manual transmission AUDI A4 1999 B5 / 1.G 01V Transmission Electrical And Electronic Components Workshop Manual

01-15


Repair Manual, 5 Spd. Automatic Transmission
01V, Repair Group 37
10 -
Shift lock solenoid -N110-
Location page 01
-30
, Fig. 12
Removing and installingCan be checked electrically page 01
-
273
and via reading measured value block
page 01
-186

Pa
ge 5 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-16


Repair Manual, Fuel Injection & Ignition, Repair
Group 01 11 -
Throttle Position (TP) sensor -G69-
Location page 01
-30
, Fig. 13
The TP sensor signal will be checked via
On Board Diagnostic (OBD) The TP sensor signal is transmitted to the
transmission control module via the engine
control module. The signal can only be
checked in measured value block Page 01
-186
. If OBD indicates a malfunction in
the TP sensor, perform OBD for the Engine
Control Module.
Pa
ge 6 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-21


Removing
Repair Manual, Body
-Interior, Repair Group 70
Fig. 2 Automatic Transmission Control Module (TCM) -J217-,
removing and installing
- Remove lower right A-pillar trim and right front door sill trim.
- Detach carpeting from right inside door sill, and raise carpeting approx.
20 cm.
- Unclip box at -A- by pulling it upward.
- Unclip box at -B- as shown.

- Unclip TCM from box (arrows).
- Release catch on multi-pin connector and disconnect connector from
TCM Fig. 3

Pa
ge 11 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-25


Location: The valve body is bolted to the underside of the transmission
housing inside the oil pan.
The Solenoid Valves -N88-, -N89-, -N90-, -N91-, -N92-, -N93- and -N94-
are attached to the valve body. The solenoid valves -N91-, -N92-, -N93-
and -N94- are also referred to as pressure control valves 1 (-N215-), 2 (-
N216-), 3 (-N217-) and 4 (-N218-).
Removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38

There are two types of transmissions:
Information about which transmission is installed:
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00 Fig. 6 Valve body
For transmissions with hydraulic regulation -E17-, the transmission
input speed sensor (inductive sensor) is secured to the underside of
the valve body. For transmissions with hydraulic regulation -E18/2-, the transmission
input speed sensor (camshaft position sensor) is secured behind valve
body at transmission housing.
Pa
ge 15 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-26


Location: The wiring harness is secured to the valve body.
The wiring harness can be removed with the valve body removed and the
transmission installed.
Wiring harness in transmission, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38

ATF Temperature Sensor -G93-, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38 Fig. 7 Wiring harness with integrated Transmission Fluid
Temperature Sensor -G93-
Pa
ge 16 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-27


Location: The multi-function switch -1- is located on left at transmission;
Multi-pin connector for multi-function switch -arrow-.
Multi-function TR switch, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38
Fig. 8 Multi-function Transmission Range (TR) switch -F125-

Installation location: The tiptronic switch is integrated into the conductor
strip of the symbol insert in the cover of the shift mechanism.
Note:
This switch is not installed on shift mechanisms without tiptronic function.
The switch consists of 3 hall-effect sensors (-A-, -B-, -C- ), which are
activated via a magnet on the lateral gate cover of the gate cover. Fig. 9 Tiptronic switch -F189-
A - Sensor for down-shift
B - Sensor for Tiptronic-recognition
C - Sensor for up-shift
Pa
ge 17 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-28

- If malfunctions occur, the switch for tiptronic
must be checked for interference in Read
measuring value block page 01
-186
and
during the electrical test page 01
-273
.

In case of problems, first check the magnet at the lateral gate cover -C- of
the gate cover is properly attached, replace gate cover, if necessary. Only
replace the symbol insert with integrated conductor strip after checking
the wires. For vehicles with tiptronic-sport steering wheel, also check the
buttons at steering wheel and their wire connections.
Tiptronic switch -F189-, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 37; repairing shift mechanism


Location: The transmission vehicle speed sensor is located at right rear in
the transmission. It is also referred to as the Sensor for Transmission
Output RPM -G195-.
Transmission VSS sensor -G38-, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38
Fig. 10 Transmission Vehicle Speed (VSS) Sensor -G38-
Pa
ge 18 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-29


Installation location:
On transmissions with hydraulic regulation -E17-, the Sensor for
Transmission RPM is secured to the underside of the valve body (see
illustration). For these transmissions the sensor is an inductive sensor. Fig. 11 Sensor for Transmission RPM -G182-

On transmissions with hydraulic regulation -E182-, the transmission input
speed sensor -A- is secured behind the valve body at the transmission
housing. On these transmissions the sensor is a hall effect sensor.
Information about which transmission is installed
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00

Sensor for Transmission RPM -G182-, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38
Pa
ge 19 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-30


The Shift Lever Lock Solenoid is located in the shift lever housing -arrow-
.
Shift Lever Lock Solenoid, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 37
Fig. 12 Shift Lever Lock Solenoid -N110-

Location: integrated in Throttle Valve Control Module -J338- -arrow-.
The location is described in the applicable engine repair manual under
repair Group 01, 23 or 24. Fig. 13 Throttle Position (TP) Sensor -G69-
Pa
ge 20 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-31


IThe relay is located on the central electric.
For relay assignment
Electrical Wiring Diagrams, Troubleshooting & Component Locations Fig. 14 Starting interlock relay -J207

Located in instrument cluster
Removing and installing transmission range selector lever display
Repair Manual, Electrical Equipment, Repair Group 90
Fig. 15 Transmission range selector lever display -Y6-
Pa
ge 21 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2