sensor AUDI A4 1998 B5 / 1.G Suspension Wheel Bearing Housing Remove And Install Workshop Manual

42-106


Wheel bearing housing,
removing and installing

Removing

Vehicle must be standing on its wheels
above vehicle lift

WARNING!
The vehicle must be standing on its wheels when loosening or
tightening the collar bolt for the drive axle. Otherwise the risk of an
accident exists. - Remove wheel trim.
On light alloy wheels use puller in vehicle tool kit to remove trim cap
- Loosen collar bolt page 42
-94
, item - 7 -.
- Loosen wheel bolts.
- Raise vehicle on lift.
- Remove wheel.
- Pull ABS wheel speed sensor from wheel bearing housing.
- Remove collar bolt page 42
-94
, item - 7 -.
Pa
ge 1 of 13 Wheel bearin
g housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.8

42-110


Wheel bearing housing, servicing

1 -
Wheel bearing housing
Do not grease bearing seat in wheel
bearing housing before pressing in wheel
bearing After replacing, check and if necessary
adjust wheel alignment
2 -
Clamping sleeve Always replaceLeft and right-sides identicalGrease all around with brake cylinder paste
before inserting into wheel bearing housingPress into wheel bearing housing until fully
seated
3 -
ABS wheel speed sensor To remove, pull outDo not install until drive axle has been
installed To install, press in by hand until fully
seated
Pa
ge 6 of 13 Wheel bearin
g housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.42.8