sensor AUDI A4 1998 B5 / 1.G Brakes Basic Setting 04 User Guide

01-277
Test table: display group 125 Read measuring value block
125
Indicated on display
Steering angle

0 or 1 Engine
0 or 1
Transmission
0 or 1 not
used



Transmission Control Module (TCM): (only for vehicles with automatic transmission)

0: No information received from the Transmission Control Module (TCM) via the CAN-bus.
1: Information is being received from the Transmission Control Module (TCM) via the CAN-
bus.

Engine Control Module (ECM):

0: No information received from the Engine Control Module (ECM) via the CAN-bus.
1: Information is being received from the Engine Control Module (ECM) via the CAN-bus.
Steering angle sensor:

0: No information received from the steering angle sensor via the CAN-bus.
1)
1: Information is being received from the steering angle sensor via the CAN-bus.
1) If the steering angle sensor is OK, it sends information, even if the zeroing procedure was not performed.
Note:
Pa
ge 40 of 64 Basic settin
g (scan tool function 04
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.15

01-278

Output Diagnostic Test Mode (DTM)
(function 03)

Output Diagnostic Test Mode (DTM) is used to
check the function of actuators. Actuators are
also called actors. These are components that
the control module activates when it reacts to the
signals sent by sensors, e.g. solenoid valves,
relays and pump motors.

Note:

Output Diagnostic Test Mode (DTM) only
functions on vehicles containing control
modules with no. 8D0 407 389 A/D/E.
For control modules with no. 4B0 907 389,
output Diagnostic Test Mode (DTM) is not
possible.

Output Diagnostic Test Mode (DTM) can and
must only be selected once after the ignition
is switched on.
Pa
ge 42 of 64 Basic settin
g (scan tool function 04
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.15