oil AUDI A4 1998 B5 / 1.G Engine Oil Level Checking User Guide
[x] Cancel search | Manufacturer: AUDI, Model Year: 1998, Model line: A4, Model: AUDI A4 1998 B5 / 1.GPages: 111, PDF Size: 1.26 MB
Page 36 of 111

may be used. Do not use any lubricant
additives.
Automatic transmission fluid: ATF, part
number G052 162 A2 (1 liter)
An ATF level check when transmission oil
temperature is too low results in overfilling;
when too high results in underfilling.
Pa
ge 36 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 37 of 111

40
CAUTION!
Too much or too liffle ATF will affect the
operation of the transmission. The ATF level
must be checked at regular intervals.
The oil level is correct if only a slight amount of oil runs out when ATF
temperature is between 30 C (86 F) and 45 C
1) (113 F) (caused by
increase of oil level when heated).
WARNING!
Wear protective glasses.
The ATF temperature is measured temperature using the VAG 1551 Scan
Tool. - Hang filled ATF reservoir VAG 1924 as high as possible (example:
radiator grill).
- Shift lever in "P", engine running at idle.
- Place oil drip pan under transmission oil pan.
- Connect VAG 1551 as described on Page 19
.
- Press key -1- for " Rapid Data Transfer " mode.
Pa
ge 37 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 40 of 111

42
Note:
Fit filler hook into one of the oil deflector cap -4-
slots placed on the filler opening.
CAUTION!
Do not press filler hook upward or oil
deflector cap can be pushed off.
- Reinstall ATF filler plug -2-.
Tightening torque: 80 Nm (59 ft lb).
-
Press key to advance program.
- Press keys -0- and -6- to select address code -
06- "Data Transmission Ended" and confirm with
key -Q-.
Pa
ge 40 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 41 of 111

43
Final drive oil level, checking
Automatic transmission 01V all wheel drive
CAUTION!
If the oil level is too low, the transmission must be checked for leaks
and be repaired. It is not sufficient to just top off oil. - Remove oil filler plug -arrow- and check level.
Specification: oil level must be at bottom of filler hole.
- If there are no leaks, fill to correct level using gear oil: SAE 75 W 90
(synthetic oil), part number G 052 145 S2 (1 liter)
- Replace sealing ring on plug.
- Install plug and tighten to 30 Nm.
Pa
ge 41 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 42 of 111

44
Power steering fluid level, checking
Requirements:
Engine at normal operating temperature.
Vehicle stationary.
Front wheels in straight ahead position.
- Remove cap with dipstick from expansion tank
and wipe off dipstick with a lint-free cloth.
Delivery inspection:
Fluid level must be at max. marking when inspection is performed.
Inspection service:
Fluid level between min. and max. markings.
Note:
If oil level has dropped to the min. marking, check power steering system, - Reinstall cap with dipstick and remove again.
- Read max. and min. markings on dipstick. top off with G 002 000
hydraulic oil, if necessary, as follows:
Pa
ge 42 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 43 of 111

including hoses, and lines. It is not enough simply to top off the hydraulic
oil.
Pa
ge 43 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 55 of 111

55
Brake fluid, changing
WARNING!
Use only new brake fluid conforming to US
Standard FMVSS 116 DOT 4. Genuine VW,
Audi brake fluid conforms to this
specification.
Brake fluid is poisonous. Do not ingest brake
fluid. Wash thoroughly with soap and water if
brake fluid comes into contact with the skin.
CAUTION!
Do not let brake fluid come into contact with
paint because of its caustic effect
Brake fluid absorbs moisture from
surrounding air and should a/ways be stored
in airtight containers.
Do not allow brake fluid to come into contact
with fluids containing mineral oils or
gasoline cleaning products.
Mineral oils damage plugs and seals of the
brake system.
Pa
ge 55 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 56 of 111

56
CAUTION!
Note:
Please observe waste disposal requirements. - Connect Brake Bleeder US 1116 to brake fluid reservoir. Use adapter -
1-, plastic fitting VAG 1238 B/2, seal -3-, and connector -4-.
- Use a suction bottle to draw off as much brake fluid as possible.
Do not use cleaning cloths that have been contaminated by
mineral oils for cleaning brake filling and bleeder fittings. Do not re-use extracted brake fluid.
- Install and adjust brake pedal depressor between driver's seat and
brake pedal.
- Open bleeder fittings and pump in fresh fluid forcing out appropriate
amount of used brake fluid.
Pa
ge 56 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 58 of 111

58
Transport locks, removing
On certain vehicle versions, blocking elements -
1- (in a luminous color) are installed in the front
suspension struts. These models are
recognizable by a tag on the mirror.
- Relieve pressure on coil spring (e.g. vehicle on
lift).
Note:
It is not necessary to remove wheels.
- Pull auxiliary spring -2- down.
- Remove 2 blocking eiements -1- fitted to each suspension strut.
Pa
ge 58 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 81 of 111

80
Service Reminder Indicator (SRI),
resetting
Vehicles up to model year 1997
If service date has been reached, service event
which is due appears as a flashing display after
ignition is turned ON. Flashing continues for a
few seconds after engine is started.
The following displays are possible:
OIL Engine oil change
In 1 Inspection service
In 2 Inspection service with additional work
A service event which is due is already displayed
1000 km (620 mi.) or 10 days before.
Service Reminder Indicator (SRI) must be
matched during Delivery Inspection or during
each Inspection Service to the km and time
specifications until next service event with help of
Scan Tool (ST) VAG 1551.
- Select adaptation channels individually and
enter relevant specified values.
Pa
ge 81 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6