wiring AUDI A4 1998 B5 / 1.G Seatbelts Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1998, Model line: A4, Model: AUDI A4 1998 B5 / 1.GPages: 41, PDF Size: 0.61 MB
Page 6 of 41
69-4
Procedure for triggering pyrotechnic belt
tensioners
Notes:
Whenever possible, pyrotechnic belt tensioners
must be deployed outside the vehicle. Use
Airbag and Pyrotechnic Deployment Device J-
44210 and follow instructions in booklet.
The procedure that follows is for deployment of
tensioners mounted inside a vehicle.
- Remove upper B-pillar trim page 70
-75
.
- Remove lower B-pillar trim page 70
-75
.
- Remove outer seat belt anchor page 69
-
13
.
- Using scissors, cut belt webbing above seat belt
tongue (about 20 cm above belt retractor).
- Disconnect harness connector from belt
retractor and connect wiring harness (Part No.
8D1 971 259) to belt tensioner.
-
Cut harness connector at opposite end, insulate
Pa
ge 6 of 41 Seat belts
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.69.1
Page 7 of 41
both ends of cable, pull cable housing apart until
ends of cable are at least 30 cm apart.
Vehicle must not be occupied
- Open windows and close doors.
- Using wiring harness and an external battery
(located outside vehicle), activate gas generator
(maintain minimum 10 m distance).
Pa
ge 7 of 41 Seat belts
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.69.1