealing surfaces with thin layer of
sealant AMV 188 001 02 Removing and installing oil collector tray
Page 34
-48
, Fig. 1

14 -
Transmission housing
Match components according to
transmission code letters found in parts
catalog microfiche
15 -
Torx bolt 22 Nm (16 ft lb)
Pa
ge 11 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4

34-48


Removing
Installing Fig. 1 Removing and installing oil collector tray
- Turn oil collector tray (arrow) and pull out.
- Push oil collector tray into transmission, until it snaps in.
Installation position: oil collector tray faces upward in transmission
cover.
Pa
ge 12 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4

34-50

Removing

- Place VAG1306 drip tray under transmission.

- Drain transmission oil.

- Secure transmission to assembly stand Page
34
-29
.

Notes: - Remove clutch release lever -A- with release bearing.
Before removing the guide sleeve, slide a shrink tube over the input
shaft splines to protect the seal. Remove the seal in the guide sleeve Page 30
-18
.
- Remove guide sleeve -B-.
- Remove spring washer -C-.
- Remove circlip -D- in front of input shaft ball bearing.
- Note thickness of circlip, if ball bearing, input shaft or transmission
housing is not replaced.
Pa
ge 15 of 26 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.4