lock AUDI A4 1998 B5 / 1.G AFC Engine Cooling System Components

19-7

- Open the cap on the coolant expansion tank.

- Remove noise insulation panel below engine.

- Drain coolant at radiator.
- Remove locking plate for connection flange of coolant hose at bottom
of radiator, pull off connection flange.
Pa
ge 6 of 12 Coolin
g system, com
ponents
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.19.2

19-9

- Close drain plug at engine block and at bottom
left of radiator.

- Push on connection flange of coolant hose at
bottom of radiator, and install locking element for
connection flange.

- Unscrew cap on expansion tank, screw on adapter VAG 1274/1, and
extend with 42mm diameter and 100 mm long auxiliary hose.

- Open hose clamp, pull back coolant hose sufficiently so that vent hole
is no longer concealed by connection.
- Open bleed screw at coolant pipe below expansion tank.
- Pour coolant into system until it flows out at bleeder hole, then tighten
screw to 15 Nm (11 ft lb).
- Pour in more coolant until it flows out at vent hole, then push on
coolant hose and tighten.
- Close cap on expansion tank and set heater controls to hot position.
- Start engine and run at about 2000 RPM for about 3 minutes.
Pa
ge 8 of 12 Coolin
g system, com
ponents
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.19.2